Specifications for Vertical baler8321.pdf

Specifications for Model CM‐3050V715 Vertical Baler or Equivalent

Multi‐Material Vertical single ram manual tie, down‐stroke single box baling press for bales 50” wide x 30” deep x 40”‐ 48” high with:

Heavy duty structural steel baler frame 15’‐6” high

Floor mounted hydraulic power unit rated for 3000 PSI

30 HP TEFC 230/460 Volt, 3PH, 60Hz motor

Pressure transducer, hydraulic pump, directional valve, pressure relief valve, and hydraulic reservoir

7” bore x 68” stroke with 4” rod industrial grade compression cylinder pin attached to compression platen with replaceable UHMW ram wear guides to cycle in approximately 60 seconds

PLC controlled operation & independent operator’s touchscreen control panel

Safety gate interlocked for front loading over bale door Semi‐automatic and manual operation

Manual turnbuckle door latch/unlatch bale door & lock

4” Bore Ejection Push Cylinder Automatic compression cycles

Special designed ram slots and baler floor slots for four or six steel wire ties or polyester strap bale ties

Audible “completed bale” horn and strobe light

Over 100,000 lbs. of compression force at 2,700 PSI with 71.5 lbs. of force per‐square inch of ram surface

FOB Stoneville/Leland, Ms.