MFR VLAT RETARDANT TRAILER.pdf

MFR VLAT RETARDANT TRAILER SPECS

A. 16,000 Gallon (including interior parts) Wheel Mounted Mixing Tank.

-Option Pricing: 20,000 gallon with same features as below.

B. 1/4 Carbon Steel.

C. Round bottom with front and rear 4" 150 lb. flanges with valves, cam locks with caps or plugs. (rear valve must be at lowest point possible for easy drainage).

D. Sides and top of tank can be round or flat.

E. DOT Standard and appropriate lifting eyes for hauling of trailer.

F. External coating – Carboline paint or comparable (red).

G. Black letters 12” in height in Arial black font on both sides centered “MEDFORD VLAT

MRB.”

H. Carboline 187 Tank Liner (or comparable anti-corrosive liner)

I. Fluid Level Indicator on Front.

J. (1) 25” wide walkway, top.

K. Folding handrails.

L. Rear, center of tank, top mounted, steel 4" fill line w/ valve and cam locks with plug or cap, end of line should be at least halfway down the tank.

M. (1) 24” CLEAN OUT with steel cover, hinged, sealed closure on one side near rear of trailer.

N. (1) 24" CLEAN OUT front with steel cover, hinged, sealed closure.

O. Stainless steel perforated air compressor line, minimum diameter 1½” no larger than 2”(air needs to blow downward and to sides) along the length of the tank, located at the bottom inside of the tank with a standard hose attachment connection (rear of trailer) on the outside including back flow prevention valve.

P. Top mounted pressure relief style vent with hinged steel cover, sealed closure.

Q. A 3 inch male cam lock port needs to be attached at a point in the middle of the right side of the tank from front to back. It should be located no more than ¼ of the way down from the top of the tank or ¾ of the way up from the bottom. This should also eject fluid 20 degrees downward on the inside. Cam lock cap.

R. (1) Industry approved black vinyl or like material temporary containment with collapsible walls with correct dimensions to fit above tank trailer.