TEST SPECS - QA263.docx

TEST & ACCEPTANCE INSTRUCTIONS: 1. 10G WAVE TESTING CRITERIA: THE

VENDOR MUST CONDUCT A 72 HOUR SATISFACTORY END TO END TEST ON

THE 10GB WAVE SERVICE IAW ITU STANDARD M.2101. ADDITIONALLY, THE

VENDOR TEST SET/SETS MUST HAVE THE ABILITY TO PRINT THE TEST

RESULTS AND THOSE RESULTS MUST BE EMAILED TO THE ACCEPTING

AUTHORITY FOR REVIEW.

2. WAVELENGTH TRANSMISSION SERVICES FOR RATES OF 10GBPS SHALL BE

IN ACCORDANCE WITH ITU-T RECOMMENDATIONS G.709(03/2003),

G.707(12/03), G.957(03/06), G.692(10/98) & TELCORDIAGR253-IE4.

THE PROVIDED WAVELENGTH TRANSMISSION SERVICE SHALL NOT INHIBIT

GOVERNMENT OPERATION OF UNDERLYING PROTOCOLS AND TRANSPORT

SYSTEMS SUCH AS, BUT NOT LIMITED TO, SONET/SDH, IP, ATM, GIGABIT

ETHERNET, AND ENCRYPTION. THE WAVELENGTH TRANSMISSION SERVICE

PROVIDED SHALL PASS ALL PAYLOAD, PATH AND LINE OVERHEAD BYTES

TRANSPARENTLY (UNTOUCHED/UNALTERED) AND WITHOUT MONITORING SDP TO

SDP. THERE SHALL NOT BE ANY LINE TERMINATING EQUIPMENT (LTE)

BETWEEN SDP AND SDP.

3. ONCE TELECOM PROVIDER HAS COMPLETED INSIDE WIRING FROM THEIR

FIBER DISTRIBUTION PANEL INSTALLED IN THEIR DWDM EQUIPMENT SUITE

TO THE GOVERNMENT SERVICE DELIVERY POINT (SDP) AT EACH LOCATION,

THEY MUST ENSURE THE LIGHT LEVEL READINGS (DB LOSS) ARE ADJUSTED

TO READ +0.5 TO -7.0 DBM LOSS. ADDITIONALLY, THESE LEVELS MUST BE

DOCUMENTED ON THE NOTICE OF COMPLETION (NOC) SENT TO DITCO.

4. FIBER OPTIC 10GB WAVE CIRCUITS SHALL PASS A FULLY DOCUMENTED

SATISFACTORY SOAK TEST BY THE GOC AT SCOTT AFB, IL. PRIMARY: (C)

618-418-8691, (D) 418-8691.

5. THE COMMERCIAL CIRCUIT WILL BE ACCEPTED ON BEHALF OF THE

GOVERNMENT BY THE DISA GOC IP BACKBONE ENGINEERING AND

IMPLEMENTATION GROUP, SCOTT AFB, IL. (C) 618-418-8627, (D)

418-8627

P. CIRCUIT SPECIFICATIONS: FORMAT TO BE USED IS:

LINE RATE: 10GB.

LINE CODE: NRZ.

FRAME FORMAT: SCRAMBLED IAW ANSI T1.104-1991 (R2003).

1. FIBER TERMINATION: SINGLE-MODE INTERFACE REQUIREMENT/INTERFACE

DATA RATE: LINE CODING, FRAME FORMAT, PHYSICAL CONNECTOR, 10

GBPS, NRZ, SCRAMBLED PER ANSI T1.104-1991 (R2003). ALL OPTIONS

DEFINED SC CONNECTOR, SINGLE-MODE FIBER PER ANSI T1.105.06-2002

(SR-0/SR-1/IR-1/IR-2/LR-1/LR-2/LR-3).

2. GFE CLOCKING: VENDOR ESFU (OR EQUIVALENT) NOT TO BE ENGINEERED

INTO CIRCUIT.

3. WAVELENGTH TRANSMISSION SERVICE PROVIDED SHALL MEET THE

FOLLOWING PERFORMANCE REQUIREMENTS ON A MONTHLY BASIS.

NON-DIVERSE/NON-PROTECTED AVAILABILITY: GREATER THAN OR EQUAL TO

99.5% OR BETTER.

MONTHLY SHORT INTERRUPTION EVENT COUNT(SEIC):

LESS THAN OR EQUAL TO 9%. ERRORED SECONDS(ES): LESS THAN OR

EQUAL TO 0.005%.

SEVERELY ERRORED SECONDS(SES): LESS THAN OR EQUAL TO 0.00035.

BACKGROUND BLOCK ERROR RATIO(BBER): LESS THAN OR EQUAL TO 5 X

10-6.

Q. REMARKS CONTINUED: BIT COUNT INTEGRITY (BCI)/PATTERN SLIP(PAT

SLIP): LESS THAN OR EQUAL TO 1 PER 72 HOURS.

JITTER LESS THAN OR EQUAL TO 1X10-12. DELAY (ONE WAY): * LESSER

OF 10 MSEC OR (0.01 X D MSEC) * WHERE "D" IS THE SDP TO SDP

TRANSMISSION DISTANCE, MEASURED SHORTEST GREAT CIRCLE, IN

KILOMETERS. (NOTE) IN A STEADY-STATE CONDITION, THE PATTERN OF

SYNCHRONOUS TRANSPORT SIGNAL (STS) POINTER ADJUSTMENTS, SDN TO

SDN (END-TO-END THROUGH THE SERVICE PROVIDED NETWORKOUTPUTS),

SHALL BE NO MORE STRESSFUL (I.E., CREATE MOREJITTER THROUGH THE

DESYNCHRONIZER AS DESCRIBED IN TABLE 6 OF ANSI T1.105.03-1994)

THAN THE POINTER ADJUSTMENT SEQUENCE IN FIGURE 5 OF ANSI

T1.105.03-1994. DURING TRANSIENT EVENTS (WHICH SHALL OCCUR NO

MORE THAN 2 TIMES PER DAY), THE PATTERN OF STS POINTER

ADJUSTMENTS, SDN TO SDN (END-TO-END THROUGH THE SERVICE PROVIDED

NETWORK OUTPUTS), SHALL BE FOUR OR LESS PER HOUR. ADDITIONALLY,

THE MAXIMUM TIME INTERVAL ERROR (MTIE) OVER A PERIOD OF S

SECONDS, OR WANDER, SHALL NOT EXCEED (.01S + 10000) NANOSECONDS

FOR VALUES OF S GREATER THAN 10,000.

R. CIRCUIT SPECIFICATIONS CONTINUED: RTD: ROUND TRIP DELAY (RTD) FOR

THIS DISA TRANSPORT TRUNK WILL BE MEASURED IN MILLISECONDS FROM

THE CUSTOMER'S SERVICE DELIVERY POINT (SDP) SITE-A TO THE

CUSTOMER'S SERVICE DELIVERY POINT (SDP) SITE-Z. THE RTD SHALL BE

LESS THAN OR EQUAL TO 10 MILLISECONDS TO EFFECTIVELY SUPPORT THE

GOVERNMENT'S MISSION. THE GOVERNMENT ACCEPTING AUTHORITY WILL

CONFIRM THE RTD DURING THE TURN-UP AND TEST PHASE AND IF IT DOES

NOT ALIGN WITH THE CONTRACTORS PROPOSAL, DISA IE161 WILL NOTIFY

DITCO IMMEDIATELY IN WRITING.

4. VENDOR MUST COORDINATE SITE VISIT WITH POC'S 72 HOURS IN

ADVANCE PRIOR TO REQUIRING ACCESS TO FACILITIES AT BOTH USER

LOCATIONS.

5. THE VENDOR MUST CONDUCT WALK-THROUGH SITE SURVEY PRIOR TO

INSTALLATION AT BOTH LOCATIONS.

6. LINE MUST REMAIN FULLY OPERATIONAL AND AVAILABLE TO USERS 24

HOURS A DAY, SEVEN DAYS PER WEEK, MONTHLY PERFORMANCE OF 99.5%

AVAILABILITY OR BETTER.

7. VENDOR MUST HAVE A 24X7 NETWORK OPERATIONS CENTER

8. TELECOM PROVIDER MUST MAINTAIN OPERATIONS, MAINTENANCE AND

ADMINISTRATION MONITORING OF ETHERNET CIRCUIT. THE VENDOR IS

REQUIRED TO HAVE CIRCUIT VISIBILITY TO ASSIST IN ANY CIRCUIT

OUTAGES AND A 1 HOUR RESPONSE TIME TO RESPOND TO CUSTOMER UPON

RECEIPT OF TROUBLE.

9. THE VENDOR MUST CONTACT DISA GOC IP BACKBONE ENGINEERING AND

IMPLEMENTATION GROUP UPON RECEIPT OF A VALID TSO TO ESTABLISH THE

COORDINATION AND ACTIVATION PROCESS. PHONE: (C) 618-418-8627,

(D) 418-8627.

10. ALL EQUIPMENT AND CIRCUIT PROBLEMS WILL BE REPORTED BY PHONE

TO THE DISA GOC IP BACKBONE ENGINEERING AND IMPLEMENTATION GROUP,

SCOTT AFB, IL. PRIMARY: (C) 618-418-9950, (D) 418-9950 TOLL

FREE: 855-868-9950.