SOW.pdf

NOAA Ship Okeanos Explorer June 2013

Starboard Crane Remote Control Installation

1 Work Description – Provide all labor, material and equipment to install a wireless remote control system on the starboard crane.

2 References

(a) NOAA Standard Specification AMC-000-3C, General Requirements for Contract Ship Repairs

(b) Owners Manual, Hydra-Pro, Inc., Model HP46-18KE

3 Government Furnished Equipment

3.1 None

4 Work Requirements

4.1 Reference (a) forms a part of these Detail Specifications. All provisions and requirements contained therein are applicable to all work items, including all additional work items which are authorized by the Contracting Officer.

4.2 All work is scheduled to be performed at 2578 Davisville Road, North Kingston, RI – Pier 1.

4.3 In conjunction with Ship’s Force, follow ship’s Lockout and Tagout Procedures to secure the starboard crane.

4.4 Provide, install and program the following material and equipment, using a Rapp Hydra Pro certified service engineer / technician, on the ships starboard crane using Reference (b) as a guide:

4.4.1 New wireless transmitter and receiver.

4.4.2 Two rechargeable battery packs with 120 VAC, 60 HZ charger.

4.4.3 Power converter for the receiver with NEMA 4X housing, 120 VAC to 24 VDC. A 120v power source is located to the right of the current control station to provide the necessary electricity needed to operate the control actuators. Contractor will tap into the junction box on the right side of the control station to connect power to the system and will use weatherproof connectors at all junction box penetrations.

4.4.4 New control valve with electronic actuators and manual handles to replace the existing control valve and is compatible with the new transmitter and receiver.

NOAA Ship Okeanos Explorer June 2013

4.4.5 Modify the existing hydraulic lines, as necessary, to hook up the new control valve with electronic proportional actuators. All non stainless steel hydraulic connections will be wrapped with cloth impregnated anti-corrosion grease tape. The grease tape shall not be installed until all equipment has been tested to allow visual inspection for leaks.

4.5 Follow ship’s lockout / tagout procedures to re-energize all secured equipment. Test each piece of equipment to ensure it is working properly.

5 Quality Assurance

5.1 Ship’s force will perform an operational test of the crane utilizing the remote operator and manual controls to ensure proper operation. Check for leaks during the operational test.

Repair all leaks, if any.

6 Notes

6.1 The crane information is as follows:

Manufacturer: Hydra-Pro, Inc.

Model Number: HP46-18KE-6600 Serial Number: 06062

6.2 All delivery employees will need to provide a picture ID preferably a Transportation Workers Identification Credential (TWIC). Vendor will provide a “Pro” or “Tracking” number when the shipment departs their facility as well as contact information for the delivering carrier.

This requirement is for Gate Access at this Davisville / Quonset Facility.

END OF SPECIFICATION