Revised Item Description.pdf

Item Description – Parts Washers

Two Power Washers will be used to clean jet engine parts prior to being repaired or machined. The power washers shall have the following features:

Dimensions shall be less than or equal to the following: Width – 110”, Depth – 96”, Height 120”

Minimum of 60” diameter turntable

Work height of at least 72”

Dual 70 hp Cast Iron Pump system capable of flowing a minimum of 400 gpm flow rate at a total system pressure of at least 170 psi

Pump and Cabinet Sound Insulation

Machine shall be closed loop, zero discharge

Machine shall have an attached Jib Boom with trolley, minimum 4000lbs capacity

Remote Grease Fittings to lubricate PBM Swivel and Turntable – All piping and fittings shall be stainless steel.

Machine shall operate on 460V, 60 Hz power supply

Machine shall operate on a steam heat source – 100 Psi Maximum

Machine shall include an automatic rinse cycle and auto steam exhaust – Pump/Venturi/Blower to be made of stainless steel.

Machine shall include Internal Reservoir Cover to protect operator from contact with hot wash solution

Machine shall include noise reducing insulation – Must meet OSHA Occupational Noise Exposure

Requirements (OSHA 29CFR 1910.95)

Machine shall include manual Pressure Adjustments – Variable Frequency Drive

Machine Wet areas shall be compatible with CeeBee Super Bee 300LF Cleaning Solution – All wetted components shall be made of stainless steel. All seals that contact solution shall be made of Viton.

Machine Pump shaft and seals shall be compatible with CeeBee Super Bee 300LF Cleaning Solution –

These items shall be made from stainless steel.

Machine Electrical System shall meet NFPA 79. All connection points to be covered with flexible conduit and water proof gaskets.

The machine shall not include the following options:

Rust Inhibitor Injector Pump

Auto Oil Skimmer

Shipment, Placement and Installation:

Contractor shall provide shipment of equipment to Tinker AFB. Government shall off load, transport, install, and connect equipment to facilities per contractor’s installation instructions. Government is responsible for site preparation, including removal of old equipment.

Start-up, Testing and Training:

The contractor shall start-up and test equipment to ensure it is operating within manufacturers design parameters.

The contractor shall provide at least 2 hours of operational and maintenance training to a maximum of 10 government personnel. Contractor shall provide maintenance and operating manuals for the parts washer machine.

Warranty:

The parts washer machine shall have a manufacturer’s warranty of at least 12 months, warranty period to begin upon completion of successful start-up and testing.