SOW_Network_Cable_Installation_Services.pdf

PRETRIAL SERVICE AGENCY FOR THE DISTRICT OF COLUMBIA

PSAIT

STATEMENT OF WORK

FOR

Network Cable Infrastructure Installation Services

1) SCOPE OF WORK

The Pretrial Services Agency (PSA) for the District of Columbia has requirement to contract services for the installation of data cables (voice and data), plates (for voice and data port), for scheduled remodel cubicles located at 633 Indiana Ave 9 th , 10 th , 11 th and

601 Indiana Ave 3 rd floor.

1.1 DEFINITIONS

The contractor will be responsible for all cable installations from point of entry (wall plates) to the patch panel, which is located in the computer room (patch panel closet) of each floor. Once the cables are installed, the wall plates and patch panel must be clearly label. The network cables must be a minimum of Cat 6 and cat 5e specification.

2) REQUIREMENTS

The contractor shall provide all the resources necessary for the installation of network cabling (data and voice). Documentation of completed task will be as follows:

2.1 Cabling for Data and Voice:

1) The contractor shall provide all materials (cables (Cat 5e), faceplates) in accordance with the specifications listed in this statement of work.

2) Contractor shall mount cable support systems to the ceiling.

3) Contractor shall run Cat 6 plenum cable and Cat 5e from LAN room (Patch Panel closet) to each location on the floor plan.

4) All cables for data and voice shall be neatly tie wrapped and terminated on cat 6 and cat 5e patch panel in the LAN room (Patch panel closet).

5) Contractor shall suspend cable bundles with rings and loops.

6) Each Jack/drop (plate) shall consist of 2 data and 1 voice ports.

7) All cable installation must conform to DCRA regulations. Each cable drop shall meet the relevant BICSI and/or EIA/TIA specifications or as specified by CSOSA

8) Cable faceplates and patch panel must be label clearly to allow PSA IT staff to identify cable termination locations.

9) All ports on patch panel shall be labeled accordingly with D designation for data and

V designation for voice

10) All cable being terminated in modular furniture Must be bundled and left in the ceiling until furniture is delivered and assembled on a later date.

11) Once modular furniture is installed and assembled, the contractor shall run cable through each cubicle and terminate RJ45C jack and label

12) All labeling is to be in a sequential order. Data drops within the same faceplates are to have the D for data designation, V designation for voice, and the location ID.

Faceplates must allow for paper or vinyl label to be place under a protective clear plastic covering. Patch panel will also reflect the sequential labeling scheme.

2.2 LAN Room (Patch Panel Closet)

1) Contractor shall provide all the required materials (cable management accessories, Cables ties where required.

2) Cable shall be terminated on the appropriate patch panel for voice and data.

3) Patch panel shall be labeled with room designation for D for data and V for voice.

4) All cable installation shall conform to DCRA regulations. Each drop shall meet relevant BICSI and/or EIA/TIA specifications or as specified by CSOSA.

2.3 Testing and Certification

1) All cables shall be tested for attenuation, crosstalk, and wiremapped.

2) All ports shall be tested for connectivity.

3) Installation Schedule Attached (Attachment I)