ATTACHMENT 1 FOR SOLICITATION.pdf

ATTACHMENT 1 FOR SOLICITATION: HC101320QA538

ALL FIBER SUPPORTING THIS REQUIREMENT MUST BE BURIED, AERIAL FIBER IS

NOT AUTHORIZED.

A. NOTE 1 (JITTER): IN A STEADY-STATE CONDITION, THE PATTERN OF

SYNCHRONOUS TRANSPORT SIGNAL (STS) POINTER ADJUSTMENTS, SDN TO SDN

(END-TO-END THROUGH THE SERVICE PROVIDED NETWORK OUTPUTS), SHALL

BE NO MORE STRESSFUL (I.E., CREATE MORE JITTER THROUGH THE

DESYNCHRONIZER AS DESCRIBED IN TABLE 6 OF ANSI T1.105.03-1994) THAN THE

POINTER ADJUSTMENT SEQUENCE IN FIGURE 5 OF ANSI T1.105.03-1994. DURING

TRANSIENT EVENTS (WHICH SHALL OCCUR NO MORE THAN 2 TIMES PER DAY),

THE PATTERN OF STS POINTER ADJUSTMENTS, SDN TO SDN (END-TO-END

THROUGH THE SERVICE PROVIDED NETWORK OUTPUTS), SHALL BE FOUR OR

LESS PER HOUR. ADDITIONALLY, THE MAXIMUM TIME INTERVAL ERROR (MTIE)

OVER A PERIOD OF S SECONDS, OR WANDER, SHALL NOT EXCEED (.01S + 10000)

NANOSECONDS FOR VALUES OF S GREATER THAN 10,000.

B. WAVELENGTH TRANSMISSION SERVICES: WAVELENGTH TRANSMISSION

SERVICES FOR RATES OF 2.5GBPS SHALL BE IN ACCORDANCE WITH ITU-T

RECOMMENDATIONS G.709(03/2003), G.707(12/03), G.957(03/06), G.692(10/98) &

TELCORDIA GR253-IE4. THE PROVIDED WAVELENGTH TRANSMISSION SERVICE

SHALL NOT INHIBIT GOVERNMENT OPERATION OF UNDERLYING PROTOCOLS

AND TRANSPORT SYSTEMS SUCH AS, BUT NOT LIMITED TO, SONET/SDH, IP, ATM,

GIGABIT ETHERNET, AND ENCRYPTION. THE WAVELENGTH TRANSMISSION

SERVICE PROVIDED SHALL PASS ALL PAYLOAD, PATH AND LINE OVERHEAD

BYTES TRANSPARENTLY (UNTOUCHED/UNALTERED) AND WITHOUT

MONITORING SDP TO SDP. THERE SHALL NOT BE ANY LINE TERMINATING

EQUIPMENT (LTE) BETWEEN SDP AND SDP.

C. SINGLE MODE FIBER MUST BE TERMINATED TO THE LINE SIDE OF THE FIBER

TERMINATING PATCH PANEL INSTALLED IN THE DISA IE1 PROVIDED MSPP SUITE

AT FARGO, ND AND THE FIBER TERMINATING PATCH PANEL INSTALLED IN THE

DISA IE1 PROVIDED ODXC SUITE INSTALLED AT OFFUTT AFB.

D. THE SINGLE MODE FIBER MUST PASS A DOCUMENTED SATISFACTORY 72

HOUR END TO END TEST IAW ITU STANDARD M.2101 PRIOR TO TURN UP TO THE

GOVERNMENT. CIRCUIT REQUIRES THE FOLLOWING PARAMETERS: (A) FIBER

TERMINATION: SINGLE-MODE INTERFACE REQUIREMENT/INTERFACE DATA

RATE: LINE CODING, FRAME FORMAT, PHYSICAL CONNECTOR, 2.5 GBPS, NRZ,

SCRAMBLED PER ANSI T1.104-1991 (R2003). ALL OPTIONS DEFINED SC

CONNECTOR, SINGLE-MODE FIBER PER ANSI T1.105.06-2002 (SR-0, SR-1, IR-1, IR-2,

LR-1, LR-2, LR-3). (B) LINE MUST REMAIN FULLY OPERATIONAL AND AVAILABLE

TO USERS 24 HOURS A DAY, SEVEN DAYS PER WEEK, AT LEAST 99.5% OR BETTER.

(E) ONE-HOUR RESPONSE TIME TURN-AROUND MUST OCCUR TO REPAIR ONCE

TROUBLE-CALL HAS BEEN REPORTED.

GFE CLOCKING: VENDOR ESFU (OR EQUIVALENT) NOT TO BE ENGINEERED INTO

CIRCUIT.

(E) SINGLE MODE FIBER TERMINATIONS "SC" CONNECTORS. (F) NO NETWORK

INTERFACE UNIT.

(G) DEDICATED PATH.

(H) CARRIER REQUIRED TO HAVE CIRCUIT VISIBILITY TO ASSIST IN ANY CIRCUIT

OUTAGES.

(I) THE VENDOR MUST CONDUCT A 72 HOUR SATISFACTORY END TO END TEST

ON THE 2.5GB WAVE SERVICE IAW ITU STANDARD M.2101. ADDITIONALLY, THE

VENDOR TEST SET/SETS MUST HAVE THE ABILITY TO PRINT THE TEST RESULTS

AND THOSE RESULTS MUST BE EMAILED TO THE ACCEPTING AUTHORITY FOR

REVIEW.

(J) VENDOR MUST HAVE A 24X7 NETWORK OPERATIONAL CENTER.

(K) THE COMMERCIAL CIRCUIT WILL BE ACCEPTED ON BEHALF OF THE

GOVERNMENT BY THE GOC GNOSC: PRI POC: DISA GLOBAL CASA

INFRASTRUCTURE INTEGRATION LEASE BB TEAM PHONE: (C) 618-418-9813, (D)

418-9813 EMAIL: DISA.SCOTT.GLOBAL.MBX.CASA-INFRASTRUCTURE-

INTEGRATION-L EASE-BB-T@MAIL.MIL ALT POC: ORGANIZATIONAL NUMBER

(CASA RF CIRCUIT ACTIVATIONS) PHONE: (C) 618-418-8691, (D) 418-8691 EMAIL:

DISA.SCOTT.GLOBAL.MBX.RF-CIRCUIT-ACTIVATIONS@MAIL.MIL L) THE VENDOR

MUST PROVIDE THE LONG HAUL CIRCUIT NUMBER AND THE 1-800 TROUBLE

REPORT NUMBER TO THE ACCEPTING AUTHORITY PRIOR TO THE GOVERNMENT

ACCEPTING SERVICE. INSIDE WIRING MUST BE COMPLETED AND TESTED

PROPERLY IAW THE ORDER PRIOR TO TURN-UP TO THE GOVERNMENT.

L VENDOR IS RESPONSIBLE FOR INSTALLATION AND MAINTENANCE OF SINGLE

MODE FIBER IAW UNIQUE INSTALLATION FACTORS.

M. INSIDE WIRING IS AUTHORIZED IAW WITH THE UNIQUE INSTALLATION

FACTORS.

N. VENDOR MUST COORDINATE SITE VISIT WITH POC'S 72 HOURS IN ADVANCE

PRIOR TO REQUIRING ACCESS TO FACILITIES AT BOTH USER LOCATIONS.

O. FOR UNSATISFACTORY SERVICE OR TO REPORT EQUIPMENT AND/OR CIRCUIT

PROBLEMS INVOLVING DISA PROVIDED TRANSPORT AND/OR EQUIPMENT,

PLEASE CONTACT THE DISN CUSTOMER CONTACT CENTER (DCCC) SCOTT AFB,

IL. TOLL FREE: 1-855-868-9500, COML: 618-418-9500, DSN: 312-418-9500.

P. DD FORM 1368 WILL BE SUBMITTED ON THIS TRUNK IAW DISAC-DITCO 350-135-

1 BY RNSOC, SCOTT AFB, IL. GUIDANCE ON SUBMISSION IS AVAILABLE AT

<HTTP://WWW.DITCO.DISA.MIL/ASP/PUBLICATIONS.ASP>. CLICK ON "DISA-DITCO

CIRCULAR, 350-135-1, DEFENSE COMMERCIAL COMMUNICATIONS ACQUISITION

PROCEDURES."

MINIMUM TECHNICAL SPECIFICATIONS: SPECIFIC FORMAT TO BE USED IS: LINE

RATE: 2.5GB. LINE CODE: NRZ. FRAME FORMAT: SCRAMBLED IAW ANSI T1.104-

1991 (R2003).

1. TEST AND ACCEPTANCE: FIBER OPTIC 10GB WAVE CIRCUITS SHALL PASS A

FULLY DOCUMENTED SATISFACTORY SOAK TEST BY THE GOC GNOSC AT SCOTT

AFB, IL. PRIMARY: (C) 618-418-8691, (D) 418-8691.

2. THE WAVELENGTH TRANSMISSION SERVICE PROVIDED SHALL MEET THE

FOLLOWING PERFORMANCE REQUIREMENTS ON A MONTHLY BASIS.

PERFORMANCE REQUIREMENT/PERFORMANCE SPECIFICATION: NON-

DIVERSE/NON-PROTECTED AVAILABILITY: GREATER THAN OR EQUAL TO 99.5%

OR BETTER. MONTHLY SHORT INTERRUPTION EVENT COUNT (SEIC): LESS THAN

OR EQUAL TO 9%. ERRORED SECONDS (ES): LESS THAN OR EQUAL TO 0.005%.

SEVERELY ERRORED SECONDS (SES): LESS THAN OR EQUAL TO 0.00035.

BACKGROUND BLOCK ERROR RATIO (BBER): LESS THAN OR EQUAL TO 5 X 10-6.

CIRCUIT SPECIFICATIONS CONTINUED: BIT COUNT INTEGRITY (BCI)/PATTERN

SLIP (PAT SLIP): LESS THAN OR EQUAL TO 1 PER 72 HOURS. JITTER SEE NOTE 1

(JITTER). BER: LESS THAN OR EQUAL TO 1X10-12. DELAY (ONE WAY): * LESSER OF

10 MSEC OR (0.01 X D MSEC) * WHERE "D" IS THE SDP TO SDP TRANSMISSION

DISTANCE, MEASURED SHORTEST GREAT CIRCLE, IN KILOMETERS. 3. ROUND

TRIP DELAY (RTD) FOR THIS DISA TRANSPORT TRUNK WILL BE MEASURED IN

MILLISECONDS FROM THE CUSTOMER'S SERVICE DELIVERY POINT (SDP) SITE-A

TO THE CUSTOMER'S SERVICE DELIVERY POINT (SDP) SITE-Z. THE RTD SHALL BE

LESS THAN OR EQUAL TO 15 MILLISECONDS TO EFFECTIVELY SUPPORT THE

GOVERNMENT'S MISSION. THE GOVERNMENT ACCEPTING AUTHORITY WILL

CONFIRM THE RTD DURING THE TURN-UP AND TEST PHASE AND IF IT DOES NOT

ALIGN WITH THE CONTRACTORS PROPOSAL, DISA IE161 WILL NOTIFY DITCO

IMMEDIATELY IN WRITING. (**UNIQ INSTALL FACTORS**) (SP D) XC SWITCH

BLDG 1000, ROOM 222/SL1. "SC" TO "SC" CONNECTORS. E. DISA IE4 IS

RESPONSIBLE FOR INSTALLATION AND GSM-O FOR MAINTENANCE OF ODXC

SWITCH, OPTICAL INTERFACE CARD AND SINGLE-MODE FIBER JUMPERS BLDG

1000, ROOM 222/SL1. ANY ADDRESSEE ON THE TSO WILL NOTIFY ALL

ADDRESSEES IMMEDIATELY BY MESSAGE IDENTIFYING ANY ISSUES, PROBLEMS,

OR SITUATIONS WHICH MAY PREVENT OR DELAY THE IMPLEMENTATION OF

THIS TELECOMMUNICATIONS SERVICE ORDER (TSO). ALL STATIONS WILL

REVIEW THE CONFIGURATION, EQUIPMENT, CONTACT NUMBERS AND

ADDRESSES CONTAINED IN THIS TSO AND PROVIDE UPDATES TO ORIGINATOR

OF TSO ANY ERRORS SO THAT SUBSEQUENT TSOS MAY BE UPDATED. T.

IMPLEMENTATION ASSISTANCE: IMPLEMENTATION ASSISTANCE: FOR DISN

BACKBONE ACTIVATION INQUIRIES/SCHEDULING/ASSISTANCE, CON TACT THE

DISA GLOBAL INFRASTRUCTURE INTEGRATION ACTIVATIONS TEAM VIA EMAIL

DISA.SCOTT.GLOBAL.MBX.CASA-INFRASTRUCTURE-INTEGRATION-L EASE-BB-

T@MAIL.MIL OR CALL DSN 312-418-9813, CML 001-618-418-9813 U.

UNSATISFACTORY SERVICE REPORTING INSTRUCTIONS: FOR UNSATISFACTORY

SERVICE OR TO REPORT EQUIPMENT AND/OR CIRCUIT PROBLEMS INVOLVING

DISA PROVIDED TRANSPORT AND/OR EQUIPMENT, PLEASE CONTACT THE DISN

CUSTOMER CONTACT CENTER (DCCC) TOLL FREE NUMBER IS 1-844-347-2457 (1-

844-DISA HLP) OPTION 2, COML 1-614-692-0032 OPTION 2, DSN 312-850-0032 OPTION

DIVERSITY/AVOIDANCE INSTRUCTIONS: NETWORK DIVERSITY REQUIRED:

PHYSICAL DIVERSITY; COMMERCIAL DIVERSITY: YES; DIVERSITY FROM

SG28JAN206360/6W87 W. DIVERSITY/AVOIDANCE COMMERCIAL CIRCUIT:

DIVERSITY IS REQUIRED. THE VENDORS MUST PROVIDE MAPS AND DRAWINGS

PER STANDARD PROVISIONS. DIVERSITY IS DEFINED AS 50 METER/164 FEET

SEPARATION WITH NO COMMON CONDUITS, MANHOLES, FACILITY ENTRANCES

AND POWER.