1.02_PWS_PREVENTIVE_MAINTENANCE_(3).docx

PERFORMANCE WORK STATEMENT FOR PREVENTIVE MAINTENANCE SERVICES ICO NAVAL CONSTRUCTION TRAINING CENTER (NCTC) PORT HUENEME, CA.

Background.

1. Naval Construction Training Center (NCTC) on Naval Base Ventura County (NBVC) Port Hueneme, CA develops and trains Sailors, Soldiers, Airman, and Marines in construction trades and military skills for Department of Defense operating forces to accomplish contingency and peacetime construction, chemical, biological, and radiological operations, and humanitarian assistance missions worldwide.

1. NCTC offers course title “Advanced Steelworker”, CIN A-711-0030 in the Catalog of Navy Training Courses. “Advanced Steelworker” provides Steelworkers advanced technical training in Gas Cutting and Welding, Structural Arc Welding of Plate and Pipe, and Shielded Inert Gas Welding utilizing the Metal Inert Gas and Tungsten Inert Gas welding processes. “Advanced Steelworker” requires students to weld and cut metal coupons of various materials (aluminum, stainless steel, mild steel) in various shapes from pipe and plate. All materials used by the students are prepared by NCTC staff members through use of shop equipment that is currently not under a maintenance contract.

1. NCTC Steel shop support equipment needs to be on a maintenance contract to ensure reliable and safe operation as well as maintaining the service life of shop support equipment.

Note. This is not a construction requirement. No permanent Navy installations will be constructed or augmented pursuant to maintenance of shop equipment.

Requirement.

1. Quarterly Maintenance of the following;

3. Ingersol Rand Compressor, model 1N

3. Jet Zip Miter Bandsaw, model J-9225

3. Pexto Shear, model 152K

3. Piranha Shear, model 3/8-10B

3. Jet Mill, model JMD-18PFN

3. LeBlonde Regal Lathe, model 13x42

3. Piranha Ironworker, model P-50

3. Savage Hydraulic Press, model C Frame

Each quarterly inspection shall include;

0. Inspection of electrical controls, cabling, wiring and all switches

0. Inspection of motor amps and noise

0. Drive belts and pulley’s

0. Coolant pumps, hydraulic cylinders and cylinder rods

0. Check and adjust as necessary gibs and drive nuts for X and Y axis where applicable

0. Check oil levels and top off as needed

0. Inspection of hydraulic hoses and valves for damage or leaks

0. Inspection of lubrication systems, lube lines and lube to all points

0. Check gearbox and gears for noise where applicable

0. Check Spindle down drive and spindle run out where applicable and adjust

0. Check and adjust gibs and blade gaps where necessary

0. Check mechanical linkage and clamp locks where applicable

0. Check notcher blades, shear blades where applicable and check for sharpness

1. Annual Preventive maintenance to include in addition to quarterly;

4. Removal of used oil, cleaning of oil tanks where applicable.

4. Check for loose hardware and tighten to manufacture spec as necessary.

4. Installation of filters and oil as applicable.

1. General.

5. Preventive maintenance inspection results shall be submitted to NCTC Staff members via email. Content shall include specific part numbers and pricing for parts as necessary.

5. All filters and lubricants required to perform maintenance shall be ordered by the contracted preventive maintenance agent.

5. Disposal of petroleum oil and lubricants (POLs) shall be carried out by NCTC Personnel.