SMCWV FORM 1155.pdf

*SEE NOTES BELOW FOR NUMBERED FIELDS

1. RECORD OF TREATMENT AND TEST:

2. CONTRACTOR: CONTRACT NO: DATE:

SPECIFICATION NO: DRAWING NO: DATE SHIPPED:

CHEMICAL ANALYSIS MADE BY: METHOD/SPEC: MACROETCH: SATISFACTORY

C

Mn P S Si Ni Cr Mo V MACROETCH: NOT TAKEN

OBTAINED DATE CAST:

REQUIRED DATE FORGED:

HEAT NO: TYPE OF INGOT: INGOT DIA: INGOT LENGTH:

INGOT NO: INGOT WEIGHT: INGOTS/HEAT:

3. HEAT TREATMENT: HEAT TREATMENT PERFORMED BY:

MECHANICAL TESTS MADE BY:

SPECIMEN LOCATIONS YS TS RA, % 4. ELONG, % 5. FRACTURE HARDNESS CHARPY, FT-LBS/JOULES

% OFFSET= TEMP =

6. VALUE DIFFERENCE

REQUIREMENT

REMARKS:

NOTES: 1. ENTER THE NUMBERS OF ALL FORGINGS OR CASTINGS REPRESENTED BY THESE TESTS, MARKING WITH AN ASTERISK (*) THOSE FROM WHICH SPECIMENS ARE TAKEN. 2. ENTER FIRM NAME AND ADDRESS. 3. USE REMARKS

BLOCK. 4. INDICATE GAGE LENGTH AND WHETHER 4D OR 5D IN REMARKS BLOCK. 5. C=CUPPED; CR=CRYSTALLINE; I=IRREGULAR; N=NONMETALLIC; P=PITTED; L=LAMINATED; W=WOODY; LC=LUSTROUS CAVITIES.

6. WHEN REQUIRED, INDICATE + OR – VALUE. ALSO INDICATE ADJUSTED MECHANICAL PROPERTIES USING: ADJ VALUE = PROD VALUE + VALUE DIFFERENCE.

GOVT INSPECTOR (TYPED NAME & SIGNATURE) ORGANIZATION DATE: SIGNATURE AND TITLE OF CERTIFYING OFFICIAL: DATE:

SMCWV FORM 1155 1 AUGUST 1990 PREVIOUS EDITIONS OBSOLETE