Attachment 1-PWS-Angle- Irons.pdf

Performance-based Work Statement Refurbishing of Angle Iron for 18CMS/MXMD

13 July 2022

1. DESCRIPTION OF SERVICES

1.1. The contractor shall provide all management, tools, supplies, equipment, and labor necessary to provide the refurbishing service outlined in this document.

1.2. SPECIFIC REQUIREMENTS

1.2.1. Refurbishment: Contractor shall notify asset owners that the shipment has been received. Refurbishment shall be accomplished within 45 days of received shipment. The contractor will receive one angle iron at a time. The contractor shall provide refurbishment on three angle irons with a grounded finish to the following specifications on all sides below while maintaining original size as much as possible.

Test Instrument (TI) Characteristics Performance Specifications Size [9 x 8 x 16 inch] P/N: 9194

Parallelism Specification Group: Parallelism

• Accuracy: Not to exceed 0.0003 inches

TIR.

Squareness Specification Group: Squareness

• Accuracy: Not to exceed 0.0003 inches TIR.

Size [7 x 5.5 x 10 inch] P/N: 9193

Parallelism Specification Group: Parallelism

• Accuracy: Not to exceed 0.0002 inches

TIR.

Squareness Specification Group: Squareness

• Accuracy: Not to exceed 0.0002 inches TIR.

Size [5 x 4.5 x 8 inch] P/N: 9192

Parallelism Specification Group: Parallelism

FA527022Q0060

Attachment 1 Performance-based Work Statement

• Accuracy: Not to exceed 0.0002 inches

TIR.

Squareness Specification Group: Squareness

• Accuracy: Not to exceed 0.0002 inches TIR.

1.2.3 Warranty: contactor shall provide a one year warranty for any defects/damage from normal use.

1.2.4 Packaging: After refurbishment, crating the parts in heavy duty wooden boxes with foam inserts with Bessel points to support the angle iron in shipment. Angle irons shall have a corrosive preventative coating and wrapped in vapor paper to protect against rust.

1.2.5 Shipment: Ship Angle Irons to:

18 CMS/MXMD

BLDG 782 UNIT 5180

APO AP 96368-5180

Kadena Japan

2. QUALITY CONTROL

2.1 Once Angle Iron has been shipped back to Kadena AB, the local PMEL will inspect the asset to verify that it meets the requested refurbishment specifications.

2.2 If asset fails to meet requirements contactor will accept shipment and refurbishment costs until asset passes verification.

2.3 Once asset passes verification the next angle iron will be shipped to the contactor for refurbishment.

FA527022Q0060

Attachment 1 Performance-based Work Statement