LED_SOW_(Parts_only)_COB_G_&_1_(1).doc

U.S. DEPARTMENT OF STATE

OBO FACILITIES MANAGEMENT DIVISION

STATEMENT OF WORK

DATE:

April 4, 2017

PROJECT:

Zagreb LED Replacement

SERVICES:

Light Emitting Devices (LED) fixtures

1. BACKGROUND AND PURPOSE

a. The U.S. Embassy in Zagreb and Overseas Buildings Operations (OBO) has a requirement to upgrade the lighting system in certain areas of the Embassy to LED. This SOW calls for the procurement of quality LED fixtures that are either UL or CE rated.

2. GENERAL REQUIREMENTS

a. The Contractor shall provide the material and shipping of the parts required to complete the technical requirements in this Statement of Work.

3. SCOPE OF WORK

a. The following lighting manufactures are authorized:

i. Lithonia Lighting

ii. Acuity Brands

iii. Gotham Lighting

iv. Hubbell Lighting

v. Mark Lighting

vi. All fixtures must be UL rated.

vii. Equivalent models/brands will be determined by COR and OBO personnel.

b. The power source in Zagreb, Croatia is 230V, 50Hz

i. Preferred operating parameter for voltage is 120-277V, 50Hz or MVOLT

c. Provide 135 LED 6” down lights:

i. Lithonia Lighting 6IN LDN, 3500 K, 2000 LM, 80 CRI, clear, semi-specular reflector.

ii. LDN6 35/20 LO6AR LSS

d. Provide 30 LED 6” down lights (emergency):

i. Lithonia Lighting 6IN LDN, 3500 K, 2000 LM, 80 CRI, clear, semi-specular reflector.

ii. LDN6 35/20 LO6AR LSS

iii. Including emergency battery pack with integral test switch

e. Provide 4 LED Strip lights:

i. Lithonia Lighting ZL1F, 48” length, 3000 lumens, 3500 K, 80 CRI, medium diffuser

f. Provide 6 LED Strip lights (emergency):

i. Lithonia Lighting ZL1F, 48” length, 3000 lumens, 3500 K, 80 CRI, medium diffuser

ii. Including emergency batter pack

g. Provide 2 LED Wall-wash lights (4’):

i. Lithonia Lighting/Mark Architectural Lighting

ii. SPRLED 4FT, N35AD, MVOLT FA

iii. Shallow profile perimeter wall-wash 4’ fixture with normal output, 3500 K, 100 W dimming driver, and flush acrylic lens

h. Provide 3 LED Wall-wash lights (3’):

i. Lithonia Lighting/Mark Architectural Lighting

ii. SPRLED 3FT, N35AD, MVOLT FA

iii. Shallow profile perimeter wall-wash 4’ fixture with normal output, 3500 K, 100 W dimming driver, and flush acrylic lens

i. Provide 4 LED Wall-wash lights (6’):

i. Lithonia Lighting/Mark Architectural Lighting

ii. SPRLED 6FT, N35AD, MVOLT FA

iii. Shallow profile perimeter wall-wash 4’ fixture with normal output, 3500 K, 100 W dimming driver, and flush acrylic lens

j. Provide 4 LED Wall-wash lights (5’):

i. Lithonia Lighting/Mark Architectural Lighting

ii. SPRLED 5FT, N35AD, MVOLT FA

iii. Shallow profile perimeter wall-wash 4’ fixture with normal output, 3500 K, 100 W dimming driver, and flush acrylic lens

k. Provide 2 LED Wall-wash lights (8’):

i. Lithonia Lighting/Mark Architectural Lighting

ii. SPRLED 8FT, N35AD, MVOLT FA

iii. Shallow profile perimeter wall-wash 4’ fixture with normal output, 3500 K, 100 W dimming driver, and flush acrylic lens

l. Provide 700 LED Volumetric recessed lighting:

i. 2BLT2 MG 33L ADP LP835

ii. BLT 600x600 MG, 3300 NOMINAL LUMENS, Curved Linear Prismatic lens, 3500K CCT

m. Provide 80 LED Volumetric recessed lighting (emergency):

i. 2BLT2 MG 33L ADP LP835

ii. BLT 600x600 MG, 3300 NOMINAL LUMENS, Curved Linear Prismatic lens, 3500K CCT

iii. EL14L – 1400 lumen battery pack

4. CONTRACT ADMINISTRATION

a. The OBO does not make representations or warranties of whatsoever kind or nature, either expressed or implied, as to the quality, level of completion, accuracy, extent of compliance with the standards, codes and requirements described or referred to in this SOW, or the extent of coordination between or among the documents provided to the Contractor.

b. Neither the Embassy’s nor OBO’s review, approval, or acceptance of, nor payment for the services required under this contract shall be construed to operate as a waiver of any rights under this contract or any cause of action against the Contractor arising out of the performance of this contract.

c. The OBO has the right to inspect and test all services called for by the contract, to the extent practicable at all times and places during the term of the contract. The OBO may perform quality assurance inspections [QAI] and to confirm the work is being performed according to the Statement of Work.

5. RESPONSIBILITY OF THE CONTRACTOR

a. The Contractor shall be responsible for the professional quality, technical accuracy, and the coordination of all parts furnished under this contract.

b. The Contractor is responsible for safety and shall comply with all local labor laws, regulations, customs and practices pertaining to labor, safety and similar matters. The Contractor shall promptly report all accidents resulting in lost time, disabling, or fatal injuries to the Contracting Officer’s Representative (COR). The COR is the Facility Manager, Doug Barnes. Contact: BarnesWD@state.gov

6. CRITERIA

a. The Contractor shall provide the exterior and interior lighting accessories in accordance with U.S. codes and standards. OBO will review and comment on the Contractor’s submissions using the following codes and standards:

i. Underwriters Laboratory Requirements for electrical lighting fixtures

ii. International Building Code

iii. Safety and Health Requirements Manual: http://obo.m.state.sbu/ops/shem/Documents/Corps%20of%20Engineers_2008_English.pdf

b. Warranty for all materials shall be included with the solicitation.

c. Lowest cost bid, which is technically acceptable, may be awarded.

7. Deliverable Schedule

a. Project Completion: Receiving of the approved parts at the following address:

IKUN, LLC

2801 ROUTE 130, UNIT 1

NORTH BRUNSWICK, NJ 08902

Tel: 571-482-5289/571-482-5290

8. SECURITY

a. Information submitted by the Contractor will not be disclosed beyond the Embassy.

END OF STATEMENT OF WORK

� EMBED MSPhotoEd.3 ���

- 2 -

_1068545213.bin