140217_-_Form_2519_-_Welding_ _Safety_Checklist.pdf

ALL PURPOSE CHECKLIST

PAGE 1 of 1 PAGES

TITLE / SUBJECT / AREA

UHHZ 140217

CONSTRUCT / INSTALL 1950 SF ADDITION, SHED SUP EQUIP DEP, B/20131

OPR

DATE

2-19-2016

WELDING & CUTTING SAFETY

References: a. AFISC/SE Msg 192000Z Dec 85, ALSAFECOM 001/1985 Welding & Cutting Safety

b. AFLC/ISC Msg 201830Z 0001/1985 Welding & Cutting Safety

c. 78 CEG/CEF Ltr 27 Jan 86, ALSFECOM 001/1985 Welding & Cutting Safety Message

ENGINEERING

1. Has the project been reviewed to insure that the cutting, welding or brazing required or allowed in the project is necessary for technical or economical reasons in lieu of a safe method? YES X NA ____

Signatures: 2-19-2016

2. Are specific required precautions that are over and above those required by the General Requirements (Section 1A) and by the U.S. Army Corps of Engineers Safety and Health Requirements Manual (EM 385-1-1) adequately covered in the design documents? YES NA X_____

3. Are requirements for welder testing or certification specified in the project documents? YES X NA _____

4. Have all Safety, Health and Fire comments been satisfactorily addressed? Have they signed the project drawings when required?

YES X_____ NA _________

CONSTRUCTION MANAGEMENT

5. Have specified and general precautions for cutting and welding safety been covered at the preconstruction conference?

YES NA _________

Signatures:

6. Is the contractor's welder properly certified and knowledgeable of the materials and facility hazards involved in his work?

YES NA __________

7. For any change in the contract that involves cutting or welding, has it been coordinated with the project engineer and all necessary Safety, Health of Fire agencies?

8. Was fire prevention inspection performed by the welding permit issuing authority (CEF) at the job site? Is all required protective equipment in place?

ON-SITE SUPERVISOR

9. Are you, the on-site Air Force and/or contractor supervisor, fully aware of fire safety prevention requirements? If the on-site supervisor is a replacement or was not in attendance at the preconstruction conference, has he been briefed on fire prevention and safety requirements prior to welding or cutting?

AF FORM 2519 - Alternate 10 Jun 2002