ATTACHMENT 1 FOR SOLICITATION HC101320QA537.pdf

ATTACHMENT 1 FOR SOLICITATION HC101320QA537

MINIMUM TECHNICAL SPECIFICATIONS: SPECIFIC FORMAT TO BE USED IS: LINE

RATE: 10GB. LINE CODE: NRZ. FRAME FORMAT: SCRAMBLED IAW ANSI T1.104-

1991 (R2003).

1. TEST AND ACCEPTANCE: FIBER OPTIC 10GB WAVE CIRCUITS SHALL PASS A

FULLY DOCUMENTED SATISFACTORY SOAK TEST BY THE CONUS GNOSC AT

SCOTT AFB, IL. PRIMARY: (C) 618-418-8691 (D) 418-8691.

2. THE WAVELENGTH TRANSMISSION SERVICE PROVIDED SHALL MEET THE

FOLLOWING PERFORMANCE REQUIREMENTS ON A MONTHLY BASIS.

PERFORMANCE REQUIREMENT/PERFORMANCE SPECIFICATION: NON-

DIVERSE/NON-PROTECTED AVAILABILITY: GREATER THAN OR EQUAL TO 99.5%

OR BETTER. MONTHLY SHORT INTERRUPTION EVENT COUNT (SEIC): LESS THAN

OR EQUAL TO 9%. ERRORED SECONDS (ES): LESS THAN OR EQUAL TO 0.005%.

SEVERELY ERRORED SECONDS (SES): LESS THAN OR EQUAL TO 0.00035.

BACKGROUND BLOCK ERROR RATIO (BBER): LESS THAN OR EQUAL TO 5 X 10-6.

BIT COUNT INTEGRITY (BCI)/PATTERN SLIP (PAT SLIP): LESS THAN OR EQUAL TO

1 PER 72 HOURS. JITTER SEE NOTE 1 (JITTER). BER: LESS THAN OR EQUAL TO

1X10-12. DELAY (ONE WAY): * LESSER OF 10 MSEC OR (0.01 X D MSEC) * WHERE

"D" IS THE SDP TO SDP TRANSMISSION DISTANCE, MEASURED SHORTEST GREAT

CIRCLE, IN KILOMETERS.

3. ROUND TRIP DELAY (RTD) FOR THIS DISA TRANSPORT TRUNK WILL BE

MEASURED IN MILLISECONDS FROM THE CUSTOMER'S SERVICE DELIVERY POINT

(SDP) SITE-A TO THE CUSTOMER'S SERVICE DELIVERY POINT (SDP) SITE-Z. THE

RTD SHALL BE LESS THAN OR EQUAL TO 10 MILLISECONDS TO EFFECTIVELY

SUPPORT THE GOVERNMENT'S MISSION. THE GOVERNMENT ACCEPTING

AUTHORITY WILL CONFIRM THE RTD DURING THE TURN-UP AND TEST PHASE

AND IF IT DOES NOT ALIGN WITH THE CONTRACTORS PROPOSAL, DISA IE161

WILL NOTIFY DITCO IMMEDIATELY IN WRITING. (**UNIQ INSTALL FACTORS**)

(SP A) COMPUTER FLOOR 'A' TO THE LINE SIDE OF THE SITE PROVIDED FIBER

TERMINATING PATCH PANEL BLDG 120, ROOM 116, USING EXISTING ON-BASE

SINGLE-MODE FIBER.

4. IN A STEADY-STATE CONDITION, THE PATTERN OF SYNCHRONOUS

TRANSPORT SIGNAL (STS) POINTER ADJUSTMENTS, SDN TO SDN (END-TO-END

THROUGH THE SERVICE PROVIDED NETWORK OUTPUTS), SHALL BE NO MORE

STRESSFUL (I.E., CREATE MORE JITTER THROUGH THE DESYNCHRONIZER AS

DESCRIBED IN TABLE 6 OF ANSI T1.105.03-1994) THAN THE POINTER ADJUSTMENT

SEQUENCE IN FIGURE 5 OF ANSI T1.105.03-1994. DURING TRANSIENT EVENTS

(WHICH SHALL OCCUR NO MORE THAN 2 TIMES PER DAY), THE PATTERN OF STS

POINTER ADJUSTMENTS, SDN TO SDN (END-TO-END THROUGH THE SERVICE

PROVIDED NETWORK OUTPUTS), SHALL BE FOUR OR LESS PER HOUR.

ADDITIONALLY, THE MAXIMUM TIME INTERVAL ERROR (MTIE) OVER A PERIOD

OF S SECONDS, OR WANDER, SHALL NOT EXCEED (.01S + 10000) NANOSECONDS

FOR VALUES OF S GREATER THAN 10,000.

5. WAVELENGTH TRANSMISSION SERVICES: WAVELENGTH TRANSMISSION

SERVICES FOR RATES OF 10GBPS SHALL BE IN ACCORDANCE WITH ITU-T

RECOMMENDATIONS G.709(03/2003), G.707(12/03), G.957(03/06), G.692(10/98) &

TELCORDIA GR253-IE1. THE PROVIDED WAVELENGTH TRANSMISSION SERVICE

SHALL NOT INHIBIT GOVERNMENT OPERATION OF UNDERLYING PROTOCOLS

AND TRANSPORT SYSTEMS SUCH AS, BUT NOT LIMITED TO, SONET/SDH, IP,

ATM, GIGABIT ETHERNET, AND ENCRYPTION. THE WAVELENGTH

TRANSMISSION SERVICE PROVIDED SHALL PASS ALL PAYLOAD, PATH AND

LINE OVERHEAD BYTES TRANSPARENTLY (UNTOUCHED/UNALTERED) AND

WITHOUT MONITORING SDP TO SDP. THERE SHALL NOT BE ANY LINE

TERMINATING EQUIPMENT (LTE) BETWEEN SDP AND SDP. 10GB WAVE SERVICE

MUST BE TERMINATED TO THE LINE SIDE OF THE FIBER TERMINATING PATCH

PANEL INSTALLED IN THE DISA IE1 PROVIDED MSPP SUITE AT FORT

LEAVENWORTH AND THE FIBER TERMINATING PATCH PANEL INSTALLED IN

THE DISA IE1 PROVIDED ODXC SUITE INSTALLED AT SCOTT AFB.

6. THE TELECOM PROVIDER MUST CONTACT DISA GOC TIER-II ENGINEERING

UPON RECEIPT OF A VALID TSO TO ESTABLISH THE COORDINATION AND

ACTIVATION PROCESS. PRI POC: DISA GLOBAL CASA INFRASTRUCTURE

INTEGRATION LEASE BB TEAM PHONE: (C) 618-418-9813, (D) 418-9813 EMAIL:

DISA.SCOTT.GLOBAL.MBX.CASA-INFRASTRUCTURE-INTEGRATION-LEASE-BB-

T@MAIL.MIL ALT POC: ORGANIZATIONAL NUMBER (CASA RF CIRCUIT

ACTIVATIONS) PHONE: (C) 618-418-8691, (D) 418-8691 EMAIL:

DISA.SCOTT.GLOBAL.MBX.RF-CIRCUIT-ACTIVATIONS@MAIL.MIL.

7. ONCE TELECOM PROVIDER HAS COMPLETED INSIDE WIRING FROM THE DWDM

EQUIPMENT SUITE TO THE GOVERNMENT SERVICE DELIVERY POINT (SDP) AT

EACH LOCATION, THEY MUST ENSURE THE LIGHT LEVELREADINGS (DB LOSS)

ARE ADJUSTED TO READ -3 TO -9 LOSS. ADDITIONALLY, THESE LEVELS MUST BE

DOCUMENTED ON THE NOTICE OF COMPLETION (NOC) SENT TO DITCO.

8. THE VENDOR MUST TERMINATE 10GB WAVE SERVICE AT BOTH LOCATIONS

IAW UNIQUE INSTALLATION FACTORS.

9. THE 10GB WAVE SERVICE MUST PASS A DOCUMENTED SATISFACTORY 72

HOUR END TO END TEST IAW ITU STANDARD M.2101 PRIOR TO TURN UP TO THE

GOVERNMENT.