Attachment 03 Support Tube CERTIFIED TEST RESULT FOR PROCUREMENT SSIM.docx

CERTIFIED MATERIAL TEST REPORT

For those material(s) identified below, a certified test report must be provided to the Government with each shipment. The test results contained on the certified test report(s) shall be adequate to determine compliance with all applicable requirements of the material specification(s) listed below. Availability of the certified test reports are in addition to other contract requirements and does not reduce or prejudice the Government's right to inspect supplies under other provisions of this contract. The test report(s) shall contain the following:

a. Name and address of suppliers.

b. Purchase order number.

c. Identification of all materials by specification, revision, amendment and dates, together with type, grade, size etc.

d. Quantity of each material.

e. Test results identified by reference to the applicable requirements:

1) Perpendicularity .010 to Datum B

2) True position of the Inner Diameter .97 ± .03

3) Outer Diameter 2.705 ± .010

4) Length 15.62 ± .02

5) ALL requirements of DWG 2114298 D

f. Quantity tested, sample size, and specimen type as applicable.

g. Date, signature, and title of the authorized representative of the contractor that is attesting to the accuracy of test report content.

DWG. No. 7100311 A DWG No. 2114298 D

REQUIREMENT

SPECIFIED FOR (.030 INCH) NOMINAL THICKNESS.

3. FIBERBOARD LINER SHALL BE TIGHTLY AND SPIRALLY WOUND. THE ANGLE OF SPIRAL

SHALL BE 45 ı# 15 DEGREES. LAYERS SHALL BE BONDED TOGETHER WITH POLYVINYL

ACETATE RESIN ADHESIVE IAW COMMERICAL ITEM DESCRIPTION ASTM D4317 OR A-A-1270

BETWEEN LAYERS. HORIZONTAL GAPS BETWEEN WINDINGS SHALL BE 0.06 MAXIMUM.