Glenair_Statement of Work_20230331.docx

Statement of Work Circular Connector, Micro Miniature Automotive Instrumentation Division, US Army Aberdeen Test Center (ATC)

1. Introduction: The contractor shall provide equipment necessary to support the ATC as defined in this Statement of Work (SOW). The fabrication of the equipment shall be conducted by the contractor to the specifications provided in the Technical Requirements document.

1.1 Background. The Automotive Instrumentation Division is responsible for the acquisition of engineering data during dynamic automotive operations to perform analysis of automotive performance and endurance of the system under test. To support the mission, the division requires cylindrical connectors with shrink boots and banding clamps, that interface the signal sources to the data recorder. The connectors being procured will provide the appropriate size, ease of use, electrical isolation and environmental resistance in order that the signals are properly interfaced from source to data acquisition system. The equipment must also meet the electrical and physical interfacing specifications to be integrated with existing data acquisition equipment at ATC.

Objective. The objective of this contract is to acquire multiple micro miniature circular connectors, shrink boots and banding clamps that meet all the following requirements of this Statement of Work.

1.2 The contractor must possess the intellectual property to perform the manufacture the micro miniature circular connectors to the specifications listed in the Technical Requirements document. The contractor shall manufacture all connectors, shrink boots and banding clamps with quantities stated in the Technical Requirements document.

2. Applicable Documents:

2.1 Technical Requirements document, Micro Miniature Circular Connectors, Shrink Boots and Band Clamps

3. Description of Services or Supplies:

Equipment manufacturer shall build, ship to ATC a total of two hundred twenty (220) micro miniature circular connectors in six different configurations and 300 connector assembly accessories. The connectors are specified to interface directly to the ATC developed automotive on-board instrumentation systems. The accessories shall physically interface with the connector hardware. The cylindrical connectors that interface the signal sources to the data acquisition systems required to record engineering data during testing. The connectors and accessories shall be fabricated to the meet or exceed the following specifications.

4. Requirements:

4.1 Item 001-003, Connector, Receptacle. Series 801 “Mighty Mouse” Receptacle, Part numbers: 801-010-02ZNU7-10PB Qty: 20 801-010-02ZNU13-37PA Qty: 40 801-010-02ZNU13-37SB Qty: 40

4.2 Items 004-006 Connector, Plug. Series 801 “Mighty Mouse”

Part numbers: 801-007-16ZNU7-10SB Qty: 20 801-007-16ZNU13-37SA Qty: 40 801-007-16ZNU13-37PB Qty: 60

4.3 Items 007-008 Shrink Boot, Straight, Series 80 “Mighty Mouse” Part numbers: 809S060-2 Qty: 30 809S060-4 Qty: 100

4.4 Item 009-010 Flat micro-band clamp for Series 80 “might Mouse” connector Part numbers: 600-057-1 Qty: 30 M85049/128-4 (600-052-1) Qty: 100

5. Delivery Information Delivery is expected 8 weeks after receipt of order.

Delivery will be made to Nathan Simmons, Engineer of the Automotive Instrumentation Division, Automotive Directorate.

Nathan Simmons, 6850 Lanyard Road, Bldg. 358, Aberdeen Proving Ground, MD 21005.

Deliveries are accepted from 0800 to 1500 Monday through Friday