1.02 Dometic_SeaLand_711-M28_Toilet.pdf

This manual must be read and understood before adjustment, maintenance, or service is performed. Modification of this product can result in property damage.

WARNING !

SeaLand®

Gravity discharge Toilet Owner’s Manual SeaLand® 711-M28 Toilet

Dometic Sanitation Corporation 13128 State Rt 226, PO Box 38

Big Prairie, OH 44611 SeaLand Product Customer Service: 1-800-321-9886 www.DometicUSA.com

Recommendations

Specifications Product Name: 711-M28 SeaLand Marine Toilet Shipping Information:

System:

Dimensions:

1. Read the “Operating Instructions” section of the manual carefully.

2. Make sure all guests understand the operation of the SeaLand toilet.

3. Carry a few spare parts for the maintenance pur-poses. Dometic has developed several repair kits that will save you both time and expense should a problem occur. See “Customer Service” section of this manual.

4. Use only SeaLand brand® Tissue and SeaLand® brand Holding Tank Deodorants to maintain a trouble-free system.

5. Do not use chlorine or caustic chemicals, such as laundry bleach or drain opening types, in the system. These products damage the seals in toilets.

soon as a problem is detected, correct it.

Installation Instructions Tank:

1. Select position in bathroom where unit can operate properly. Allow room for using the flush lever and clearance for raising the seat and lid.

2. Position the tank 3/4" (19mm) away from the wall.

Mark four holes at mounts on tank base. After holes are marked, remove tank, and drill pilot holes. Slide tank back into position. Secure the tank with four #14 x 2" long pan head screws and washers on all tank mounts.

3. Run 5/8" (16mm) I.D. hose to vent fitting and secure with hose clamps.

Install thru-hull vent fitting:

(not supplied with unit – SeaLand part number 346368)

4. Drill hole through the hull, well above water line and directly above SeaLand toilet. Hole location is determined by routing and length of hose.

Table of Contents Specifications Recommendations Installation Instructions. . . . . . . . . . . . . . . . 2 - 4 Operating Instructions Maintenance. . . . . . . . . . . . . . . . . . . . . . . . 4 - 5 Preparing for Summer Use Model Identification Spare Parts Customer Service Troubleshooting Guide Warranty

12. Route hose from tank to deck fitting and secure with hose clamp.

Note: The holding tank on the 711-M28 is designed to withstand discharge by a properly operating discharge pump.

Toilet Installation:

13. Push button on back of flush pedal, then pull flush pedal cover away from pedal to expose water valve.

Remove plastic pedestal cover from toilet base.

14. Install the (4) 1/4-20 x 1-3/4" long studs in inserts on the tank top.

15. Place floor flange seal on studs, aligning the studs with bumps on seat. Note: “THIS SIDE UP” should face upwards.

16. Place toilet on studs and secure with four washers and four nuts.

5. Apply waterproof caulk around underside of thru-hull vent fitting.

6. Install thru-hull vent fitting and secure snugly with nut. Wipe off excess caulk with damp cloth.

7. Attach remaining end of vent hose to thru-hull fitting with hose clamp.

Dockside Discharge Fitting:

(not supplied by SeaLand)

8. Drill hole in deck directly above SeaLand toilet. Hole location is determined by routing space and length of hose.

9. Screw 1-1/2" FPT x 1-1/2" hose barb into bottom of deck fitting.

10. Apply waterproof caulk around deck hole and install deck fitting into 2-1/4" (57mm) hole with screws. Wipe off excess caulk with a damp cloth.

11. Install 1-1/2" MPT x HUB adapter into discharge fitting on holding tank. If necessary, PVC cement elbow and hose adapter or hose adapter only into 1-1/2" (38mm) adapter. Secure 1-1/2" (38mm) hose to adapter with hose clamp.

Installation Instructions (cont’d) or

Installation Instructions (cont'd)

Water line:

to inlet fitting on back of water valve.

Pedestal cover:

19. Slide back side of pedestal cover around rear of toilet base and snap in groove. Close front half of pedestal cover and snap in groove.

Flush pedal cover:

20. Put flush pedal cover back in place.

Seat and lid:

21. Remove seat and lid from package. Secure to ceramic bowl using instructions from mounting pack.

Operating Instructions

To properly use the SeaLand toilet, follow these simple instructions:

1. A good biodegradable tissue such as SeaLand® brand is recommended.

2. To add water to the toilet before using, lift or raise the flush pedal.

3. To flush toilet, push pedal all the way down until sewage leaves the toilet bowl. Water flow pressures vary at different locations and therefore, holding the flush lever down 4-8 seconds may be required. We recommend 2-4 GPM (8-15 Lpm) for proper rim and bowl wash.

4. Release flush pedal by allowing it to snap back, which permits positive sealing around the flush ball.

5. A small amount of water should remain in the bowl.

Note: Holding the flush pedal down longer than neces-sary results in excessive water usage.

Caution: Do not dispose of sanitary napkins or other non-dissolving items in the toilet.

Maintenance

Cleaning The SeaLand toilet should be cleaned regularly for maxi-mum sanitation and operational efficiency.

Clean the toilet bowl with a mild bathroom cleaner, such as SeaLand® Toilet Bowl Cleaner. Do not use chlorine or alcohol-based caustic chemicals such as drain opening types, as they will damage the seals.

If an odor is apparent from the toilet:

1. Clean out system by flushing several gallons of fresh water through with one cup of liquid laundry soap.

2. Add odor control deodorant in amount specified for your holding tank capacity after cleaning and every few days during use.

Winterizing At the end of each season, the SeaLand toilet should be winterized for storage by either draining or using potable, water-safe antifreeze in the system.

To drain:

waterline.

4. Press flush lever until all water is drained from toilet.

Your SeaLand 711-M28 toilet is designed for years of dependable trouble free service. However, during the life of the product certain parts may require replacement.

The following is a list of parts kits which may be required for maintenance purposes.

Model Identification

Spare Parts

The model identification label is located on the inside of the flush pedal cover.

To use antifreeze:

through toilet and into the waste holding tank. Each installation is different, so amounts may vary. User discretion is required to assure adequate protection.

5. Empty holding tank.

Note: Use nontoxic antifreeze designated for potable water systems (see boat owner’s manual).

Caution: Never use automotive-type antifreeze in freshwater systems.

Preparing For Summer Use To prepare the SeaLand toilet for summer use, turn on water supply and check system for leaks. Flush toilet, check for leaks and repair as necessary. Your SeaLand toilet is now ready for use.

Maintenance (cont’d)

Dometic has a strong, worldwide network to assist in servicing and maintaining your SeaLand toilet if parts or service are required. Before calling, please have the following information available. Your cooperation in hav-ing this information ready is appreciated and allows our Customer Service Department to better meet your needs.

When you call, we will direct you to the nearest parts distributor.

List.)

When you have gathered all the required information, call us at one of the following telephone numbers from 8:00 a.m. to 5:00 p.m. (Eastern Time) Monday through Friday, or email us.

Customer Service

U.S.A. - Southeast

(AL, FL, GA, NC, PR, SC, TN, VI)

Environmental Marine 111 S.W. 23rd Street, Suite A Fort Lauderdale, FL 33315

E-mail: info@environmentalmarine.com U.S.A. - Southwest (AZ, CO, NV, UT, CA-south) Ardemco Marine Specialties 778 West 17th Street Costa Mesa, CA 92627

E-mail: info@ardemco.com U.S.A. – Upper Midwest

(IA, MN, NE, ND, WI, SD)

PowerHouse Marine 518 Logan La Crosse, WI 54603

E-mail: dave@powerhousemarine.com U.S.A. – Northern California Fox Marine 6545 Caballero Buena Park, CA 90620 Tel: 800-826-2873 E-mail: foxmarco@pacificsupplyco.com Canada - East Transat Marine 70 Ellis Drive Unit 1 Barrie, Ontario L4N 8Z3 Canada

Email: josborn@transatmarine.com Canada - West Western Marine Company 1494 Powell Street Vancouver, BC V5L 5B5

MASTER SANITATION

DISTRIBUTORS –

North America U.S.A. – North Central

(IL, IN, KY, MI, OH)

Midwest Marine Supply 24300 Jefferson Ave.

St. Clair Shores, MI 48080

U.S.A. - Northeast

(CT, DE, DC, MA, MD, ME, NH, NJ, NY, PA,

RI, VA, VT, WV)

Northeast Marine Sanitation 69 Florida Street Farmingdale, NY 11735

U.S.A. - Northwest

(AK, ID, MT, OR, WA, WY)

Marine Sanitation, Inc.

1900 N. Northlake Way, Suite 121 Seattle, WA 98103

U.S.A. - South Central

(AR, KS, LA, MO, MS, NM, OK, TX)

AER Supply P.O. Box 349 2301 Nasa Road #1 Seabrook, TX 77586

E-mail: sales@aersupply.com

Troubleshooting Guide

1. Water will not stay in bowl.

2. Plastic flush ball will not close completely.

3. Water does not shut off in toilet (toilet overflows).

4. Water does not enter toilet bowl properly.

5. Water leaking from water valve.

6. Water leaking from rear of toilet bowl.

Teflon seal for foreign objects.

Clean if necessary.

a. Loosen clamp ring.

b. Check spring tension by letting up on flush lever suddenly. If lever does not snap back, replace spring cartridge.

a. Disassemble and clean water valve.

b. Bend front of cam strap up about 1/16" (1.6mm).

located on inlet of water valve.

a. Tighten bottom cap, inlet fitting and outlet hose clamp.

threaded and tighten.

connection.

c. Replace vacuum breaker assembly.

d. Replace toilet bowl.

P roblem Possible Cause Service Instructions

to dirt or debris on underside of Teflon® ball seal.

a. Clamp ring is overtightened, causing too much tension on seal and flush ball.

b. Weak or defective spring cartridge.

a. Dirt lodged in water valve seal.

b. Cam strap is bent down, holding water valve open.

a. Loose connection.

properly.

c. Worn or defective vacuum breaker.

d. Cracked or defective toilet bowl.

This page is intentionally left blank.

Manufacturer’s Two-Year and ten-year Limited Warranty Dometic Corporation warrants, to the original purchaser only, that this SeaLand® gravity discharge toilet, if used for personal, family or household-like purposes, is free from defects in material and workmanship for a period of two (2) years from the date of purchase.

Dometic also warrants, to the original purchaser only, that the ceramic portion of the toilet bowl will not discolor, stain, scratch or craze for a period of ten (10) years if used for personal, family or household-like purposes, and is regularly cleaned as described in the product’s owner’s manual.

If this Dometic product is placed in commercial or business use, it will be warranted, to the original purchaser only, to be free of defects in material and workmanship for a period of ninety (90) days from the date of purchase.

Dometic reserves the right to replace or repair any part of this product that proves, upon inspection by Dometic, to be defective in material or workmanship. All labor and transportation costs or charges incidental to warranty service are to be borne by the purchaser-user.

EXCLUSIONS

IN NO EVENT SHALL DOMETIC BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, FOR DAMAGES RESULTING FROM IMPROPER INSTALLATION, OR FOR DAMAGES CAUSED BY NEGLECT, ABUSE, ALTERA- TION, OR USE OF UNAUTHORIZED COMPONENTS. THIS INCLUDES FAILURES WHICH MAY RESULT FROM NOT FOLLOWING THE WINTERIZATION OR CLEANING PROCEDURE AS DESCRIBED IN THIS OWNER’S MANUAL.

ALL IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE, ARE LIMITED TO A PERIOD OF ONE (1) YEAR FROM DATE OF PURCHASE.

IMPLIED WARRANTIES

No person is authorized to change, add to, or create any warranty or obligation other than that set forth herein.

Implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one (1) year from the date of purchase for products used for personal, family or household-like purposes, and ninety (90) days from the date of purchase for products placed in commercial or business use.

OTHER RIGHTS

Some states do not allow limitations on the duration of an implied warranty, and some states do not allow exclusions or limitations regarding incidental or consequential damages; so, the above limitations may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

To obtain warranty service, first contact your local dealer from whom you purchased this product.

® Registered; ™ Trademark of Dometic Corporation ® Teflon is a registered trademark of DuPont Co.

© Dometic Corporation600342689 4/07

Dometic is a customer-driven, world-leading provider of innovative leisure products for the caravan, motorhome and marine markets. Dometic offers a complete range of air conditioners, refrigerators, awnings, cookers, sanitation systems, lighting, windows, doors and other equipment that makes leisure life more comfortable away from home.

Dometic also provides refrigerators for specific use in hotel rooms, offices and for storage of medical products and wine. Dometic’s products are sold in almost 100 countries and are produced mainly in Dometic’s own production facilities around the world. Dometic has more than 4,400 employees.

Dometic Sanitation Corporation 13128 State Rt 226, PO Box 38

Big Prairie, OH 44611 SeaLand Product Customer Service: 1-800-321-9886

Email: SeaLand@DometicUSA.com www.DometicUSA.com