PWS 308th Bull Pen 22Jul25 (308 Edits).pdf

Performance Work Statement (PWS) 308th RQS Bull Pen Facility Modernization Project

BLDG 780; Rooms 207A/B, 208, 211

1.0 PURPOSE The purpose of this requirement is to modernize the 308th RQS Bull Pen facility to enhance operational functionality through the installation of modular workspace solutions, technology integration, and structural reconfiguration in designated office and reception areas.

2.0 SCOPE OF WORK The contractor shall provide all labor, equipment, materials, and supervision necessary to execute the scope outlined below. All work shall comply with applicable local codes and installation access requirements.

2.1 Office Reconfiguration (Rooms 208 and 211)

• Realign front entrance walls to match adjacent middle office configuration

• Use manufacturer-matched materials consistent with existing installations

2.2 Reception Area Renovation

• Remove and dispose of current desks

• Provide and install two (2) L-shaped desks, 72"x72"x24", including a reception counter at the main entry

• Install prefabricated tech wall with embedded monitor and 308th RQS branding

2.3 Bull Pen Workstation Area

• Remove existing desks

• Install 34" prefabricated walls to create eight (8) individual workstations

• Each station includes:

o One (1) L-shaped desk, 72"x72"x24" with lower cabinetry o Writable wall surfaces

• All finishes and colors shall match facility standards

2.4 First Sergeant’s Office

• Install prefabricated office enclosure (approx. 96" x 120")

• Provide and install one (1) L-shaped desk, 72"x72"x24"

2.5 Demountable Wall Reconfiguration – Second Floor The contractor shall reconfigure demountable architectural walls on the second floor to expand and modernize designated office areas. This includes:

• Tear-down of existing demountable partitions and doors

• Expansion of wall layout to accommodate revised office configurations

• Installation of new modular walls per approved KI Wall architectural drawings

• Integration of clear tempered glass panels, rift-cut wood doors, and anodized aluminum finishes as specified

• Installation of compliant door hardware including Schlage ALX50J cylindrical locksets, overhead closers, and door stops

• Final adjustment and finish to ensure alignment, wall stability, and design intent

All work must conform to project renderings and component specifications detailed in the accepted vendor proposal, including wall post back color, ceiling rail, and trim codes.

3.0 EXCLUSIONS

• Data communication (WAPs and phone jacks to be supplied by customer)

• Offsite staging, overtime labor, and holiday scheduling are not included

4.0 ACCEPTANCE CRITERIA Work will be accepted upon completion of:

• Compliance with scope and design

• Successful installation and functionality of workstations and tech features

• Ensuring any damage is repaired and uniformity is present through work areas

• Government representative walkthrough and approval

5.0 Base Access and REAL ID Compliance All contractor personnel accessing Patrick Space Force Base must comply with federal base entry protocols. This includes:

• Presenting a valid REAL ID-compliant state-issued identification or an acceptable federal credential (e.g., DoD CAC, passport) upon arrival at the gate

• Coordinating with the Government Point of Contact to obtain base access passes at least 72 hours prior to arrival

• Complying with security procedures, including vehicle inspections, restricted area boundaries, and prohibited item policies