Attachment_F_-_OP_MANUAL_PICS_SEPT_1_2021.pdf

DEVA – DEVIL’S HOLE EXHIBIT – AUG 2021

The Devil’s Hole exhibit has two Brightsign media players (HD1034)

The left media player is connected to the front push button and feeds the Asus display mounted inside the exhibit.

The right media player is connected to the wall mounted TV. This media player plays on a continuous loop.

MEDIA PLAYERS

ATTACHMENT F

NORMALLY OFF

ALWAYS ON/

POWER FOR RELAY

ON/OFF SWITCH ON SIDE

OF EXHIBIT.

EXHIBIT HAS FOUR SCREWS THAT

RELEASES THE KIOSK FROM THE

WALL. THERE ARE TWO ON EACH

SIDE. ONCE THESE SCREWS ARE

OUT, THE BOTTOM OF THE KIOSK

LIFTS UP SLIGHTLY AND THEN WILL

COME OFF THE WALL.

DEVA – FLASH FLOOD EXHIBIT – AUG 2021

The Flash Flood exhibit plays as a continuous loop. (HD1034)

The media player is located at the projector. (Epson L2000sx)

The audio from the exhibit comes from the projector.

The projector is turned on and off with the manufacturer remote.

DEVA – GEOLOGY EXHIBIT – AUG 2021

The Geology exhibit is a single push button exhibit. It is played off of one Brightsign media player.

(HD1034)

The media player is located behind the TV.

The audio from the exhibit comes from the display.

The TV is to be turned on and off with the display’s remote.

A push button to play splash screen plays when the movie is not playing.

The button wiring travels from the button to the hidden panel. A screw terminal is located behind the hidden panel and then continues back behind the display where it is connected to the GPIO of the Brightsign.

The button

HIDDEN PANEL

DEVA - TIMBISHI EXHIBIT – AUG 2021

The Timbish exhibit has three buttons that controls the media player. (Brightsign HD1034)

The audio from this exhibit comes from the HDMI extracted audio from the Brightsign.

The power switch located on the side of the exhibit casing turns on and off the exhibit. The power supply for the power sequencer should be plugged into the always on outlet. Everything else needs to be plugged into the normally off outlet.

The Asus display only has a DVI input. The display automatically turns on when it sees a signal.

The audio amplifier is located inside the exhibit and the volume can be controlled from this location.

The speaker wire travels through the 119C data jack to the Data rack location in the rack room. The patch panel has a CAT cable coming out of the patch connection and is screw terminaled to the existing speaker wires. The speaker is located directly above the exhibit.

The kiosk has four screws on the side of the exhibit that attaches the casing to the wall. Once the screws are removed, slightly lifting up the kiosk will allow the unit to be removed from the wall.

VOLUME CONTROL

SPEAKER CONNECTION TO

RACK ROOM.

PATCH PANEL

IN RACK ROOM.

ON/OFF SWITCH ON SIDE

KIOSK COMESS OFF.

EQUIPMENT IS MOUNTED

TO BACK WALL.

DEVA - WEATHER EXHIBIT – AUG 2021

The Weather Exhibit runs as a constant loop. (Brightsign HD1034)

There is no audio for this exhibit.

The power switch located on the back of the exhibit casing turns on and off the exhibit. The power supply for the power sequencer should be plugged into the always on outlet. Everything else needs to be plugged into the normally off outlet.

The Asus display only has a DVI input. The display automatically turns on when it sees a signal.

ON/OFF SWITCH

MEDIA PLAYER

ON/OFF SWITCH ON BACK

BACK OF EXHIBIT

COMES OFF. EQUIPMENT

IS MOUNTED TO PANEL