Attch 2 Specifications.pdf

31 March 2021

(15” DISC STYLE) BRUSH CHIPPER SPECIFICATIONS

- Caterpillar C3.4, 120 horsepower engine without clutch - Tier 4 FINAL (Includes 2 year / 2,000 hour engine warranty)

- 45• diameter x 2" thick (2 knife pocket) chipper disc, each pocket equipped with (2) 1/2" x 4 1/T x 8 1513T dual edge knives.

- 40 gallon steel fuel tank with magnetic drain plug, lockable filler cap, and aluminum sight gauge

- 13 gallon steel hydraulic tank with magnetic drain plug, lockable filler cap, and sight gauge

- Slide box feed system (includes adjustable spring on each side) with (2) horizontal feed wheels 10 5/8" diameter x 241/2" wide, driven by (2) 32.3 CID hydraulic motors.

- Hydraulic lift cylinder - utilizes a hydraulic cylinder to raise or provide down pressure for the top feed wheel (controlled via a handle located on either side of the infeed hopper)

- Bottom feed wheel clean out door (opens via spring latch pin allowing dirt and debris to fall out extending knife and component life)

- Clean out and inspection door on discharge

- {2) Last chance safety pull cables

- Control bar - located around top and sides of infeed hopper with 3 control positions

(forward I neutral I reverse)

- Wooden pusher tool with mount on infeed hopper

- 3/8" {G70) safety chains with spring loaded latch hooks

- 8,000 pound capacity tongue jack with 15" of travel and foot pad

- 12 volt system with rubber mounted LED taillights, 6 prong replaceable coiled power cord

& protected heavy-duty wiring with junction box, and LED clearance lights with reflectors.

- Banded chipper drive belts (adjustable via a sliding engine system)

- Pressure check kit - Gauge is NOT included

- Standard lmron Industrial Urethane

- NACD Spring Loaded Clutch

- Standard drive system for engine horsepower options up to 145 horsepower

- 33 1/2" high x 64" wide tapered heavy-duty infeed with weld on pan and infeed deflectors

Dynamic winch with line docking station and manual push button feed assist (Includes 5/16" diameter x 200' Teufelberger rope) (Includes (1) manual rear stabilizer)

- Bolt-on shut-off switch for engine shut-down located on both sides of infeed hopper

- Double teeth for bottom feed wheel

- Hydraulic flow control for feed wheel rate adjustment (All-In-One

Mount)

- Radio remote control with tether back-up (Controls: feed forward I reverse, yoke up/ down, discharge swivel, discharge flipper up/ down (winch if ordered), throttle and engine a-stop) (MUST select hydraulic swivel discharge with hydraulic flipper option)- Tier 4 and gas engines only

- 2) 215/75R 17.5" tires mounted on 8-bolt heavy-duty gray rims {8,000 pound axles on up)