SOW.doc

STATEMENT OF WORK

Station Grand Haven Parking Lot Resurface

START:

04 May 2020

COMPLETE:

08 May 2020

1. LOCATION:

Coast Guard Station Grand Haven 601 S. Harbor Drive

Grand Haven, MI 49417

2. SCOPE OF WORK:

a. Place appropriate barricades in place on work site.

b. Power clean lot with blower.

c. Crack repair up to 3,500 linear feet of the worst excluding the stable fractured areas. Clean Cracks, 3/8” or lager, using our Thermo Blaster System (2000 F @ 110 PSI). Seal Cracks using bander method and injection process. (may not include all cracks)

d. Seal coat entire parking lot area approximately 26,000 square feet.

e. Apply two heavy coats of custom blended coal tar emulsion asphalt sealer. That exceeds federal spec RP-355E.

f. Re-stripe all parking spaces, arrows and handicap symbols, using airless striping equipment to insure clean, crisp, straight lines.

3. SPECIFICATIONS:

All services shall meet DHS / USCG Architecture policies, standards, and procedures. Specifically, the contractor shall comply with the following Homeland Security Enterprise Architecture (HLS EA) and Coast Guard Enterprise Architecture (CGEA) requirements:

4. SECURITY REQUIREMENTS:

Each individual employed under the contract shall be a citizen of the United States of America, or an alien who has been lawfully admitted for permanent residence as evidenced by a Permanent Resident Card (USCIS I-551). Any exceptions must be approved by the Department’s Chief Security Officer or designee.

Contractors shall identify in their proposals, the names and citizenship of all non-U.S. citizens proposed to work under the contract. Any additions or deletions of non-U.S. citizens after contract award shall also be reported to the contracting officer.

All personnel requiring access to classified spaces on Coast Guard units shall require a current security clearance with a minimum level of secret. Contractor’s request for authorization will be submitted in accordance with DOD 5220.22M (Industrial Security Manual for Safeguarding Classified Information) no later than (1) week before each unit visit. Request will be sent to the TA who will forward to the Security Officer for approval.

All Contractor employees shall identify themselves as Contractors when their status is not readily apparent and display a valid government identification.

5. GOVERNMENT FURNISHED EQUIPMENT:

5.1 The Government will make available to the Contractor, upon request, restroom facilities and standard power outlets

6. GOVERNMENT FURNISHED MATERIAL: N/A

7. GOVERNMENT FURNISHED EQUIPMENT: N/A

8. CONTRACTOR FURNISHED EQUIPMENT:

8.1 Contractor will supply all equipment.

9. CONTRACTOR FURNISHED MATERIAL

9.1 Contractor will furnish all materials necessary.

10. ACCEPTANCE PLAN

Compliance

The Contractor shall ensure that delivered tasks and products meet all standards and guidelines provided in this Contract and in applicable regulations and directives.

Acceptance

Preliminary reports, outlines and draft documents submitted to the Coast Guard will be reviewed by the Coast Guard for completeness, and may be returned to the Contractor for correction. Absence of any comments by the Coast Guard shall not relieve the Contractor of the responsibility for complying with the requirements of this work statement.

11. OTHER CONDITIONS/REQUIREMENTS:

11.1 Place and Hours of Performance:

Work is to be performed off-site and on-site as defined below:

On-site:

601 S. Harbor Drive

Grand Haven, MI 49417 Contractor employees shall generally perform all work between the hours of 0800 and 1700 EST, Monday through Friday (except Federal holidays). However, there may be occasions when Contractor employees shall be required to work other than normal business hours, including weekends and holidays, to fulfill requirements under this task order. When the Contractor is required to work other than normal business hours and needs access to government facilities to complete work, an advance written request shall be submitted to the COTR for approval.