SRC23744. barbour gate specs.pdf
PDF 124 KB Posted
- Attached to
- Conservation/WL/D4-Steel Gates-Barbour WMA
- Solicitation number
- SRC0000023744
- Issued by
- Bullock County, Alabama
About this file
This document is a specification for a state and local contract opportunity for the procurement of welded steel gates for the Barbour Wildlife Management Area (WMA) in Midway, Alabama. The contract is being issued by the state of Alabama, specifically for Bullock County. The specification calls for the delivery of 5 welded steel gates, each 16 feet long and made from 2-inch square tubing. The gates must have a locking mechanism with an off-centered hole to accommodate a lock shackle, as well as a 3-inch round swivel pole and supporting diagonal and vertical bars. The gates are to be painted yellow and delivered to the Barbour WMA location.
The pricing and other terms of the contract are not explicitly stated in the document. However, the contract opportunity indicates that this is an "All or None" bid, meaning that bidders must submit pricing for the entire quantity of 5 gates. There are no set-asides or other special requirements mentioned, and the incumbent contractor, if any, is not identified. The funding source and amount for this project are also not provided.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| Quick Quote Standard Boilerplate updated 08.31.2023.pdf | ||
| SRC23744. gate diagram.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Barbour WMA Welded Gate Description:
QTY:5
16' long welded gate made from 2 ½" square tubing that is ¼" thick.
The locking side of the gate needs to have a 10"x2 ½"x¼" plate welded onto the end of the 16' square tube with a½" hold cut into it.
The hole needs to be off centered to allow for a lock shackle to be inserted.
The swivel side of the gate needs to have a 3' long round pile welded to it that is just large enough to slide over the 3" pipe that is the swivel pole.
There needs to be a 12' long support bar made from 2 ½" square tube welded diagonally from the 16' square pipe to the base of the 3" swivel side.
There also need to be a vertical support made from 2 ½" square tube welded to the 12' support and the 16' square tube.
The locking pole should be made from 4" square tube that is 6' long and ¼" thick with a plate welded to the top.
The pole needs to have a 6"x7"x ¼" square tube welded onto one for the sides flush with the top of the pole.
There needs to be a S"x¾" gap cut into the box to allow gate to be locked.
The swivel pole of the gate should be made from 3" round pipe that is 7'6" long.
The below ground portion should be 4' long and the above ground section should be 3' long.
There needs to be a cap or welded plate attached to prevent the gate from being lifted off the swivel pole.
The gates should be painted yellow.
Attached is a schematic for the gates.
Delivered to Barbour WMA, 188 Christa Drive, Midway AL 36053.
File details come from the government source that posted it. Updated .