23-SIMACQ-D40-0023_SOW - ASTV SAM.docx

Statement of Work for

CONTROL PANEL TO DB-9 CONNECTOR CABLE ASSEMBLY

1 Scope. Naval Surface Warfare Center (NSWC), Port Hueneme Division requires to procure Control Panel to DB-9 Connector Cable Assembly.

2 Applicable Documents.

2.1 Department of Defense Drawings.

Drawing 8751013 Control Panel to DB-9 Connector Cable Assembly

2.2 Department of Defense Standards. Available from the ASSIST database at https://quicksearch.dla.mil/.

2.3 Non-Government Standards and Other Publications.

3 Requirements.

The contractor shall provide all resources necessary to accomplish the tasks and deliverables described in this Statement of Work (SOW).

The contractor shall create a Control Panel to DB-9 Connector Cable Assembly. Drawing will be provided. These tasks are described in detail below.

3.1 Custom Cable.

3.1.1 The contractor shall produce two (2) Control Panel to DB-9 Connector Cable Assembly as first articles.

3.1.2 After Government acceptance of the design, the contractor shall transition to full rate production to produce additional Control Panel to DB-9 Connector Cable Assembly for use in the fleet.

3.1.3 Physical Configuration. The cable Assembly shall follow all measurements identified in drawing 8751013.

3.1.4 Quality of Workmanship. The display PC shall be manufactured and assembled with a quality of workmanship which assures freedom from defect which might adversely affect life, strength, or reliability of each assembly. Particular attention shall be given to neatness and thoroughness of assembly. Protective coatings shall be continuous and free from scratches or gouges. Threaded fasteners and mounting hardware shall be properly assembled and tightened. All sharp edges shall be rounded.

3.1.5 Marking. The display PC shall be marked in accordance with MIL-STD-130N.

3.1.6 Connectors. The unit shall include two (2) connectors as follows, with pinouts described in Table 1 and Table 2. Ground is carried through receptacle P5 and J1. The P5 connector shall be a MIL-DTL-28840-series receptacle.

Table 1. Power Cable and Pinout P5

Table 2. Data Cable and Pinout.

J1

3.2 Place of Performance. Work shall be performed within the United States.

3.3 Meetings. No meetings are required

3.4 Point of Delivery. Hardware shall be delivered to:

Commander Naval Surface Warfare Center, Port Hueneme Division 4363 Missile Way Port Hueneme, CA 93043-4307

3.5 Government Points of Contact (POCs).

3.5.1 Technical POC.

3.5.2 Alternate Technical POC.

3.5.3 Contracting POC.