DOS - Corrosion Prevention Control - FY20 - FINAL.pdf

DESCRIPTION OF SERVICE

FOR

VEHICLE CORROSION PREVENTION AND CONTROL

SELFRIDGE AIR NATIONAL GUARD BASE, MICHIGAN (SANGB)

1. Description of Service:

1.1. Perform corrosion prevention and control measures on 25 vehicles and vehicular equipment listed in

Technical Exhibit 1. Services shall be performed at Contractor’s facilities. Contractor must be located within 25 miles of SANGB, MI. Government employees will transport all vehicles to and from the contractor’s location.

1.1.1. The contractor shall identify and perform corrosion prevention and control measures that restore the vehicles listed in Technical Exhibit 1 to a condition designed to; prevent significant vehicle deterioration under existing usage environments at SANGB, enhance safety, and extend vehicle service life. The measures detailed in Technical Exhibit 1 are not a definitive list of actions to be taken, only an estimate of the work that may be required.

1.2. Minimum technical requirements:

1.2.1. The contractor shall replace the corroded section of a body component with an industry standard metal using a cut and weld method, or replace the entire component. Automotive body fillers shall not be used as the primary corrosion repair action, but may be used to cosmetically prepare the repaired surface for painting.

1.2.2. All paints, primers and coatings shall be applied in accordance with manufacturer’s recommendations for paint, primers and coatings.

1.2.3. Paint shall be blended using current blending technology, and blended areas shall match surrounding painted surfaces.

1.2.4. The contractor shall ensure all removed and replaced hardware is corrosion protected if originally provided corrosion protection by the original equipment manufacturer.

1.2.5. The contractor shall ensure the vehicular equipment shows no evidence of overspray from contractor applied paint, rustproofing compound, or undercoating compound.

1.3. Vehicle scheduling shall be coordinated with the Government POC.

1.4. Unless otherwise coordinated with the Government POC, the contractor shall complete services within twenty-one (21) days of vehicle delivery.

1.5. Contractor shall coordinate with government POC, the pick-up of completed vehicles. The Government will inspect all completed vehicles prior to leaving Contractor’s facility.

2. General

2.1. Physical Security. The contractor shall ensure all government equipment and materials in their possession are secured.

2.2. Safety/Environmental: The contractor shall comply with all federal and state Occupational Safety and

Health Administration (OSHA) requirements and standards, technical orders, regulations, and referenced publications as published in the OSHA 29 CFR.

3. Government Furnished Property, Material, Equipment and Services (GFP/M/E/S): The Government will provide the 14 vehicles identified in attached Exhibit.

4. Contractor Manpower Reporting Application (CMRA):

4.1. The contractor shall report ALL contractor labor hours (including subcontractor labor hours) required for performance of services provided under this contract for the Air Force via a secure data collection site.

4.2. The contractor shall completely fill in all required data fields using the following web address:

http://www.ecmra.mil/. Reporting inputs shall be for the labor executed during the period of performance during each Government fiscal year (FY), which runs October 1 through September 30. While inputs may be reported any time during the FY, all data shall be reported no later than October 31 of each calendar year, beginning with 2013. Contractors may direct questions to the help desk at http://www.ecmra.mil.

UIC Code: FFKNTO Issuing Office DoDAAC: W50S85

TECHNICAL EXHIBIT 1

Estimated Workload Data

This estimate is not a definitive list of actions to be taken, only an estimate of the work that may be required.

See document attached “Vehicle List Final 2020”