SOW - Clean Water Well SA-1.pdf
PDF 96 KB Posted
- Attached to
- Clean Water Well SA-1
- Solicitation number
- FA480126Q0013
About this file
This is a Statement of Work (SOW) for cleaning Water Well SA-1, located approximately five miles south of Alamogordo, dated February 24, 2026.
The contractor shall clean the interior of a 710-foot deep well with a 16-inch diameter casing where the static water level is at 225 feet depth. The work consists of two primary phases: (1) injection of a liquid descaling cleaning solution followed by 20 hours of brush cleaning of the casing interior, with a mandatory work stoppage and video documentation after 15 hours for CE Utility Shop review to determine if additional brushing (up to 5 additional hours) is required; and (2) removal of debris from the well bottom through 10 hours of bailing and sand pumping. The contractor must submit product information for the cleaning solution prior to commencing work and obtain approval from the CE Inspector before beginning operations. A final video must be taken upon completion of all brushing and bailing work. If damage to the casing is discovered during brushing, work must cease immediately and the CE Utility Shop must be notified. The well is located in a restricted area; access requires escort by the CE Utility Shop, which can be reached at 575-572-7080. If additional cleaning or bailing is determined necessary following completion, the CE Utility Shop must be notified.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| Solicitation - FA480126Q0013.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
STATEMENT OF WORK
CLEAN WATER WELL SA-1
Feb 24, 2026
1. The Contractor shall clean Water Well SA-1.
2. This well is located about five miles south of Alamogordo.
3. This well is about 710' deep with a 16" diameter casing. The static water level is at a depth of 225'.
4. The casing has become clogged with debris. The inside of the casing needs to be cleaned.
5. Inject a liquid descaling cleaning solution into the well. Then use a brush to clean the inside of the casing.
6. The Contractor shall bid to brush the well for twenty (20) hours.
7. After 15 hours of brushing, stop work and take a video of the well casing. Then contact the CE Utility Shop, who will review the video. They will then decide how much more brushing will be required.
8. If the shop determines that no further brushing is required, then the cleaning phase will be considered complete.
9. If the shop determines that more brushing is required, continue to brush the well for up to five (5) additional hours.
10. If any damage to the casing is noted during the brushing process, stop work and notify the
CE Utility Shop.
11. Remove the debris at the bottom of the well. The Contractor shall bid for ten (10) hours of bailing and sand pumping.
12. Take another video once all brushing and bailing is complete.
13. If it is determined that additional cleaning or bailing is required, notify the CE Utility Shop.
14. The pump and column pipe have been removed from the well. There is nothing in the well other than the usual rust and debris. Some debris has fallen to the bottom of the well.
15. The well is located in a restricted area. The CE Utility Shop will escort the contractor out to the well location. Their number is 575-572-7080.
16. Submit product information on the cleaning solution prior to starting work. Do not begin any work until the cleaning solution has been approved by the CE Inspector.
-----END-----
File details come from the government source that posted it. Updated .