Compliance with Trade Agreements.pdf

Valves are subject to Trade Agreements, per DFARS 225.401-70, so all line items associated with this requirement are subject to Trade Agreements.

Please complete the table in section (c), subparagraph (2) below, if applicable. If no line items are identified within the table, this will imply that the valves quoted by the vendor are from a

“designated country end product”, “qualifying country end product,” or “U.S.-made end product”, as defined in DFARS 252.225-7021, Trade Agreements.

TRADE AGREEMENTS CERTIFICATE—BASIC (NOV 2014)

(a) Definitions. “Designated country end product,” “nondesignated country end product,”

“qualifying country end product,” and “U.S.-made end product” as used in this provision have the meanings given in the Trade Agreements—Basic clause of this solicitation.

(b) Evaluation. The Government—

(1) Will evaluate offers in accordance with the policies and procedures of Part 225 of the

Defense Federal Acquisition Regulation Supplement; and

(2) Will consider only offers of end products that are U.S.-made, qualifying country, or designated country end products unless—

(i) There are no offers of such end products;

(ii) The offers of such end products are insufficient to fulfill the Government’s requirements; or

(iii) A national interest waiver has been granted.

(c) Certification and identification of country of origin.

(1) For all line items subject to the Trade Agreements—Basic clause of this solicitation, the offeror certifies that each end product to be delivered under this contract, except those listed in paragraph (c)(2) of this provision, is a U.S.-made, qualifying country, or designated country end product.

(2) The following supplies are other nondesignated country end products:

Line Item Number Country of Origin

(End of provision)