ITB-25-001B-Addendum NO.1 Dish Machine.pdf

Honoring Those Who Served U.S.

ADDENDUM NO. 1

SOLICITATION NO. FDVA-ITB-25-001B

SOLICITATION TITLE: JACOBSON KITCHEN DISH MACHINE

ISSUE DATE: SEPTEMBER 23, 2024

The following FDVA responses shall clarify or, revise, or replacement the requirements of Solicitation No.

FDVA-ITB-25-001B.

1) FDVA Requirement Replacement: Remove the original dish machine, required (Hobart Model

#CLPS66EN on page 15,16 and replace it with CL44 - BAS.

FDVA now requires the Hobart Model-Conveyor Dishwasher- CL44 - BAS, in accordance with the following specifications:

Hobart Model CL44 - BAS Dish machine SPECIFICATIONS Hobart MODEL CL44 BAS Color Machine Specifications:

Machine direction of operation to be Left-to-Right

Machine electrical voltage to be 208/60/3ph.

Standard chamber opening dimensions: 22" x 19 11/16" to accommodate up to six 18" x 26" sheet pans in one rack.

(Optional higher than standard chamber opening of 22" x 24")

The machine MUST be Energy Star rated.

Final rinse rate: 90 gallons per hour (GPH).

The machine should have a minimum capacity of 202 racks per hour.

Model- Conveyor Dishwasher-

CL44 - BAS

Silver

Standard Features:

Machine to be furnished with

Complete Delime™ with Delime Notification, Auto Dispensing and Booster Guard™; which notifies the operator when to delime, then automatically

State of Florida

DEPARTMENT OF VETERANS’ AFFAIRS

Office of the Executive Director 11351 Ulmerton Road, #335

Largo, FL 33778-1630

(727) 518-3202 www.FloridaVets.org

Ron DeSantis Governor

Ashley Moody Attorney General

Jimmy Patronis Chief Financial Officer

Wilton Simpson Commissioner of Agriculture

James S. Hartsell Executive Director doses delime chemical and delimes the machine, including the energy recovery coil and booster heater.

Control activated NSF certified Pot & Pan mode.

Capless wash arms for easy cleaning.

Hobart Service diagnostic connection for fast trouble shooting.

Configurable Energy saver mode.

Full touch display to provide simple and intuitive operation for easy training, with integrated diagnostics and troubleshooting to minimize downtime.

Wi-fi connection with Hobart SmartConnect app provides machine status, temperature logs, error code with trouble shooting, energy cost, consumption, and usage analysis.

Tank Heat & Booster Heat:

(Electric Tank Heat) Machine to include 15 kW electric immersion heater controlled by solid-state thermostat with positive low water protection.

(Internal Booster) Internal, atmospheric stainless steel, pre-wired and pre-plumbed 18kW booster heater for 110-degree incoming water. (field convertible to 12kW for 140-degree incoming water)

Booster heater: yes

Other Features:

Equipped with anti-jam protection, including an electronic sensor to monitor the conveyor drive output RPM. In case of RPM change, the machine should shut off automatically.

Dual side pawl conveyor driven by a 1/6 HP motor to ensure simultaneous and even rack movement.

Double-wall insulated hinged doors.

Slanted, self-locating one-piece scrap screen and a deep soil collection basket.

Tank and chamber constructed of #16-gauge stainless steel.

2 HP wash pump motor with inherent overload protection and manual reset.

Stainless steel, self-draining pump and impeller mounted above the water line for longer life.

Pumped rinse provides consistent rinse performance in continuous operating condition without pressure regulating valve for incoming water pressure less than 65 PSI.

Single-point electrical connection including the electric booster heater. (field convertible to dual point electrical connection)

Dish machine to be provided with 0.5 hp final rinse pump.

Integrated stainless steel pump intake screen.

Electrical interface points for easy chemical pump connections.

Maintenance and Service:

Free Factory Start up.

6 months of extended warranty when Hobart Service completes installation.

High Temperature Rack Conveyor 202 Wash Tank 23

Conveyor speed 5.6

Motor Horsepower 1/6 Wash 2 Final rinse 2/3

Water consumption per hour 90 Per rack 0.45 Peak Drain flow (U.S) per minute) 38

Heating Tank Heal, Electric (kw) 15 Electric Booster (built in) (kw for 70 18 degrees F rise

Electric Booster (field conversion0(kw for 40 degrees F rise 12 Venting Load end (minimum CFM) 200 Unload End (minimum CFM) 400

Shipping Weight (approximate) 600 lbs.

Crated Dimension 53” L x 38” W x79”H

Failure to file a protest within the time prescribed in Section 120.57(3), Florida Statutes, or failure to post the bond or other security required by law within the time allowed for filing a bond shall constitute a waiver of proceedings under Chapter 120, Florida Statutes. Any protest concerning this FDVA decision must be timely received by FDVA Agency Clerk at: Florida Department of Veterans’ Affairs, Office of the General Counsel - Agency Clerk, The Capitol, Suite 2105, 400 South Monroe Street, Tallahassee, Florida 32399- 0001.

REMINDER: Make sure to fully execute and include Solicitation No. FDVA-ITB-25-001B Form “4” Addendum Acknowledgment with complete bid package submission. Failure to do so may result in respondent bid being considered nonresponsive.

Solicitation No. FDVA-ITB-25-001B is revised to the extent specifically amended by this Addendum.

Otherwise, all other terms, conditions, and provisions of Solicitation No. FDVA-ITB-25-015B remain in full force and effect.

As specified in Solicitation No. FDVA-ITB-25-001B, Respondents bids shall be delivered:

PRIOR TO:

3:00 PM (local time), on Thursday, October 3, 2024.

TO:

Jo Ann Snyder Purchasing Specialist Florida Department of Veterans’ Affairs Mary Grizzle State Office Building 11351 Ulmerton Road, Suite 335 Largo, FL 33778-1630

Sincerely, Jo Ann Snyder Purchasing Specialist Florida Department of Veterans' Affairs