Fizeau_Interferometer_SOW_Draft.pdf

Rev 02/04/19

Statement of Work

Depot Level Fizeau Interferometer

1. INTRODUCTION

The Naval Surface Warfare Center, Corona (NSWCCO) Division, Measurement Science and Engineering

Department perform Metrology, Test, and Monitoring Systems Assessment supporting the NAVSEA

Metrology and Calibration (METCAL) Program. Measurement Science and Engineering Department sets the measurement science and calibration standards to support proper weapons operation, interoperability and peak readiness for the fleet.

2. BACKGROUND

Measurement Science and Engineering Department, Code MS35 provides support and guidance for the

Test and Measurement Diagnostic Equipment (TMDE) and the Calibration Standards Program in support of Navy Calibration Laboratories. The Depot Level Fizeau Interferometers will be used by Navy personnel in shore-based depot laboratories for calibration of a wide variety of optical flats, gage blocks, and mounted mirrors.

3. SCOPE

The scope of this effort is to procure a minimum of one (1) and a maximum of seventeen (17) Depot

Level Fizeau Interferometer’s, over a three (3) year period, for all Navy calibration laboratories necessary to replace the Navy’s current Plano-Interferometer; the D305 and D309 series by Davidson Optronics.

The Fizeau Interferometer shall cover up to four (4) inches in diameter for optical flats with a 4-inch transmission flat and up to 12 inches in diameter with a beam expander attachment. For vertical configurations, the minimum height length for testing of gage blocks for this configuration shall be six (6) inches to provide proper clearance.

4. APPLICABLE DOCUMENTS

Document Type No./Version Title Date

MIL-PRF

28800F Test Equipment for use with Electrical and Electronic

Equipment, General Specification.

MIL-PRF

38793 Manuals, Technical: Calibration Procedures Preparation

NIST Technical

Note

1297 Guidelines for Evaluation and Expressing the Uncertainty of

NIST Measurement Results http://physics.nist.gov/Pubs/guidelines/TN1297/tn1297s or from the National Institute of Standards and Technology, Gaithersburg, MD 20899-0001

NAVAIR

17-35QAC-

01B

Navy Marine Corps Calibration Laboratory

Audit/Certification Manual http://physics.nist.gov/Pubs/guidelines/TN1297/tn1297s

Rev 02/04/19

5. REQUIREMENTS

The Contractor shall provide the Government a minimum of one (1) and a maximum of seventeen (17)

Depot Level Fizeau Interferometers in accordance with specification CSS 06-3211.

5.1.1 The Contractor shall provide operator/maintenance manual(s) required to be supplied with each calibration standard. At a minimum, these manual(s) shall contain information on operator/maintainer safety, theory of operation, troubleshooting, preventative maintenance, periodic maintenance, calibration, maintainability data, and operational instructions. The manuals can be either print or electronic media format on either CD-ROM or DVD disks.

5.1.2 The Contractor shall ensure the interferometers shall be provided with a manufacturer’s standard warranty, of one (1) year minimum after acceptance by the Navy.

5.1.3 A calibration certificate with a report referencing actual data shall be provided by the vendor to the

Government for each interferometer procured.

5.1.4 Calibration certificates provided must include standards that are traceable to the National Institute of

Standards and Technology (NIST) and result in an Accredited Certificate/Report of Calibration.

5.1.5 The Contractor shall provide a calibration label indicating the calibration interval shall be placed on each delivered interferometer.

5.1.6 The Contractor shall provide a Software/Firmware version to be provided with each system delivered. The Software/Firmware version shall be the same on all interferometers delivered.

5.1.7 The Contractor shall provide a Software/Firmware Change Request, to the US Navy prior to any software/firmware changes to alert and inform the US Navy about changes to software/firmware and also to provide detailed information about the changes and estimated cost. The Software/Firmware Change

Request shall be provided on CD-ROM, DVD disk, or via an internet downloadable site to the US Navy for correction of software errors or commercially available improvements for the model numbers of the calibration standards installed for a period of not less than five (5) years.

6. GOVERNMENT FURNISHED PROPERTY

N/A