Attachment 1 -SOW Rubber Flooring.pdf

SOO-1

STATEMENT OF WORK

FOR

Replace Rubber Flooring in Wheel & Tire Shop, B270

NELLIS AIR FORCE BASE, NEVADA

6 August 2026

OFFICE OF THE BASE CIVIL ENGINEER

NELLIS AIR FORCE BASE, NEVADA

SOO-2

STATEMENT OF WORK

1. OVERVIEW: The existing rubber flooring in the Wheel and tire shop at building 270 is in need of replacement. The flooring is buckling and falling apart which causes a hazardous condition for employees.

SCOPE: The purpose of the contract is to replace approximately 2,800 square feet of rubber flooring in the Wheel and Tire shop. The new rubber flooring must have a minimum thickness of 1/3 in, black in color, slip resistant, and chemical resistant (specifically petroleum containing products such as motor oil, jet fuel, grease, etc.). The Contractor shall remove all existing rubber flooring to include the adhesive glue and properly dispose of the material. The contractor shall prepare the concrete floor to accept the new adhesive and rubber flooring. The contractor will ensure that all seams are flush and properly connected with no gaps or buckling. The contractor shall groove all open seams and apply seam welding treatment. At the end of each day and at the completion of the project, the contractor will clean all job-related debris from area.

LOCATION: The project site is located at Nellis Air Force Base, Nevada. The Main Base is located approximately 9 miles north of downtown Las Vegas on Highway US 93 (Las Vegas Blvd.). NAFB consists of three main areas: the Main Base, Area II, and Area III. The specific project location is on the Main Base in Building 270, the Phase Dock, located at the intersection of Tyndall Ave and Rickenbacker Ave,4141 TYNDALL AVE, NV, 89084.

1. ENVIRONMENTAL PROTECTION: All work and the contractor’s operations shall comply with the requirements imposed by all applicable federal, state, local, and NAFB laws, regulations, codes, and permits (including NAFB Management Plan 12) concerning environmental protection. If required per the task in the area where work is to be performed, an asbestos-containing material and a lead-based paint test will be done by the 99 CES.

2. CONTRACTOR PERSONNEL: The contractor’s personnel shall conduct themselves in a professional manner.

3. QUALITY ASSURANCE: The government, through the 57 Maintenance Group, will periodically evaluate the contractor’s performance in accordance with the specific contract performance requirements.

4. WORKING HOURS: Standard working hours are from 7:00 a.m. to 4:00 p.m. Monday through Friday excluding Federal Holidays and the day after Thanksgiving.

5. GENERAL CONDITIONS: All work must be in compliance with and conform to industry standards and applicable manufacturer’s recommendations. Any electrical wiring, connections, and structural designs shall be installed IAW latest version of the NFPA 70 National Electric Code (NEC), Uniform Mechanical Code, and NFPA 54, ASME CSD-1 (Controls & Safety Devices).

All work must be in compliance with the International Building Code (IBC). 2009 Edition, DoD Unified Facilities Criteria Standards (UFC) Unified Plumbing Code (UPC) and all accepted industry practices. At the completion of the project, the system should be 100% operational.

SOO-3

--------------------------- END OF STATEMENT OF WORK---------------------------