B.08 Attachment 1 Boat Specifications.pdf

Boat specifications:

Boat design: Catamaran Hull Landing Craft

Hull length: 26 feet

Hull Material: ¼ inch aluminum - minimum

Beam: 8 feet 6 inches

Propulsion: Twin 150hp four stroke outboards

Bow Door Opening: 64 inch minimum

Hull shall include at least 2 structural bulkheads with the forward compartment being watertight. Inspection hatches shall be included.

6 welded cleats (3 per side) shall be included.

1 ¼ inch pipe railings shall be installed at 32 inches above main deck from stern to midship.

Two beaching wear plates shall be installed on the fore bow.

Two 26-inch side doors shall be installed (1 each side) Doors shall swing inboard and forward and lock in closed position.

4 scuppers shall be installed flush with the main deck in accordance with ABYC deck drainage requirements.

Lifting padeyes shall be installed in the hull.

3-inch D-rubber push knees shall be installed on each side of the bow.

Push knees shall be ¼ inch double wall plate and extend to near the waterline.

Storage shelves shall be installed into the gunnel along both sides.

Storage lockers shall be installed on each side of the bow door.

The bow door shall incorporate a manual winch for raising and lowering. Door shall lock in the closed position and include a watertight seal.

Dual aluminum fuel tanks shall be installed with sending units to a fuel gauge on the dash and two fuel/water separators with shut off valves.

A 12-volt air blower shall be installed in the fuel compartment.

A 52-inch T-top console shall be installed aft of the centerline with a 60 inch by 120-inch roof.

T-top includes four windows with aft leaning windshields.

Roof shall include pipe railings and vertical grab rails on each side.

A padded two person leaning post shall be installed at the operator console.

One exterior seat locker shall be installed forward of the operator’s console.

Two removable seat lockers installed along gunnel (one each side)

Install a pipe davit rated at minimum of 500 pounds. Approximately 80 inches high and 42-inch reach. Rotate 360 degrees and lockable every 90 degrees. Include a 12-volt Capstan with foot controls and a minimum 300 load rating.

Install a crucifix style towing bit.

Incorporate a tow line guard into the motor guard.

Install a towline protection screen forward of the tow bit.

Include a removable side door dive ladder and storage.

Install an onboard fire fighting pump with through hull suction fitting and isolation valve. Minimum of 100 GPM at 100 PSI.

Include all standard safety equipment in accordance with USCG and

ABYC.

Include trailer to meet all requirements of transporting this vessel.

Ship to Lowell Oregon.

Include operating and maintenance manual, two complete sets of keys and manufacturers Statement of Origin document.