DIP Parts list.pdf

1.

2.

3.

2. DIP Controller Setup Types For guidance on the DIP virtual sensor see the v3.7 Virtual DIP Installation Guide. A fully virtual kit setup will require a Deviation Request as this capability has not been through a Capstone event.

There are a number of ways to set up a Deployable Interceptor Platform (DIP) Kit. A physical DIP kit is defined as all hardware for both sensors and servers. A fully virtual setup is defined as all nodes (servers/sensors) being set up as VMs. A hybrid kit can be defined as a hardware kit with one to many remote sensors deployed as VMs. (Note: There is nothing that prevents the provisioning of more virtual servers, but it is not supported per our documentation.) For each setup type follow the below instructions:

Physical Kit Setup - To set up a physical kit follow all instructions notated in this guide.

Optional steps referring to setting up a virtual sensor may be skipped unless setting up a hybrid kit.

Fully Virtual Setup - For a fully virtual kit setup refer to the . A switch setup is not required as everything will be v3.7 Virtual DIP Installation Guide set up in either ESXi or VCenter setup. (NOTE: the operator may optionally import the ACAS and Windows Server VM as well in section 9) Hybrid Kit Setup - To set up a hybrid kit follow all instructions notated in this guide.

Return to Top

3. DIP R440 Physical Setup This section aims to provide a general overview for configuring the Deployable Interceptor Platform (DIP) kit before deployment. This section will establish the key points in narrative form, which are needed to ensure a smooth transition of the kit to an operational state when deployed. The objective is for operators to take a prepared kit to a remote location and be operational within thirty minutes of entering the facility. The recommendation is to read through this section to gain a general and holistic understanding of the DIP, and then use the step-by-step guided sections as checklists for each stage in the process. This section explains why there is a need to configure the DIP and the supplemental sections provide how to configure the DIP.

Cables and other required accessories are the responsibility of the Unit.

Standard DIP Issue

Image Standard DIP Includes the Following: Part Number QTY

Dell R440 with CVA/H Identity Module and branded bezel/face plate (16C/32T, Dual Processor; 512 GB RAM; (10)2.4 TB 10k SAS Hard Drives)

210-ANKU 7

S4112 Switch 210-AOYZ 1

PDU (APC or Tripp Lite PDU Basic Dual Volt 100V-240V) A5056811 7

Transit Case (case per server + Switch) AA759571 7

Accessory Case AA755745 1

Optics and Cables for Kit

OM4 MPO to 4xLC Optical Breakout,7 Meter (Optics required) 470-ABPK 2

QSFP+ 40Gb Active Fiber Direct Attach, 10m 470-ABPI

( 470-AAZM)

OM4 MPO Crossover Fiber Cable (Optics required), 10 Meter 470-ABPV 4

OM4 LC/LC Fiber Patch Cable 10 Meter 470-ACMN 4

OM4 MPO Crossover Fiber Cable (Optics required), 10 Meter 1

SFP 1000Base-T, 1GbE (SFP to RJ45) 407-BBOS 12

SFP28+ SR-No FEC Optic, 25GbE 407-BBXU 1

QSFP+ SR4 Optic, 40GbE 2

QSFP28,100GE Optic, SR4-NOF, Duplex LC 407-BBWV 1