SOW (Draft.updated).pdf

STATEMENT OF WORK

VERTICAL LAUNCHING SYSTEM

MK25 Umbilical Connect, Cable Assembly, Printed Wiring Assembly

1. INTRODUCTION

The Naval Surface Warfare Center (NSWC), Corona Division, Measurement Science & Engineering Department, Interface Engineering & Assessment Division (MS20) was tasked to procure MK25 Connector, Missile Umbilical, Part Number 7115456-1, Cable Assembly, A1A2W1, A1A3W1, A1A4W1, A1A5W1, Part Number 7116997-9, Printed Wiring Assembly, Canister Part Number 7117089- 9.

2. BACKGROUND

The Missile Umbilical Connector, Cable Assembly, and Canister Printed Wiring Assembly are electrical components that support the MK41 VLS on various Navy ships, as they are required for the systems maintenance/overhaul and/or to replace obsolete items.

3. SCOPE

The Contractor shall be responsible for the satisfactory and timely performance of the requirements defined in the Statement of Work (SOW). This SOW, with its supporting attachments and referenced documentation, describes the total requirement for the manufacture, assembly, and delivery of VLS MK25 Umbilical Connect, Cable Assembly, and Printed Wiring Assembly to the U.S. Navy.

4. APPLICABLE DOCUMENTS

4.1 Government Documents

Document Number Document Title 7115456 Rev. M Connector, Missile Umbilical

P/N: 7115456-1 7116997 Rev. D Cable Assembly, A1A2W1, A1A3W1, A1A4W1, A1A5W1 P/N: 7116997-9

7116997-9 PL Rev. C Parts List Cable Assembly, A1A2W1, A1A3W1, A1A4W1, A1A5W1

P/N: 7116997-9 7116975E Printed Wiring Assembly, Missile Present

7116976A- Cover Assy, Missile Present

Cover Assembly, Missile Present

7116976A-9 (PL) Cover Assy, Missile Present Parts List 7116977B Printed Wiring Board, Missile Present

7116997C-9 PL Cable Assy, A1A2W1, A1A3W1, A1A4W1, A1A5W1 Parts List

7116997D Cable Assy, A1A2W1, A1A3W1, A1A4W1, A1A5W1

7117069A-Backshell Back shell 7117078_E Plate, Back shell

7117079_D_MK25 Cover, Back shell 7117112rev Guide, Jackscrew 7117127A Connector, Receptacle, 15 Socket Contact, Floating 7117129A Connector, Receptacle, 50 Socket Contact, Floating 7117153_E227195_appr_

11212018 Cable Assy, A1A2W1, A1A3W1, A1A4W1, A1A5W1 7117153B Temperature Sensor Housing Components

7117170_C Conduit Assembly 7117200C-Gasket Gasket

1771214- Ring, Locking Ring, Locking 7117219-Shunt, Electrical Shunt, Electrical

7117225_A Tube, Guide 7117231A Saddle Assembly

7117237-Backshell Back shell, Connector, Shield Termination 7117240rev Adapter 7117242B Caulking, Conductive

7117259 Rev D Washer 7251083B-Adhesive, Epoxy Adhesive, Epoxy

PL7116975-19_B Missile Present Parts List WS19179E Process Specification for Fabrication and

Installation of Cable Assemblies and Wiring Harness

WS19185B- Process Specification for Marking of Items

Process Specification for Marking of Items

WS19201D- Process Specification for

Application of Epoxy Polyamide Paint

Process Specification for Application of Epoxy Polyamide Paint

7117089 Rev. N Printed Wiring Assembly, Canister P/N: 7117089-9

7117089-9 PL Rev. F Parts List, Printed Wiring Assembly, Canister P/N: 7117089-9

2533409B Nut-Hex, Self-Locking Thin 5771850Rev- Sealant

7117040 Rev J Connector, Canister Umbilical 7117041H Insulator, Circuit board

7117042 Rev J Contact, PIN 20GA 7117043 Rev J Contact, PIN 16GA 7117044 Rev J Contact, PIN 12GA

7117048A- Plug, Filler Plug, Filler 7117060- Keying Plug Keying Plug

7117089_N Printed Wiring Assembly, Canister

7117089F-9 PL Canister Parts List 7117090_E268447_appr_

09272021 Printed Wiring Board, Canister

7117090_G Printed Wiring Board, Canister 7117091 Rev C Schematic Diagram Printed Wiring Assembly

Canister 7117092B Electrical Acceptance Test Procedures, ESSM

Canister PWA 7117095- Bar, Support Bar Support

7117096 Rev A Connector, CSES 7117097_B Relay, Solid State, DC Output, Squib Fire

7117133-Threadlocker Adhesive

Thread locker Adhesive

7117139- Strap, Ground Strap, Ground 7117149 Rev A Connector, Receptacle 25 Socket Contact 7117150 Rev B Connector, Receptacle 50 Socket Contact

7117257_appr_05162019 Production Environmental Test Requirements for Vertical Launching System Canister

8240280 Rev- Semiconductor Devices, High Reliability

5.0 REQUIREMENTS

5.1 MK25 Umbilical Connect, Cable Assembly, Printed Wiring Assembly

The Offeror shall ensure all manufactured parts are to the latest drawing and subject to applicable revision or change notice(s). The Offeror shall furnish all materials, components, and services required to manufacture parts complete per the latest specifications. The Offeror shall execute applicable modification per revision or change notice(s) at the appropriate phase to satisfy product conformance according to the latest requirement with minimal impact on the overall performance of the contract.

Item # DRAWING DESCRIPTION QTY.

1 7115456 Rev. M Name: Connector, Missile Umbilical Part Number: P/N 7115456-1

7116997 Rev. D 7116997-9 PL Rev. C

Name: Cable Assembly, A1A2W1, A1A3W1, A1A4W1, A1A5W1 Part Number: P/N 7116997-9

7117089 Rev. N 7117089-9 PL Rev. F

Name: Printed Wiring Assembly, Canister Part Number: P/N 7117089-9