Attachment 1 Statment of Work.pdf

Statement of Work (SOW) Vertical Blade Bandsaw (1) each.

Background:

a. Requiring Organization Defense Distribution Depot Hill UT (DDHU)

b. History Saws are required to replace outdated machines that are maintenance intensive and lack necessary safety equipment required to meet OSHA standards.

c. Purpose of the Statement of Work (SOW):

Purchase new Vertical Blade Bandsaw one (1) ea.

1. Scope of Work to be Performed by Contractor:

The contractor shall provide all necessary labor and material to construct, deliver and place into operation one (1) new vertical blade bandsaw with traveling table. All equipment furnished shall be new from the manufacturer’s most current production. The saw shall be in compliance with all OSHA, federal, state, and local codes and regulations and shall conform to the best quality of materials and workmanship. Accessories not specifically mentioned herein, but necessary to furnish complete systems ready for use, shall also be included and named. All transportation/shipping of the purchased saw shall be provided by the contractor. The contractor shall coordinate a Site Visit with the receiving location in order to ensure all necessary electrical and ventilation connections are in place prior to scheduling the installation of the bandsaw.

The machines must be equal to or greater than the below listed vertical blade bandsaw with traveling table:

1ea Forrest Model 2054

Salient Characteristics:

• 480 volt, 3 phase, 60 cycle electrical operation

• Min 2 HP feed drive motor

• 60” fence throat

• 60" of outside blade table support

• 120” table

• Min 48” table stroke

• Min 16 inch high adjustable fence

• Min 16 inch vertical working blade length with adjustable guard

• Blade break detection shut off

• One(1) 14 tooth per inch V-tooth style single edge blade suitable for straight cuts through polyethylene and polyurethane flexible foam planks

• Supply 6” flexible piping to finalize connection to existing ventilation system from machine dust collection points (roughly 50’)

• Pneumatic Blade Tensioning

Exterior color – Manufacturer’s standard.

Warranty Coverage - Warranty coverage shall be manufacturer’s standard warranty but not less than one year parts and labor.

Operator, Parts and Service Manual(s) and Training – The contractor shall provide with delivery, one (1) complete set of manuals with each machine.

2. Definitions of Terms and Abbreviations:

a. DDHU: Defense Distribution Depot Hill Utah

b. OSHA: Occupational Safety Health Administration

3. Description of Contractor’s Tasks:

Task 1: Fabricate and Deliver one (1) each vertical blade bandsaw with traveling table. Saw to be connected to existing electrical connections, no requirement for additional electrical work is required. Saws to be connected to existing ventilation system, Contractor responsibility to provide and install flexible ventilation piping to connect new saw to the existing system.

Task 2: Provide one (1) 8 hour period of training instruction on the safe operation of the installed bandsaw. Training to be conducted at one location to be identified by personnel at the receiving location on the day of delivery and installation.

4. Certification and Acceptance:

Final acceptance of the vertical blade bandsaw will be performed by personnel at the receiving location.

5. Project Management Approach:

6. Performance and/or Delivery Schedule:

The contractor shall coordinate the delivery to the location listed below with the POC listed below. Hill Air Force Base (AFB) UT is a secure government facility. All personnel requesting access to Hill AFB are required to pass a background check and provide proof of US Citizenship.

A minimum of two forms of identification are required for all visitors and delivery drivers requesting access to the site.

7. Shipping Location

QTY: 1EA

Defense Logistics Agency

Defense Distribution Depot Hill AFB, UT 7537 Wardleigh Way, Bldg. 849 Hill AFB, UT 84056