Specifications Washer_Dryer.pdf

WASHER AND DRYER SPECIFICATIONS:

PART 1 – GENERAL

1.0 EQUIPMENT

a. Commercial Soft Mount Washer

b. Double Stack Dryer

1.01 WASHER CHARACTERISTICS AND FEATURES

Washer shall be a freestanding automatic laundry washer

A. WASHER DESIGN REQUIREMENTS:

1. Construction: 304 or equal stainless steel cylinder, tub, front and top panels

2. Input voltage: 460-480/60/3

3. Dry Weight capacity: 45 LB

4. Wash cylinder volume: 7.3 cu. ft. (min.)

5. Overall width: 37.2 inches nominal

6. Overall height: 65 inches nominal

7. Overall depth: 53.8 inches nominal

8. Number and size of water supply inlet values: 4 valves with 3/4 inch BSP male connections (2 standard, 1 optional) steam connection – 1 with 1/2 inch

9. Number and size of drain outlets: 1 at 3 inch

10. Overflow: Internally plumbed

11. Control System: Programmable microprocessor

12. Cylinder Drive: Single motor, 5 hp, capable of 954 RPM maximum, using a rotation sensor to monitor performance

B. WASHER PERFORMANCE REQUIREMENTS:

1. Number of selectable cylinder speeds: 9

2. G-force at highest extract speed: 400 G

3. OPTI spray rinsing power

4. Delayed Start

1.02 DRYER CHARACTERISTICS AND FEATURES

The dryer shall be a Unimacs 45lb stack tumbler with the Unilinc micro controls, opti-dry over dry prevention, dual 45 lb baskets, gas heat, single 10” vent, white, 460-480/60/3 electrical

A. DRYER DESIGN REQUIREMENTS:

1. Capacity: dual 45 lb baskets

2. Dimensions:

a. Width: 35.5”

b. Depth: 54”

c. Height: 84.9”

3. Cylinder Diameter: 33”

4. Cylinder Depth: 30”

5. Cylinder Volume – 14.8 cu ft

6. Door Opening Size: 26.9”

7. Energy: 95,000x2 btu/hr

8. Gas Connections: 0.5”propane

9. Air Outlet: 1 x 10” Oval

10. Motor: 0.5 x 2 HP

11. Air Flow: 2 x 600 cfm

12. Weight: 690 lbs

B. DRYER PERFORMANCE REQUIREMENTS

1. Over dry prevention

2. 30 auto dry setting

3. Dual Digital timers

4. Customizable controls

PART 2 – DELIVERY, STORAGE, & INSTALL

2.01 DELIVERY

Washer and Dryer shall be delivered to:

Northern Cheyenne Health Clinic 420 North Cheyenne Ave Lame Deer, MT 59043

A. ACCEPTANCE AT SITE:

1. Inspect machines for damage prior to acceptance. If damage is found, follow freight handler’s procedure for claims.

2.02 STORAGE AND PROTECTION

1. Equipment shall be stored in a site protected from weather, direct sunlight and temperature extremes.

Do not remove packaging prior to storage

2. If equipment is to be stored for an extended period of time, consult manufacturer for special requirements.

2.03 INSTALLATION

A. Refer to and comply with manufacturer’s installation instructions. Do not deviate without permission from Contracting Officer.

1. Washing unit shall be “set” in appropriate location where unit will be operated. Setting includes drilling cement floor and installing anchor bolts, placing washer over bolts, leveling, grouting, and bolting down unit.

2. Dyer shall be “set” and leveled but will not require fastening to the floor.