S01 ATTACHMENT 3 Pictures and Specifications.pdf

1 | P a g e

Mounted Hydraulic Probe Figures

Figure 1 – Side view of the mounted hydraulic probe. Spray-on bed liner (similar or equal to Rhino Lining ®) will be applied to the vehicle bed edges. Toolbox will be mounted on the passenger’s side of the bed rail.

2 | P a g e

Figure 2 – Close-up view of the mounted hydraulic probe. A spray-on type bed liner (similar or equal to Rhino Lining ®) is applied to the bed and box edges to protect from possible rust. Wire mesh installed/attached around the probe on the inside of the truck bed will prevent items from falling through.

3 | P a g e

Figure 3 – Rear view look from the tailgate of the mounted probe. The braces are used to stabilize and keep the probe in place. The power unit and hydraulic switch are located to the left of the probe and adjacent to the left side of the bed rail. The toolbox is mounted on the right side (passenger) of the bed rail with struts attached to the toolbox and pickup bed for stabilization.

4 | P a g e

Figure 4 – Close-up view of the mounted probe and truck bed. (Note that the Spray-in bed liner seals the rough edges of the hole and prevents possible rust of the bed).

5 | P a g e

Figure 5 – Examples – CM brand (or equal) flatbed trailer

Specifications and Features

Length: 8’6”

Headache Rack: Steel Tube

Deck: 1/8” Treadplate

Frame Rails: 4” Structural Channel Steel

Crossmembers: 3” x 3/16” Channel

Rear Skirt: Solid One Piece with Tapered Covers

GN Hitch: 30K B&W Hitch with Welded Ball

BP Hitch: 18,500 lbs. B&W Hitch with Receiver Tube

Fuel Fill: Angled

12V Trailer Plug: 12V round, 7-pin in GN box, Round 7-pin 4-way flat on rear

Rear Lighting: Clear LED Oval

Light Box (Rear Skirt): Steel

Marker Lighting: Bullet DOT approved LED

6 | P a g e

Figure 6 – Westin ® 80-TBS200-72 (or equal)

Dimensions: 72” L x 20” W (at the bottom) x 24” H

Tool Box Type: Top Mount

Door Quantity:

Drawer Quantity:

Single (1)

Double (2)

Opening Style: Doors and Drawers

Volume Approximately 20cf

Material: Aluminum

Finish: Bright

7 | P a g e

Figure 7 – Core tube sample holder fabricated from 2” angle iron or metal sturdy enough to hold sample.

8 | P a g e

Figure 8 – Haldex 12V DC Hydraulic Power Unit (or equal).

Specifications:

Volts: 12 Volt DC

Flow (GPM):

Inlet Port (in.):

1.4

9/16 in-18 SAE

Outlet Port (in.): 9/16 in-18 SAE

Reservoir Capacity 3 qt.

Max RPM: 2,750

Max PSI:

Operation Method

3,000

Manual; 3-position spool valve

9 | P a g e

Figure 9 – Road Master Spare Tire Carrier (or equal).

Construction: Painted or Powder coated steel

Mounting bracket material thickness:

1/4in

Minimum wheel diameter:

18in

Lug nuts to be included: Yes

10 | P a g e

Figure 10 – N-FAB single and double hoop side steps (or equal).

Construction:

Tube Diameter:

Tube wall thickness:

Powder coated steel

2in – 3in

0.084 - 0.095in