SPRRA117R0090__Redacted.pdf

AVN Form S53 FOR OFFICIAL USE ONLY 2

AMSC K. This part must be produced from class 1 castings under MIL-STD-2175.

AMSC L. The annual buy value of this part falls below the screening threshold established by DoD.

AMSC M. Manufacture of this part requires use of master or coordinated tooling.

AMSC N. Manufacture of this part requires special test and/or inspection facilities to maintain function or system integrity.

AMSC P. The rights to use the data needed to purchase this part from additional source(s) are not owned by the

Government and cannot be purchased, developed, or otherwise obtained.

AMSC Q. The Government does not have adequate data, lacks rights to data, or both. It is not economical to buy the data or rights to the data.

AMSC R. The Government does not own the data or rights to the data needed to purchase this part from another source. It is not economical to procure the data or rights to the data.

AMSC S. Acquisition of this item is restricted to Government approved source(s) because the item involves military sensitive technology.

AMSC U. The cost to the Government to breakout this part and acquire it competitively has been determined to exceed the projected savings over the life span of the part.

AMSC V. This part has been designated a high reliability part. Probability of failure would be unacceptable. The engineering activity has determined that data to define and control reliability limits cannot be obtained.

AMSC Y. The design of this part is unstable. Engineering, manufacturing, or performance characteristics indicate that the required design objectives have not been achieved.

AMSC Z. This part is a commercial/no-developmental/off-the-shelf item.

Other:___________________________________________________________________________________

6. Efforts to ensure that offers are solicited from as many sources as practicable are:

The acquisition will be synopsized on or about _________________ and any firm requesting a solicitation copy will be provided one.

A synopsis exception cited in FAR 5.202 applies: (Explain) ________________________________________________ Manufacturers of similar products identified in the market survey will be solicited.

Dealers of the manufacturers will be solicited.

Other: (Explain) ___________________________________________________________________________________

7. I hereby determine that the anticipated cost to the Government will be fair and reasonable. (Explain) _________________________

8. A market survey as defined by FAR 10:

was conducted, and firms indicating an interest in the acquisition will be solicited. Market research efforts, include:

was not conducted due to: ___________________________________________________________________________

9. Additional facts supporting other than full and open competition are:

Based upon the technical certification on file, technical data is not available and cannot be developed to permit full and open competition. The data presently available reflects the minimum needs of the Government.

When FAR 6.302-1 is cited for follow-on acquisitions as described in 6.302-1(a)(2)(ii), an estimate if the cost to the Government that would be duplicated and how the estimate was derived. ______________________________________

June 2, 2016

SOURCES SOUGHT SYNOPSIS posted May 26, 2016. No responses received

The overall cost of this acquisition will be fair and reasonable to the government. IAW FAR 15.403 -4, the contractor will be required to provide certified cost and pricing data to be used in supporting the Government's evaluation of the proposed cost. The proposed skill mix of labor, labor hours, types and quantities of material, other direct and indirect rates will be negotiated by the Government based on recommendations from DCAA and expert technical personnel supporting the program. the contract price will be negotiated IAW the procedures in FAR 15 ensuring ultimate cost to the government is Fair and reasonable. O

Market research as defined in FAR 10.001 was conducted based on knowledge of individuals within the requirements community. This item was published in the 30 JUNE 2016 CASL. Contracting Officer are required to issue a Request for Information (RFI) or Sources Sought with the J&A when acquiring supplies from only one or a limited number of responsible source.

SPRRA1-17-R-0090

AVN Form S53 FOR OFFICIAL USE ONLY 3

Other: ___________________________________________________________________________________________

10. A listing of sources, if any, indicating an interest in writing in the acquisition are: (if none, state none)

CAGE COMPANY NAME

11. The actions, being taken to overcome barriers to competition before any subsequent acquisition are made: (Explain)

APPROVAL

APPROVAL LEVELS OF THE JUSTIFICATION – FAR 6.304

not exceeding $ 0,000…………………………… ……. Contracting Officer over $ ,000 not exceeding $1 ,500,000………………… Competition Advocate

TECHNICAL/REQUIREMENTS PERSONNEL CERTIFICATION – FAR 6.302-2(c) pporting data that is the responsibility of technical or requirements personnel and which form the basis for this justification have been

DLA COUNSEL AVIATION – DLAD 1.691(e)(ii) DLA Counsel Aviation has reviewed this Form S53 and concluded i creates a legally sufficient justification for restricting competition pursuant to 10 U.S.C.

2304(c)(1) and FAR 6.302-1 in acquisitions for NSNs in the federal supply system.

CONTRACTING OFFICER – FAR 6.303-2(b)(12) I hereby certify that the information contained in this justification is accurate and complete to the best of my knowledge and belief. If not exceeding $ 0,000, this signature serves as the approval.

Name and Title Signature Phone Date

COMPETITION ADVOCATE – FAR 6.304(a)(2) The Competition Advocate for the procuring activity designated pursuant to FAR 6.501 has reviewed and approved this Justification for a proposed contract over $ 0,000 but not exceeding $1 .5 million.

Name and Title Signature Phone Date

It has been determined that the Government's needs cannot be met by an item in the commercial marketplace; therefore, FAR Part 12 will not be used.

This is a spare part procured to an approved part number and is a military unique requirement not available in the commercial market place.

none none

Firms are encouraged to seek source approval in order to compete for future solicitation by accessing the website www amcomdmx.redstone army.mil/casl_cmo/casl_cmo_home and looking under Standardization Aviation and Missile Source Approval request (SAMSAR). Currently, there are no outstanding qualification requests on this item; however, this is a continuous method of identifying potential new sources of supply. Any potential candidates who identify themselves within the appropriate time-frame will be referred to the previously mentioned website. As a result of the sources sought, no response has been received.

Nelminia R. Serrano- Contracting Officer S I A.

Digitally signed by

SERRANO.NELMI

Date 2016.11.08 1 11/08/2016

Carla H. Cole - Price/Cost Analyst ARL Digitally sign

COLE.CARL

Date: 2016. 11/15/2016

SPRRA1-17-R-0090