HC101325QA095-0002.v0.pdf

IQO INQUIRY

FM: PL8211

TO: Contractors

DATE (MM/DD/YYYY): 12/10/2024

SUBJECT: HC101325QA095-0002 Amend: 0002

A. TYPE ACTION: ADMIN AMEND

1. PURPOSE: THE PURPOSE OF AMEND 0002 IS TO:

1. CORRECT ROOM # FOR THE 4141 COLONEL GLENN HWY BEAVERCREEK, OH LOCATION:

ROOM IS 121, SUITE 115, VICE ROOM 100

2. 4141 COLONEL GLENN HWY BEAVERCREEK, OH SITE IS LOCATED IN A COMMERCIAL

OFFICE BUILDING, IT IS NOT ON A GOVERNMENT BASE.

3. ADD LORENE DANIELS AS THE PERSON TO APPROVE TEST RESULTS

4. UPDATE THE DISA COMMERCIAL ACTIVATION TEAM EMAIL TO: disa.dscc.peo-transport.mbx.dcp-commercial-activation@mail.mil

ALL ELSE REMAINS THE SAME

THE PURPOSE OF AMEND 0001 IS AS FOLLOWS:

1. ADD DITCO ADDITIONAL TELECOMMUNICATIONS TEXT - 22

2. DELETE DITCO ADDITIONAL TELECOMMUNICATIONS TEXT - 23

3. EXTEND QUOTE DUE DATE TO 30 DEC 2024

ALL ELSE REMAINS THE SAME

1. SUBMIT A QUOTE TO PROVIDE, INSTALL, AND MAINTAIN A 55 MB ETHERNET

SERVICE BETWEEN (BLDG) 4141, (ROOM) 121, SUITE 115, 4141 COLONEL GLENN HWY,

BEAVERCREEK, OH 45431, AND (BLDG) 10271, (ROOM) 128, 2721 SACRAMENTO STREET,

WRIGHT PATTERSON AFB, OH 45433-5061

- VENDOR MUST ALSO ADVISE CAT TEAM OF HANDOVER AT: disa.dscc.peo-transport.mbx.dcp-commercial-activation@mail.mil

**SEE UNIQUE INSTALLATION FACTORS AND TESTING REQUIREMENTS**

2. EACH CONTRACTOR IS RESPONSIBLE FOR READING AND COMPLYING WITH ALL

TECHNICAL ASPECTS OF THIS SOLICITATION, TO INCLUDE READING AND RESPONDING

TO ALL PROVISIONS, CLAUSES, AND DITCO TEXT, ATTACHMENTS LISTING SPECIFIC

TECHNICAL REQUIREMENTS, PRICE QUOTE REQUIREMENTS, AND REQUESTED SERVICE

HC101325QA095-0002

DATE. FAILURE TO READ AND ADHERE TO ANY PORTION OF THE INQUIRY SHALL RENDER

THE QUOTE NON-COMPLIANT AND RESULT IN IT BEING EXCLUDED FROM EVALUATION AND

AWARD.

3. THE SERVICE DATE TO BE MET IS: 21 APR 2025 (SIP). THE GOVERNMENT ASSUMES THAT

CONTRACTORS HAVE CONSIDERED ALL ISSUES THAT MAY IMPACT THE SERVICE DATE.

THE GOVERNMENT MAY CANCEL, TERMINATE, OR REQUEST CONSIDERATION IAW DITCO

ADDITIONAL TELECOMMUNICATIONS TEXT 42 FOR FAILURE TO MEET CONTRACTUAL

SERVICE DATE OR COMPLY WITH ANY CONTRACT TERMS OR CONDITIONS.

4. CONTRACTORS SHALL SUBMIT QUOTES IAW DITCO ADDITIONAL TELECOMMUNICATIONS

TEXT 04. IN RESPONSE TO THIS SOLICITATION, NO TERMS OR CONDITIONS PLACED

UPON THE GOVERNMENT, NOR ASSUMPTIONS WILL BE ACCEPTED. CONTRACTORS

ARE ENCOURAGED TO SUBMIT QUESTIONS AND REQUEST CLARIFICATION OF THE

REQUIREMENT(S) BEFORE SUBMITTING QUOTES. QUESTIONS SHALL BE SUBMITTED TO

CONTRACT SPECIALIST AND CONTRACTING OFFICER DURING THE SOLICITATION PHASE

ONLY, AND RESPONSES FOR ALL INTERESTED PARTIES WILL BE POSTED TO SAM.GOV

5. TSP: TSP0K63HC-02

6. QUOTES MUST BE UPLOADED TO IDEAS.

7. FAILURE TO READ AND ADHERE TO ANY PORTION OF THE SOLICITATION SHALL RENDER

THE QUOTE NON-COMPLIANT AND RESULT IN IT BEING EXCLUDED FROM EVALUATION AND

AWARD.

M. ADDITIONAL INFORMATION:

3. TSR NUMBER: SI03OCT246693A

4. CCSD: NPNG7VDM

Z. DITCO CONTACT:

Donna Voss

667-890-4827

DONNA.M.VOSS7.CIV@MAIL.MIL

Dale L. Rupright

DITCO Contracting Officer

Unless otherwise specified, all other terms and conditions are unchanged.

Paragraph M.10.TESTING REQUIREMENTS change from:

CONUS NO JUMBO FRAME ETHERNET

VENDOR WILL PERFORM ACCEPTANCE TESTING IN ACCORDANCE WITH EITHER RFC-6815 OR ITU-T Y.1564.

VENDOR MUST TEST THE CIRCUIT FOR 24 HOURS IAW ITU-T.Y.1564 SPECIFICALLY, FRAME SIZES OF

64,128,256,512,1024,1280 AND 1518 BYTES MUST BE USED. THE TEST MUST VERIFY LENGTH OF RECEIVED FRAMES, INDICATE NUMBER OF FRAMES DROPPED, NUMBER OF FRAMES RECEIVED OUT OF ORDER, AND DUPLICATE

FRAMES. TESTS MUST BE BI-DIRECTIONAL USING THE SAME DATA RATE IN EACH DIRECTION. BURST TESTS

MUST BE RUN TO DETERMINE MINIMUM INTERVAL BETWEEN FRAMES THAT CAN BE PROCESSED WITHOUT FRAME

LOSS. A THROUGHPUT TEST IS REQUIRED INDICATING THE FASTEST RATE AT WHICH TEST FRAMES CAN BE

TRANSMITTED WITHOUT FRAME LOSS. A SEPARATE THROUGHPUT TEST MUST BE RUN WITH FRAMES ADDRESSED

TO THE HARDWARE BROADCAST ADDRESS CONSTITUTING AT LEAST 1% OF THE TEST STREAM AND BE EVENLY

DISTRIBUTED THROUGHOUT THE TEST. A LATENCY TEST MUST BE RUN FOR A PERIOD OF NO LESS THAN 120

SECONDS, AND REPEATED NO LESS THAT 20 TIMES. THE TEST STREAM FOR THE LATENCY TEST SHOULD BE RUN

AT THE THROUGHPUT RATE FOR CORRESPONDING FRAME SIZES FROM THE THROUGHPUT TEST. END TO END

LATENCY WILL BE CALCULATED AS THE AVERAGE OVER THE 20 TEST RUNS. FRAME LOSS RATE TESTS SHOULD

BE RUN AT THE FRAME RATE CORRESPONDING TO THE MAXIMUM FRAME RATE AND REDUCED BY 10% INTERVALS

UNTIL THERE ARE AT LEAST TWO CONSECUTIVE RUNS IN WHICH NO FRAMES ARE LOST.THROUGHPUT TEST

RESULTS: PASSING RATE 100% FOR ALL FRAME BYTE SIZES EXERCISED. FRAME LOSS RATE (%) RESULTS: FRAME

LOSS RATE LESS THAN 0.01% FOR ALL FRAME BYTE SIZES EXERCISED.

LATENCY WILL BE MEASURED WILL BE ACCORDING TO THE FOLLOWING MAXIMUM TRANSMISSION DELAY FOR

ANY CIRCUIT UP TO 500 MILES AIR-MILES IN LENGTH SHALL BE NO GREATER THAN 13MS ONE-WAY AND ANY

POINT-TO-POINT CIRCUIT LONGER THAN 500 AIR-MILES SHALL BE NO GREATER THAN 50MS ONE WAY WITHIN THE

48 CONTINENTAL STATES. ANY APS SWITCHOVER SHALL TAKE LESS THAN 50 MILLISECONDS MONTHLY

AVAILABILITY SHALL BE NO LESS THAN 99.5%.

To:

CONUS NO JUMBO FRAME ETHERNET

VENDOR WILL PERFORM ACCEPTANCE TESTING IN ACCORDANCE WITH EITHER RFC-6815 OR ITU-T Y.1564.

VENDOR MUST TEST THE CIRCUIT FOR 24 HOURS IAW ITU-T.Y.1564 SPECIFICALLY, FRAME SIZES OF

64,128,256,512,1024,1280 AND 1518 BYTES MUST BE USED. THE TEST MUST VERIFY LENGTH OF RECEIVED FRAMES, INDICATE NUMBER OF FRAMES DROPPED, NUMBER OF FRAMES RECEIVED OUT OF ORDER, AND DUPLICATE

FRAMES. TESTS MUST BE BI-DIRECTIONAL USING THE SAME DATA RATE IN EACH DIRECTION. BURST TESTS MUST

BE RUN TO DETERMINE MINIMUM INTERVAL BETWEEN FRAMES THAT CAN BE PROCESSED WITHOUT FRAME LOSS.

A THROUGHPUT TEST IS REQUIRED INDICATING THE FASTEST RATE AT WHICH TEST FRAMES CAN BE

TRANSMITTED WITHOUT FRAME LOSS. A SEPARATE THROUGHPUT TEST MUST BE RUN WITH FRAMES ADDRESSED

TO THE HARDWARE BROADCAST ADDRESS CONSTITUTING AT LEAST 1% OF THE TEST STREAM AND BE EVENLY

DISTRIBUTED THROUGHOUT THE TEST. A LATENCY TEST MUST BE RUN FOR A PERIOD OF NO LESS THAN 120

SECONDS, AND REPEATED NO LESS THAT 20 TIMES. THE TEST STREAM FOR THE LATENCY TEST SHOULD BE RUN

AT THE THROUGHPUT RATE FOR CORRESPONDING FRAME SIZES FROM THE THROUGHPUT TEST. END TO END

LATENCY WILL BE CALCULATED AS THE AVERAGE OVER THE 20 TEST RUNS. FRAME LOSS RATE TESTS SHOULD

BE RUN AT THE FRAME RATE CORRESPONDING TO THE MAXIMUM FRAME RATE AND REDUCED BY 10% INTERVALS

UNTIL THERE ARE AT LEAST TWO CONSECUTIVE RUNS IN WHICH NO FRAMES ARE LOST.THROUGHPUT TEST

RESULTS: PASSING RATE 100% FOR ALL FRAME BYTE SIZES EXERCISED. FRAME LOSS RATE (%) RESULTS: FRAME

LOSS RATE LESS THAN 0.01% FOR ALL FRAME BYTE SIZES EXERCISED.

LATENCY WILL BE MEASURED WILL BE ACCORDING TO THE FOLLOWING MAXIMUM TRANSMISSION DELAY FOR

ANY CIRCUIT UP TO 500 MILES AIR-MILES IN LENGTH SHALL BE NO GREATER THAN 13MS ONE-WAY AND ANY

POINT-TO-POINT CIRCUIT LONGER THAN 500 AIR-MILES SHALL BE NO GREATER THAN 50MS ONE WAY WITHIN THE

48 CONTINENTAL STATES. ANY APS SWITCHOVER SHALL TAKE LESS THAN 50 MILLISECONDS MONTHLY

AVAILABILITY SHALL BE NO LESS THAN 99.5%.

THE PERSON RESPONSIBLE FOR APPROVING THE VENDOR TEST RESULTS IS LORENE DANIELS:

lorene.daniele.ctr@mda.mil 719-721-9155

Location A, LOCATION OF TERMINATION A change from:

ADDRESS: BLDG 41414141 COLONEL GLENN HWYBEAVERCREEK, OH 45431

ROOM: 100; 1ST FLR

LOCATION: BEAVRCRK

To:

ADDRESS: BLDG 41414141 COLONEL GLENN HWYBEAVERCREEK, OH 45431

ROOM: Room 121, Suite 115, 1ST FLR

LOCATION: BEAVRCRK

Location A, DEMARK change from:

(BLDG) 4141; (RM) 100

(FLR) 1ST

4141 COLONEL GLENN HWY

BEAVERCREEK, OH 45431

(BLDG) 4141; (RM) 121, Suite115

(FLR) 1ST

4141 COLONEL GLENN HWY

BEAVERCREEK, OH 45431

Location A, UNIQUE INSTALLATION FACTORS change from:

1. COMMERCIAL VENDOR MUST DELIVER A GIG-E INTERFACE, SM FIBER WITH LC TERMS, CONFIGURED FOR AUTO

NEGOTIATE AT THE CUSTOMER LOCATION.

2. SERVICE MUST BE TESTED IAW ITU-T Y.1564 TESTING STANDARD.

3. COMMERCIAL VENDOR MUST SHOW SITE POC THE INTERFACE PORT, PROPERLY TAGGED WITH LED ID AND

DISA CCSD. VENDOR MUST THEN OBTAIN SITE POCS SIGNATURE TO CONFIRM IMPLEMENTATION.

4. FOR LOCAL COMMUNICATIONS UNIT: THE LOCAL COMM UNIT WILL EXTEND SERVICE FROM THE COMMERCIAL

DEMARC TO THE SERVICE DELIVERY POINT (SDP).

-FOR CIRCUIT ACTIVATION ASSISTANCE CONTACT DCP COMMERCIAL ACTIVATION TEAM (CAT) AT D312-850-0820, C614-692-0820, ; HANDOVER AT: DISA.DSCC.IE.MBX.DCP-COMMERCIAL-ACTIVATION@MAIL.MIL.

-DISA REQUIRES THAT CIRCUIT VENDOR OBTAIN A SIGNATURE FROM A RESPONSIBLE SITE POC CERTIFYING

THAT THE VENDOR PROVIDED THE CONNECTIVITY AND THAT THE CIRCUIT IS PROPERLY TAGGED WITH CIRCUIT ID

AND TSR NUMBER OR CCSD.

5. FOR THE VENDOR: VENDOR WILL DELIVER SERVICE TO THE COMMERCIAL DEMARC IDENTIFIED IN THE

DOCUMENT.

1. COMMERCIAL VENDOR MUST DELIVER A GIG-E INTERFACE, SM FIBER WITH LC TERMS, CONFIGURED FOR AUTO

NEGOTIATE AT THE CUSTOMER LOCATION.

2. SERVICE MUST BE TESTED IAW ITU-T Y.1564 TESTING STANDARD.

3. COMMERCIAL VENDOR MUST SHOW SITE POC THE INTERFACE PORT, PROPERLY TAGGED WITH LED ID AND

DISA CCSD. VENDOR MUST THEN OBTAIN SITE POCS SIGNATURE TO CONFIRM IMPLEMENTATION.

4. FOR LOCAL COMMUNICATIONS UNIT: THE LOCAL COMM UNIT WILL EXTEND SERVICE FROM THE COMMERCIAL

DEMARC TO THE SERVICE DELIVERY POINT (SDP).

-FOR CIRCUIT INSTALLATION ASSISTANCE WITH THE COMMERCIAL LEASED PATH, CONTACT DCP COMMERCIAL

ACTIVATION TEAM (CAT) AT C614-692-0820 OR DISA.DSCC.PEO-TRANSPORT.MBX.DCP-COMMERCIAL-

ACTIVATION@MAIL.MIL

-DISA REQUIRES THAT CIRCUIT VENDOR OBTAIN A SIGNATURE FROM A RESPONSIBLE SITE POC CERTIFYING

5. FOR THE VENDOR: VENDOR WILL DELIVER SERVICE TO THE COMMERCIAL DEMARC IDENTIFIED IN THE

DOCUMENT.

Location B, UNIQUE INSTALLATION FACTORS change from:

1) FOR LOCAL COMMUNICATIONS UNIT: THE LOCAL COMM UNIT WILL EXTEND SERVICE FROM THE COMMERCIAL

DEMARC TO THE SERVICE DELIVERY POINT (SDP).

- FOR CIRCUIT ACTIVATION ASSISTANCE CONTACT DCP COMMERCIAL ACTIVATION TEAM (CAT) AT C614-692-0820/ disa.dscc.peo-transport.mbx.dcp-commercial-activation@mail.mil

- DISA REQUIRES THAT CIRCUIT VENDOR OBTAIN A SIGNATURE FROM A RESPONSIBLE SITE POC CERTIFYING

(2) FOR THE VENDOR: VENDOR WILL DELIVER SERVICE TO THE COMMERCIAL DEMARC IDENTIFIED IN THE

DOCUMENT