Base Access and Building Locations.pdf

Overview maps for Kirtland AFB battery delivery

Contractor/delivery gate for accessing Kirtland Air Force Base operates Monday through Friday, 5:30 am to 3:00 pm MST Should the delivery be scheduled/running outside of these hours, access via the Truman gate can be performed. Truman gate access must be provided by a base sponsor at the Visitor’s Center located near the gate. Contact William Jennings by phone and/or email for meeting at the Visitor Center for sponsorship. Use of the Truman gate will also require inspection/ searching of the vehicle by base personnel before access is permitted.

Personnel performing delivery/installation on base require the following to be allowed access to the base:

• Bring/provide personal identification (example: driver’s license that is not expired)

• Have no outstanding warrants and/or be a felon

• Must be a citizen of the United States of America

Full overview of the area involved.

Points of interest have been circled and named.

Building 1010

Building 498

Entry Gate

Recommended route to 1010 from the delivery gate has been marked with red arrows.

Follow Hickman Ave SE from the entry gate, turn onto Lowery Ave heading east, and then onto Maxwell St SE heading north.

Turn onto Aberdeen Dr SE heading east, and finally turn onto Grace Ave SE heading south. Building 1010 will be at the end.

Building 1010

Entry Gate

Building 1010 in relation to building 498.

The recommended path from building 1010 to building 498 has been marked with red arrows. This path takes you to the parking lot of building 498, and the closest that one can get for a vehicle with the intent of loading/unloading materials.

Distance for the full route is estimated as roughly ft

Building 498

Building 1010

Pictures for building 498’s existing battery racks

Entryway clearance.

Estimate of 33 inches

Battery racks are composed of 24 cells.

3 cells per shelf. 8 shelves per rack.

Rack measurements (estimates) Height – 78 inches Width – 42 inches Depth – 25 inches

Each cell is estimated to weigh 150 lbs.

Clearance between battery rack and rectifier.

Estimate 34 inches

Location of battery/rectifier clearance measurement in the red circle.

Electrical Outlets and Inverter Location Electrical outlets and inverters are to be installed within the rooms west of the room containing the batteries.

Battery Room

Inverter & 7 Outlets

Inverter & 20 Outlets

Not to scale, distances are estimates

200 ft

85 ft

80 ft

30 ft