Conveyer_dishwasher_SOW.pdf

STATEMENT OF WORK

FOR

PURCHASE AND INSTALLATION OF NEW CONVEYOR DISHWASHER

Purpose: To purchase, remove existing and have installed a new conveyor dishwasher and food waste disposer inside Building 195, Gunfighters Club, located on Mountain Home Air Force

Base, Idaho.

Specifically we request:

1 - DISHWASHER, CONVEYOR-TYPE – Hobart Model No. CLC86E+Buildup

Conveyor Dishwasher, two tank with a corner scrapper, 342 rack/hours, insulated hinged doors, .39 gallon/rack, stainless steel enclosure panels, with low temperature & dirty water indicators, with Energy Star rating. It should come with a 1-year warranty for parts, labor, and travel time during normal working hours.

Dishwasher should include the below items:

Should run on 208 volt, 60 amp three phase power

CLCS86E – ELEOAX 208/60/3

Should have a heated water tank that runs on 15kw

CLCS86E – HTE15K Electric tank heater 15kw

CLCS86E – CTROTH

Should have a 30KW electric booster heater

CLCS86E – 30kw electric booster

Should be right to left operating

CLCS86E – DIR0LR Left to Right Operation

CLCS86E – HGTSTD Standard Height

CLCS86E – FETSD Standard Feet

Should have a Stainless steel vent hood

VNTHE/E – DOM E-series vent hood domestic

CLE/TBL – SWITCH Table LMT switch CLE-Series

VENTSTK – DAMPER Vent Stack damper kit

1 - DISPOSER - Hobart Model No. FD4/125+BUILDUP Disposer, basic unit only, 1-1/4 HP motor, aluminum housings, no feet. It should come with a standard warranty for parts, labor & travel time during normal working hours

Should run on 208 volt, 60 amp three phase power

FD4/125-ELEOKT 208-240/480/60/3 & 220-240/380-415/50/3

CONTROL-GRPGOKP Control Panel Group 6, 200-240v/50/3-ph & 200-240/440-

480v/60/3-ph

FD4/125-HSGSHT Short upper housing

BREAKER·VACUUM Vacuum breaker 3/4"

Scope of work for removal of the existing dishwasher and garbage disposal to consist of the following:

-Secure all utilities, and disconnect from existing dish-machine, and garbage disposal.

-Disconnect existing duct work from machine.

-Remove existing soil table and set aside. Existing table to be reinstalled.

- Remove existing dine dish-machine to back dock. (Formal Disposal to be done by others/Gov't

Agency).

-Remove and dispose of existing garbage disposal, and controls.

Scope of work for the installation of new dishwasher and garbage disposal to consist of the following:

-Uncrate, set in place and level new Hobart CLCS86E dine dish machine with built-in 30 kw booster.

- Install existing soil table to new dish-machine.

-Modify as needed existing exhaust ducting to accommodate new dish-machine.

-Provide and install new water line plumbing from existing shut offs with-in the room to new dish-machine.

-Provide and install drain line from new dish-machine to existing floor drain.

-Provide and install new 90 amp electrical circuit from existing electrical panel to new built-in booster heater. (Booster heater located in machine)

-Hook-up all final electrical connections to new dish-machine.

-Uncrate and install new Hobart garbage disposal with new electronic control group on existing soil table.

-Provide and install new water line plumbing from existing shut offs with-in the room to new garbage disposal and existing soil table.

-Start-up and operation check.