Techincal Exhibit 1 Specifications for Comparison and Evaluation sheds.pdf

Submission for Meet or Exceeds

(Required for Submission: See TE #2 for Buy Terms)

Technical Exhibit #1: Specifications for Evaluation and Submission Sheet

Vendor must fill out Company’s name, POC, UEI, Date

Company Name:

POC:

Signature of Vendor:

Date:

UEI:

Failure to submit a complete submission sheet with vendor’s signature will be result in a not acceptable rating. The Governme Quantit y Unit of

Measure

IN EACH

Specifications salient characteristics. All specifications must be equal to the following specifications and/or salient characteristics presented

Offeror must reply to all areas in order to be evaluated by the government.

Any specification not addressed will be considered not acceptable.

Any areas deemed not acceptable will result in a overall rating of not acceptable and will not be eligible for award.

Technical

Customer

Evaluation

(Acceptabl e or Not

Acceptable na na Offeror must acknowledge all bullet points as an understanding of scope

• Furnish and deliver all listed supplies in the quantities and specifications described.

• Ensure all products meet or exceed ASTM and

American

Concrete

Institute

(ACI)

standards for structural and finishing materials.

• Provide

Material

Safety Data

Sheets

(MSDS) for all sealants, adhesives, and other chemical products.

• Coordinate all delivery scheduling with the

FLETC

Training

Support

Division to prevent disruption to ongoing training operations.

• All materials shall be delivered and staged to Track 2, FLETC Glynco

Campus, located at:

1131 Chapel

Crossing

Road, Glynco, GA

31524

• Delivery employee must be able to be vetted to gain access to

FLETC.

25 each

#5 rebar, 20′ lengths

42 LBS

Synthetic fiber additive

(polypropylene, 1.5 lb per cubic yard)

1800 SQ FT

Vapor barrier, 6-mil polyethylene

15 each 2×6×16 spruce (Must be straight). The government has the right to reject and require replacement within 4 hours if not acceptable at time of delivery.

50 each 2×4×16 spruce (Must be straight). The government has the right to reject and

100 each Tapcon concrete anchors, 3/8″ × 6″

150 each Tapcon concrete anchors, 1/4″ × 3″

375 each 2×4×104 5/8″ SPF precut studs

(Must be straight). Government has the right to reject and require replacement within 4 hours if not acceptable at time of delivery.

120 each 2×6×16 SPF studs (Must be straight).

Government has the right to reject and

35 each Pressure-treated 2×4 sill plates

160 Linear ft 3-1/2″ rigid insulation foam strips for under sill plates

1 each 4×4 post (treated) (Must be straight).

Government has the right to reject and

30 pounds Paslode 3″ framing nails (collated)

200 each Simpson Strong-Tie 6″ structural truss screws

17 trusses ROOF- Prefabricated wooden trusses, 5/12 pitch

55 sheets Roof sheathing, 5/8″ ZIP System panels, 4×8

8 rolls ROOF-ZIP System seam tape rolls.

54 bundles ROOF- Dimensional shingles, 30-year architectural (gray)

220 Linear ft ROOF- Drip edge (aluminum)

40 pounds ROOF- 2″ galvanized nails (collated)

55 SHEETS ZIP System wall sheathing, 4×10

1650 SQ FT R-panel metal siding, gray finish

200 Linear ft Black metal trim coil

3000 Sq ft Vinyl soffit panels (vented)

80 Linear ft J-channel for siding/windows

4 each Exterior siding corners, black finish

800 each Metal siding screws, #12 × 1-1/2″, gray, self-drilling with neoprene washers

300 each Painted-head trim and soffit screws, #8 × 1″, color-matched

24 TUBES Exterior-grade polyurethane sealant (tubes)

6 EACH Insulated exterior steel doors with locksets

2 EACH Black vinyl windows, 3′×5′

8 SETS Window/door trim kits

12 TUBES Silicone window/door caulk

170 sheets Interior 1/2″ drywall, 4×8

12 each Drywall joint compound -5 gallon

20 pounds Drywall screws

24 tubes construction adhesive (drywall grade, tubes)

25 each interior paint (eggshell, white) gallon

12 each Drywall tape

600 Linear ft base molding, 3-1/4″

280 Linear ft Window/door casing, 2-1/4″

10 pounds 2″ finish nails (collated, 15-gauge)

10 pounds 2-1/2″ finish nails (collated, 15-gauge)

24 tubes interior acrylic latex caulk (paintable)

12 tubes fire-rated sealant (intumescent caulk, red)

6 cans fire-block foam (expanding, orange)

The project include six (6) bathrooms. The following items below must be a package with coordinating colors to each other and eggshell colored walls and present a uniform appearance.

6 each BATHROOMS: ADA-compliant toilets Must fit into 5’X8” bathroom with vanity/sink combos

6 each BATHROOMS: toilet installation kits

6 units BATHROOMS: Vanity/sink combos with faucets

6 units BATHROOMS: Under-sink electric water heaters (2.5–4 gal)

6 units BATHROOMS: Bathroom exhaust fans with duct kits

6 units BATHROOMS: Bathroom mirrors

12 units BATHROOMS: ADA stainless steel grab bars

1 unit BATHROOMS: Bottle filling station with chilled water feature

600 LINEAR

FT

BATHROOMS: PEX supply line, 1/2″

200 Linear ft BATHROOMS: PEX supply line, 3/4″

120 Sets/pieces PEX fittings (elbows, tees, couplings)

300 LINEAR

PVC drain line, 3″

200 LINEAR

PVC drain line, 4”

6 SETS BATHROOMS: Sink traps and supply kits

6 SETS BATHROOMS: Toilet flanges and seals

6 SETS BATHROOMS: Sink traps and supply kits

1 UNIT Septic tank, 1,000-gal polypropylene (poly-pro)

4 RUNS Easy-Flow pipe, 50′ runs

40 TONS Septic sand for drain field

1 UNIT 200-amp breaker panel

20 UNITS 20A breakers

2500 LINEAR

FT

NM-B 12-2 cable (Romex)

500 LINEAR

FT

NM-B 10-2 cable (Romex)

80 UNITS 20A device boxes (new work)

80 UNITS 20A duplex receptacles, tamper-resistant

20 UNITS Switch boxes

20 UNITS Single-pole switches, 20A

100 UNITS Cover plates

20 FIXTURES Interior LED ceiling lights

4 FIXTURES Exterior LED wall-pack lights

500 LINEAR

FT

Conduit, fittings, clamps

6 UNITS Single-gang low-voltage boxes for

CAT6

500 Linear ft CAT6 Ethernet cable (plenum rated

1284 Sq ft Open-cell spray foam insulation – exterior 2×4 walls

1625 Sq ft Open-cell spray foam insulation – roof deck underside

12 Cubic

Yards For continuous footers (24”X12”) 3000 psi pump mix concrete with fiber no air, must arrive onsite at 4-inch slump. Concrete must be accepted by the government. All unacceptable concrete must be redelivered at no cost to the government. The government reserves the right to ask for rework with no extra charge to the government for concrete mix. The government will provide a 2-day notice for the delivery of the concrete mix onsite to the build area. The government will pour the concrete.

Contractor/driver must be able to be vetted through security. Delays at the gate is at no fault of the Government.

28 CUBIC

YARDS

For continuous footers (30X50) 3000 psi pump mix concrete with fiber no air, must arrive onsite at 4-inch slump. Concrete must be accepted by the government. All unacceptable concrete must be redelivered at no cost to the government. The government reserves the right to ask for rework with no extra charge to the government for concrete mix. The government will provide a 2-day notice for the delivery of the concrete mix onsite to the build area. The government will pour the concrete.

Contractor/driver must be able to be gate is at no fault of the Government.

1 job Finish concrete slab approximately 600 square feet to a smooth, slick finish using power trowel machine equipment.

The government will provide labor and equipment to place and level the concrete during the pour.

Contractor shall supply experienced finishers only for the final finishing application.

Finishers must be equipped with all tools, safety gear, and machine trowels necessary to deliver a high-quality, uniform surface suitable for all-weather exterior use.

This is considered incidental services completed by the Contractor.

Contractor must provide certified concrete finisher to ensure poured concrete is to required codes.

Government will provide oversight.

1 ea 20’ x 30’ red iron lean-to structure kit, complete with all framing hardware, pre-drilled components, and installation brackets

52 YARDS Fifty-two (52) yards of 3000 PSI pump mix concrete, small pea gravel mix. with fiber no air, must arrive onsite at 4-inch slump. Concrete must be accepted by the government. All unacceptable concrete must be redelivered at no cost to the government. The government reserves the right to ask for rework with no extra charge to the government for concrete mix. The government will provide a 2-day notice for the delivery of the concrete mix onsite to the build area. The government will pour the concrete.

Contractor/driver must be able to be gate is at no fault of the Government

15 Ea 2"x2"x16' spruce lumber boards (Must be straight). The government has the right to reject and require replacement within 4 hours if not

20 ea 2"x4"x16' spruce lumber boards the right to reject and require

12 ea 2"x6"x16' spruce lumber boards the right to reject and require

1 EA 25 lb bucket of 3" T25 Star Drive construction screws

16 EA 5/8" diameter x 20' length steel rebar rods

30 EA 3/4" diameter x 12" long threaded rods, Grade 8 steel

60 EA 3/4" nuts, compatible with the Grade 8 threaded rods

120 EA 3/4" washers, compatible with the Grade 8 threaded rods

10 EA 10-foot lengths of 1" EPVC conduit

100 EA 1/2" EPVC Schedule 40 conduit lengths

4 EA 1/2" EPVC male adapters

4 EA 1/2" steel locknuts

4 EA 1/2" plastic bushings

8 EA 1/2" EPVC couplings

3 EA 1/2" EPVC 90-degree elbows

1 EA 1/2" EPVC LB conduit body

1 EA SOD miniature circuit breaker

1 EA 2-gang 5-hole aluminum weatherproof box

1 EA extra-duty dual-gang weatherproof cover (vertical/horizontal configuration)

2 EA 1-gang 3-hole aluminum weatherproof boxes

2 EA extra-duty single-gang weatherproof covers (vertical/horizontal configuration)

100 EA 1/2" non-metallic conduit lengths

50 EA 1/2" EPVC two-hole straps

200 FT 1/4" x 2-1/4" Tap-Con masonry screws

500 FT 12 AWG green THHN stranded wire

500 FT 12 AWG black THHN stranded wire

500 FT 12 AWG white THHN stranded wire

12 EA 1/2" non-metallic straight sealtite connectors

12 EA 1/2" non-metallic 90-degree sealtite connectors

3 EA 4-foot selectable LED vapor-tight fixtures

2 EA wall-mounted AirEye directional fans, 30-inch blade diameter o Yellow blade color finish o 120V operation o OSHA-compliant fan screen o Integrated LED display with

AirEye power and motion detection activation o Noise reduction technology with three precision-balanced airfoils o Rated for wet locations and suitable for outdoor use