CED-Heated holding cabinets.pdf

INITIATED

05/16/16

CED

DELICATESSEN

DEPARTMENT

Minimal Acceptable Standards

REVISION

07/28/21

1D11 Cabinet, heated, holding PAGE 1 of 2

FY16r.01

1 Purpose of this Equipment: To hold pre-cooked or pre-warmed foods within a proper temperature range prior to serving. This unit is not designed to cook foods.

2 Federal Supply Class: 7310

3 General Operating Specifications:

3.1 Dimensions:

3.1.1 Dimensional sizes not to exceed 26 inches long / wide, 38 inches deep, 77 inches high.

3.2 Salient Characteristics that shall be provided:

3.2.1 Stainless steel exterior and interior.

3.2.2 Thermostat heat control – must be able to maintain temperatures between

90 and 210 degrees Fahrenheit.

3.2.3 Adjustable humidity.

3.2.4 Right or left hinged door capability.

3.2.5 Four casters, two locking.

3.2.6 Accommodates a minimum of (12) ea. - 18 x 26 inch pans.

3.3 Industry Standards / Requirement(s):

3.3.1 Industry Standards: Underwriters Laboratory (UL) listed and National

Sanitation Foundation (NSF) certification, or approved equivalent.

3.3.2 Warranty period shall be for (1) year from date of delivery/installation against defective material and workmanship and shall include parts, service and labor.

3.4 Information Technology requirements: N / A

3.5 Color Requirement(s): N / A

4 Electrical Requirements:

INITIATED

05/16/16

CED

DELICATESSEN

DEPARTMENT

Minimal Acceptable Standards

REVISION

07/28/21

1D11 Cabinet, heated, holding PAGE 2 of 2

FY16r.01

4.1 Standard U.S.A. electrical specifications: 120 volts, 60 Hertz, 1 phase.

4.2 _____ Pacific Theater stores 120 V / 50 HZ / 1 PH (Applies to these stores only:

Atsugi, Misawa, Sagami, Sagamihara, Yokosuka, Yokota, Camp Zama, and Kanto Plains CDC. All other stores are standard U.S.A. 60 cycle voltages.)

4.3 Minimum 6 foot cord with a NEMA Standard plug, or a manufacturer’s equivalent to comply with the equipment plug in requirements.

4.4 NOTE: the operating range for 120 volts is 110 to 120 volts; the operating range for 220 volts is 208 to 230 volts.

5 Standard Contractor Requirements:

5.1 Must be shipped ready to plug in, and use

5.2 Information to be provided by the Contractor to the commissary at the time of delivery:

5.2.1 Point of Contact for Service

5.2.2 Installation and Operating Instructions

5.2.3 Parts List

5.3 Maintenance Sustainability Requirements: Continued parts support is required for the projected life cycle of the equipment plus 5 years.

6 Special Coordinating / Safety Instructions: N / A