Laser Stamp Maker.Spec Table.pdf

Laser Stamp Maker:

Overall dimensions base structure:

36” wide x 32” deep, approximate load height at 38”-40”

Features: System with Programmable Toolpost and Auto Door

General Laser Marking System

1. Laser controller with laser power source, RF driver, and electrical controls

2. Laser marking head

3. 1.75m fiber optic cable assembly

4. Visible red-diode positioning beam

5. Dual Sense Shutter Assembly

6. MERLIN II LS, Visual Design Software

7. Flat field lens 160mm (4.33” x 4.33” Image field, 6.93” Working clearance)

8. Standard manual set on USB Stick

Vertical Door Enclosure

a. Features a sheet steel enclosure with vertical door with viewport window, handle, and lift assist balancer; exterior dimensions of 36” wide x 40” deep

b. Interior t-slot base with safety interlock during door closed operation

c. Monitor/keyboard support arm

2. Pneumatic Door Assembly

a. Pneumatic cylinder door lift

i. Cylinder valve for door operation

b. Push button activation

c. Safety bump strip

i. Operator safety feature that allows for “press and go” marking cycle activation

3. Programmable Z-Axis Mounting Post Assembly

a. Includes single rail support post, laser rail bracket support, and mounting base plate.

b. Stepper motor drive

4. Auxiliary Axis Controller Assembly

a. Provides two axis of control, programmable through the software programming, i.e. rotary drive axis or Z-axis

5. Industrial PC

a. Includes Windows 10 64-bit PC with the latest specs available, 17” monitor, keyboard and mouse.

6. Laser Safety Kit

a. Includes small electrical enclosure to house required laser safety controls

7. Base Support Structure

a. Base structure, floor mount, 36” wide x 32” deep, approximate load height at 38”-40”

b. Under-storage for PCU and controllers

8. E-Stop button pane

Mini Vacuum System:

General high efficiency vacuum system (12.5” x 13.5” x 18”;

45lbs.) welded steel powdercoat unit with single 3” inlet port.ii. 59 dba; 120VAC, 6.0A; 165cfm at 19” wc; variable speed blower control with electronic filter monitoring display

Rotary Device i. 5” Rotary drive with manual 3 jaw chuck

ii. Will utilize auxiliary controller included with system above

Utilities/ Power supply

1.120VAC power single-phase, 50-60Hz, 20AMP for laser and peripherals

2. 80psi – compressed air (clean/dry) if auto door system is purchased