Attachment 1 - Statement of Work.pdf

Statement of Work Entry Points Vehicle Barrier Gate Replacement

Joint Communications Support Element (JCSE) MacDill AFB, FL

Description of Services Required.

JCSE requires replacement of vehicle barrier gates at all three compound entry points.

Gates located on inside of both sides of each compound entry points, connected to HySecurity Slide Driver Operators, Model 222 E ST, which will remain in place and do not require replacement. Entry points are 26 ft. across. When closing, gates meet in the middle of the entry point, with one side of the gate having a welded-on steel coupling that the end of the opposite gate closes into for the North and South Gates. The Main Gate has a steel beam buried in the center of the entry way, separating entry and exit lanes, for which gates on each side close into. Gates consist of Double Drive Cantilever ¼ wall steel frames with corrugated aluminum panels attached to the front side of the steel frame facing the main roadway outside the JCSE Compound. (See attached gate photos for exact configuration and setup)

Measurements of gates

Main Gate (center) and South Gate (Same measurements)

Steel frames: H – 5 ft. 9 in. L – 24 ft.

Corrugated aluminum panels: H – 5 ft. 9 in. L – 15 ft.

Drive Rails: L – 20 ft.

North Gate (Shorter in Height)

Steel frames: H – 5 ft. L – 24 ft.

Corrugated aluminum panels: H – 5 ft. L – 15 ft.

Drive Rails: L – 20 ft.

Place of Performance

Primary place of performance is the JCSE Compound located at 8632 Marina Bay Drive on MacDill AFB. The three gate entry points, North Gate, Main Gate (center gate) and South Gate.

Deliverables.

• Install new custom manufactured gates at all three compound entry points on both sides of each entry point, consisting of Double Drive Cantilever ¼ wall steel frames and corrugated aluminum attached to the frames on the front side of the gates (facing roadway outside of the compound), measurements provided above.

Photos are attached are reference.

• Install new HySecurity Drive Rails (or equivalent) on each gate and connect to HySecurity gate operators.

• Install new 4” Square Cantilever Rollers for gates on existing steel poles using sealed maintenance free bearings. Put fresh coat of paint on poles (existing color paint, brown).

• Provide welded coupling on the end of the gate on one side for North and Sounds gates to facilitate gate sealing and closure in the center of the entry point

• Powder coat brown all new gate materials

• Provide all miscellaneous materials, accessories and equipment required for proper installation

• When installed, new gates should provide the same vehicle barrier and stopping capability that currently exists when gates are closed.

• Provide any required maintenance on the HySecurity Model 222 E ST gate operators to facilitate proper gate functionality once new gates are installed

Pay Schedule

Contractor shall maintain the ability to receive electronic payment from the government as stipulated in the contract requirements. This is done through the Wide Area Work Flow system.

Security Requirements

Contractor shall coordinate with POC to provide information needed for a Base Access Request to be submitted to the 6th Security Forces Squadron at MacDill AFB at least one week prior to the scheduled visit. The Contractor and all employees working on the project shall maintain a clean criminal record in order to be able to gain access to MacDill AFB.

Period Of Performance.

One time project.

Photos of Current Gates for Reference

Main Gate (center gate) left and right side

South Gate:

North Gate: