ATTACHMENT 1 FOR SOLICITATION HC101320QA536.pdf

ATTACHMENT 1 FOR SOLICITATION HC101320QA536

(JITTER): IN A STEADY-STATE CONDITION, THE PATTERN

OF SYNCHRONOUS TRANSPORT SIGNAL (STS) POINTER ADJUSTMENTS,

SDN TO SDN (END-TO-END THROUGH THE SERVICE PROVIDED NETWORK

OUTPUTS), SHALL BE NO MORE STRESSFUL (I.E., CREATE MORE

JITTER THROUGH THE DESYNCHRONIZER AS DESCRIBED IN TABLE 6 OF

ANSI T1.105.03-1994) THAN THE POINTER ADJUSTMENT SEQUENCE IN

FIGURE 5 OF ANSI T1.105.03-1994. DURING TRANSIENT EVENTS

(WHICH SHALL OCCUR NO MORE THAN 2 TIMES PER DAY), THE PATTERN

OF STS POINTER ADJUSTMENTS, SDN TO SDN (END-TO-END THROUGH

THE SERVICE PROVIDED NETWORK OUTPUTS), SHALL BE FOUR OR LESS

PER HOUR. ADDITIONALLY, THE MAXIMUM TIME INTERVAL ERROR

(MTIE) OVER A PERIOD OF S SECONDS, OR WANDER, SHALL NOT

EXCEED (.01S + 10000) NANOSECONDS FOR VALUES OF S GREATER

THAN 10,000.

WAVELENGTH TRANSMISSION SERVICES:

WAVELENGTH TRANSMISSION SERVICES FOR RATES OF 10GBPS SHALL BE

IN ACCORDANCE WITH ITU-T RECOMMENDATIONS G.709(03/2003),

G.707(12/03), G.957(03/06), G.692(10/98) & TELCORDIA

GR253-IE1. THE PROVIDED WAVELENGTH TRANSMISSION SERVICE

SHALL NOT INHIBIT GOVERNMENT OPERATION OF UNDERLYING

PROTOCOLS AND TRANSPORT SYSTEMS SUCH AS, BUT NOT LIMITED TO,

SONET/SDH, IP, ATM, GIGABIT ETHERNET, AND ENCRYPTION. THE

WAVELENGTH TRANSMISSION SERVICE PROVIDED SHALL PASS ALL

PAYLOAD, PATH AND LINE OVERHEAD BYTES TRANSPARENTLY

(UNTOUCHED/UNALTERED) AND WITHOUT MONITORING SDP TO SDP.

THERE SHALL NOT BE ANY LINE TERMINATING EQUIPMENT (LTE)

BETWEEN SDP AND SDP.

C. 10GB WAVE SERVICE MUST BE

TERMINATED TO THE LINE SIDE OF

THE FIBER TERMINATING PATCH PANEL INSTALLED IN THE DISA IE1

PROVIDED MSPP SUITE AT FORT LEAVENWORTH AND THE FIBER

TERMINATING PATCH PANEL INSTALLED IN THE DISA IE1 PROVIDED

ODXC SUITE INSTALLED AT OFFUTT AFB.

D. THE TELECOM PROVIDER MUST CONTACT DISA GOC TIER-II

ENGINEERING UPON RECEIPT OF A VALID TSO TO ESTABLISH THE

COORDINATION AND ACTIVATION PROCESS. (A) FIBER TERMINATION: SINGLE-

MODE INTERFACE

REQUIREMENT/INTERFACE DATA RATE: LINE CODING, FRAME FORMAT,

PHYSICAL CONNECTOR, 10 GBPS, NRZ, SCRAMBLED PER ANSI

T1.104-1991(R2003). ALL OPTIONS DEFINED SC CONNECTOR,

SINGLE-MODE FIBER PER ANSI T1.105.06-2002 (SR-0, SR-1, IR-1,

IR-2, LR-1, LR-2, LR-3).

(B) LINE MUST REMAIN FULLY OPERATIONAL AND AVAILABLE TO USERS

24 HOURS A DAY, SEVEN DAYS PER WEEK, AT LEAST 99.5% OR

BETTER.

CIRCUIT REQUIRES THE FOLLOWING PARAMETERS:

(A) FIBER TERMINATION: SINGLE-MODE INTERFACE

REQUIREMENT/INTERFACE DATA RATE: LINE CODING, FRAME FORMAT,

PHYSICAL CONNECTOR, 10 GBPS, NRZ, SCRAMBLED PER ANSI

T1.104-1991(R2003). ALL OPTIONS DEFINED SC CONNECTOR,

SINGLE-MODE FIBER PER ANSI T1.105.06-2002 (SR-0, SR-1, IR-1,

IR-2, LR-1, LR-2, LR-3).

(B) LINE MUST REMAIN FULLY OPERATIONAL AND AVAILABLE TO USERS

24 HOURS A DAY, SEVEN DAYS PER WEEK, AT LEAST 99.5% OR

BETTER.

(C) ONE-HOUR RESPONSE TIME TURN-AROUND MUST OCCUR TO REPAIR

ONCE TROUBLE-CALL HAS BEEN REPORTED.

(D) GFE CLOCKING: VENDOR ESFU (OR EQUIVALENT) NOT TO BE

ENGINEERED INTO CIRCUIT.

(E) SINGLE MODE FIBER TERMINATIONS "SC" CONNECTORS.

(F) NO NETWORK INTERFACE UNIT.

(G) DEDICATED PATH.

(H) CARRIER REQUIRED TO HAVE CIRCUIT VISIBILITY TO ASSIST IN

ANY CIRCUIT OUTAGES.

(I) THE VENDOR MUST CONDUCT A 72 HOUR SATISFACTORY END TO END

TEST ON THE 10 WAVE SERVICE IAW ITU STANDARD M.2101.

ADDITIONALLY, THE VENDOR TEST SET/SETS MUST HAVE THE ABILITY

TO PRINT THE TEST RESULTS AND THOSE RESULTS MUST BE EMAILED

TO THE ACCEPTING AUTHORITY FOR REVIEW.

(J) VENDOR MUST HAVE A 24X7 NETWORK OPERATIONAL CENTER OF

THIS 10GB WAVE SERVICE.

(K) THE COMMERCIAL CIRCUIT WILL BE ACCEPTED

ON BEHALF OF THE

GOVERNMENT BY THE GOC GNOSC:

PRI POC: DISA GLOBAL CASA INFRASTRUCTURE INTEGRATION LEASE BB

TEAM

PHONE: (C) 618-418-9813, (D) 418-9813

EMAIL: DISA.SCOTT.GLOBAL.MBX.CASA-INFRASTRUCTURE-INTEGRATION-L

EASE-BB-T@MAIL.MIL

ALT POC: ORGANIZATIONAL NUMBER (CASA RF CIRCUIT ACTIVATIONS)

PHONE: (C) 618-418-8691, (D) 418-8691

EMAIL: DISA.SCOTT.GLOBAL.MBX.RF-CIRCUIT-ACTIVATIONS@MAIL.MIL

(L) THE VENDOR MUST PROVIDE: 1) THE LONG HAUL CIRCUIT NUMBER

AND THE 1-800 TROUBLE REPORT NUMBER TO THE ACCEPTING

AUTHORITY PRIOR TO THE GOVERNMENT ACCEPTING SERVICE. INSIDE

WIRING MUST BE COMPLETED AND TESTED PROPERLY IAW THE ORDER

PRIOR TO TURN-UP TO THE GOVERNMENT.

3. VENDOR IS RESPONSIBLE FOR INSTALLATION AND MAINTENANCE OF

10GB WAVE SERVICE IAW UNIQUE INSTALLATION FACTORS.

4. INSIDE WIRING IS AUTHORIZED IAW WITH THE UNIQUE

INSTALLATION FACTORS.

5. VENDOR MUST COORDINATE SITE VISIT WITH POC'S 72 HOURS IN

ADVANCE PRIOR TO REQUIRING ACCESS TO FACILITIES AT BOTH USER

LOCATIONS.

6. FOR UNSATISFACTORY SERVICE OR TO REPORT EQUIPMENT AND/OR

CIRCUIT PROBLEMS INVOLVING DISA PROVIDED TRANSPORT AND/OR

EQUIPMENT, PLEASE CONTACT THE DISN CUSTOMER CONTACT CENTER

(DCCC) SCOTT AFB, IL. TOLL FREE: 1-855-868-9500, COML:

618-418-9500, DSN:312-418-9500.

7. DD FORM 1368 WILL BE SUBMITTED ON THIS TRUNK IAW

DISAC-DITCO 350-135-1 BY RNSOC, SCOTT AFB, IL. GUIDANCE ON

SUBMISSION IS AVAILABLE AT

<HTTP://WWW.DITCO.DISA.MIL/ASP/PUBLICATIONS.ASP>. CLICK ON

"DISA-DITCO CIRCULAR, 350-135-1, DEFENSE COMMERCIAL

COMMUNICATIONS ACQUISITION PROCEDURES."

CIRCUIT SPECIFICATIONS: SPECIFIC FORMAT TO BE USED IS:

LINE RATE: 10GB.

LINE CODE: NRZ

FRAME FORMAT: SCRAMBLED IAW ANSI T1.104-1991 (R2003).

1. TEST AND ACCEPTANCE: FIBER OPTIC 10GB WAVE CIRCUITS SHALL

PASS A FULLY DOCUMENTED SATISFACTORY SOAK TEST BY THE CONUS

GNOSC AT SCOTT AFB, IL. PRIMARY: (C) 618-418-8691 (D)

418-8691.

2. THE WAVELENGTH TRANSMISSION SERVICE PROVIDED SHALL MEET

THE FOLLOWING PERFORMANCE REQUIREMENTS ON A MONTHLY BASIS.

PERFORMANCE REQUIREMENT/PERFORMANCE SPECIFICATION:

NON-DIVERSE/NON-PROTECTED AVAILABILITY: GREATER THAN OR EQUAL

TO 99.5% OR BETTER.

MONTHLY SHORT INTERRUPTION EVENT COUNT (SEIC): LESS THAN OR

EQUAL TO 9%.

ERRORED SECONDS (ES): LESS THAN OR EQUAL TO 0.005%.

SEVERELY ERRORED SECONDS (SES): LESS THAN OR EQUAL TO

0.00035.

BACKGROUND BLOCK ERROR RATIO (BBER): LESS THAN OR EQUAL TO 5

X 10-6.

BIT COUNT INTEGRITY (BCI)/PATTERN SLIP (PAT SLIP): LESS THAN

OR EQUAL TO 1 PER 72 HOURS.

JITTER SEE NOTE 1 (JITTER).

BER: LESS THAN OR EQUAL TO 1X10-12.

DELAY (ONE WAY): * LESSER OF 10 MSEC OR (0.01 X D MSEC) *

WHERE "D" IS THE SDP TO SDP TRANSMISSION DISTANCE, MEASURED

SHORTEST GREAT CIRCLE, IN KILOMETERS.

3. ROUND TRIP DELAY (RTD) FOR THIS DISA TRANSPORT TRUNK WILL

BE MEASURED IN MILLISECONDS FROM THE CUSTOMER'S SERVICE

DELIVERY POINT (SDP) SITE-A TO THE CUSTOMER'S SERVICE

DELIVERY POINT (SDP) SITE-Z. THE RTD SHALL BE LESS THAN OR

EQUAL TO 15 MILLISECONDS TO EFFECTIVELY SUPPORT THE

GOVERNMENT'S MISSION. THE GOVERNMENT ACCEPTING AUTHORITY

WILL CONFIRM THE RTD DURING THE TURN-UP AND TEST PHASE AND IF

IT DOES NOT ALIGN WITH THE CONTRACTORS PROPOSAL, DISA IE161

WILL NOTIFY DITCO IMMEDIATELY IN WRITING.