PWS.pdf

USATA-NG-0005-17

PERFORMANCE WORK STATEMENT

FOR REPAIR AND CALIBRATION OF ANRITSU SIGNAL GENERATOR

1.0 GENERAL. The U.S. Army Test, Measurement and Diagnostic Equipment Activity (USAT A) has a requirement to acquire commercial repair and ISO 17025 accredited calibratio,n of a Signal Generator, Model MG3694C, Serial Number 114811, manufactured by the Anritsu Corporation of Morgan Hill, CA.

2.0 GOVERNMENT TASKS.

2.1 The government shall be responsible for shipment of the unit from the Red River Depot in Texarkana, TX to the Contractor's facility at the government's expense. The unit shall be shipped to the Contractor's facility not later than 48 hours (less weekends and holi~ays) after receipt of notice of contract award.

2.2 The U.S. Army TMDE Activity, Redstone Arsenal, AL (Acceptance DODAAC:

W80RA6) shall be responsible for receiving, inspection and acceptance in DFAS Wide Area Workflow (WAWF) for the unit.

3.0 CONTRACTOR TASKS.

3.1 The Contractor shall furnish all labor, material and equipment required to provide repair and calibration of each item in accordance with the manufacturer's specifications.

3.2 A preliminary evaluation of the Anritsu Model MG3694C, S/N 114811, reports that the unit is referencing a loop error. The Contractor shall repair the unit, restoring to original factory operating condition, and provide calibration in accordance with or compliant to ISO/IEC 17025. As a minimum, a calibration report with the following will be included: as found data, as left data, calibration standards used, and the measurement uncertainty.

3.4 Movement of the equipment through transportation conveyances increases risk of damages to government test, measurement and diagnostic equipment, as well accuracy of applied calibration; therefore, all work shall be performed at the Contractor's on-site repair/calibration facility. Subcontracting to off-site calibration laboratories shall not be authorized in an effort to reduce these risks.

3.5 The Contractor shall not provide repair or other services outside the scope of this contract without authorization from the government Contracting Officer identified in the contract.

4.0 PLACE OF PERFORMANCE. All performance shall take place at the Contractor's facilities.

5.0 PERIOD OF PERFORMANCE. See Section B of contract.

Attachment 01

USATA-NG-0005-17

6.0 GOVERNMENT-FURNISHED EQUIPMENT. None.

7 .0 QUALITY REQUIREMENTS. Not Applicable.

8.0 CONTRACTOR MANPOWER REPORTING REQUIREMENT - SERVICE

CONTRACTS.

(NOTICE: ·MANDATORY REQUIREMENT)

8.1 Department of the Army requires reporting of all contractor labor hours associated with services, to include calibration and repair, provided to United States Army organizations; therefore, 82 The contractor shall report ALL contractor labor hours (including subcontractor labor hours) required for performance of services provided under this contractor for the U.S.

Army TMDE Activity via secure data collection site. The contractor is required to completely fill in all required data fields using the following web address:

http://www.ecmra.mil, and then click on "Department of the Army CMRA" or the icon of

. the DOD organization that is receiving or benefiting from the contracted services.

8.3 Reporting inputs will be for the labor executed during the period of performance during each Government fiscal year (FY), which runs October 1 through September 30.

While inputs may be reported any time during the FY, all data shall be reported no later than October 31 of each calendar year, beginning with 2016. Contractors may direct questions to the help desk by clicking on "Send an email" which is located under the Help Resources ribbon on the right side of the login page of the applicable · Service/Component's CMR website.

Attachment 01