A1_SOW- Scissor lift Orig.pdf

STATEMENT OF WORK

SCISSOR LIFT REPAIR

Background

MCB Camp Pendleton utilizes horizontal carousels to store thousands of Marine Corps equipment repair parts. The carousels are accessed multiple times daily utilizing scissor lifts manufactured by Autoquip - see the attached. The equipment maintenance contractor has indicated that one lift either needs to be repaired or replaced as soon as possible.

Objectives

To repair a scissor lift.

Scope

To provide and install the required parts needed to return the lift to a fully operational status.

Tasks

Task Number

Work Milestones

Projected Completion Date

2.1 Site Visit TBD

2.2 Furnish materials TBD

2.3 Installation TBD

2.4 The TPOC will inspect the job when completed TBD

1. Upon award, the contractor is to provide a repair start date to the TPOC once the contractor has received the required repair parts.

2. Place Of Performance:

The job site location is aboard MCB Camp Pendleton, Ca in building 2251.

2.1 - Site Visit:

Contractors are to attend a site visit to confirm required repairs

2.2 - Furnish Materials:

The contractor will provide the materials required as indicated below:

Leg assembly and hydraulics (base frame, cylinders, hosing)

2.3 - Installation:

The contractor is to repair the scissor lift.

Contractor Responsibilities:

DISTRIBUTION: DoW COMMUNITY ONLY steven.elggren Cross-Out

Generic SOW Temp'ate

Remove damaged parts and place them outside of the building 2251

Install the new parts

Test the lift to ensure proper operation

Government Responsibilities:

Provide access to the building

Provide access to available power

Remove the damaged parts from the job site

2.4 - Completed Job Inspection:

The contract does not contain a Quality Assurance Survellance Plan (QASP); however, the TPOC will inspect the job for quality upon completion. Quality will be measured in accordance with the following:

Description Of Work

Contractors quoted materials at the time of the solicitation

3. Government Tecliiiical Point Of Contact:

The Contracting Officer will designate a Government Technical Point Of Contact ( TPOC) during the term of the contract. The TPOC will provide assistance in identifying and resolving problems and provide technical clarification and assistance in support of the contract. The TPOC

DOES NOT have the authority to make changes and/or give direction under this contract. The only person that can authorize the above is the Contracting Office from the Regional Contracting

Office MCI-WEST, Camp Pendleton, Ca.

Steve Elggren 760 725-3172 steven.e1ggren@usmc.mil

4. Base Access

DISTRtBUTION: DoW COMMUNITY ONLY steven.elggren Cross-Out rn b --.-.

I - - N

I -- I 9

I.

MATERIALS: 1/4' Thick Smooth Flat Steel with Fine Oxide Grit Finish

LiFTING CAPACIEY: 2,000 lbs, 1,000 lb. Side load, and 500 lb. End load

TRAVEL: 72 -

LOWERED HEIGHT: B, Approximately 4" of toe clearance when lift in lowered posion rs

F' ' S j 1IJ

IISXA1;4I1LIi

' ''-' '"I- 'I"

S - I- .i. - - I S - 5-. 5 I - - --

III

I

S.,-, - - - - I. - - S.. :. -- IS I.

" II S - S - - - - S -e . - - S - -

; 5 " - S S - S " 51.15

II I I

5" I S - - I - S - "SIS - - -

"'.I

.! LLt S 'S"S ';A:j!; ;\ "S "_O

E STOP

CHAIN ACROSS

ACCESS OPENING

FRONT

V8EW

Ii.1I111LI ANYWHERE REAR VIEW (FROM CAROUSEL SftDE)

ON CENTER

RAILING

14-0"

T

REAR VEW 4"

- rLt"L UP/DOWH I 0 SWTCH & ELECTRICAL 77.5"

OUTLETS ANYWHERE ON HAND RAIL

RGHT VIEW

3cIearPf- (

POWER SOURCE

0> ii(iIYkI1

L

ELECTRICAL OUTLET

MOU NTED

ON KICK PLATE.

ADDITIONAL POWER

STRIP TO BE ADDED.

FRONT VIEW

6-0" H 6-0" H 6-0" H in TET 48"

48'

I. .I IIIi*TiI q4" 88.5" 31.5" 13"