Attachment 0003 - Quality Requirements.pdf

DATE:

AO: CB:

REQ'D

Warranty of Supplies - Noncomplex years

Warranty of Supplies - Complex years

FAR 52.246-17

FAR 52.246-18

FAR 52.246-15

Packaging

Critical Characteristics Clause

Statistical Process Control

Inspection and Acceptance (Origin)

Inspection and Acceptance (Destination)

Certified Material Test Report

Certificate of Conformance

Section C

Section E

Standard Inspection Clause

Rework and Repair of Nonconforming Material

FAR 52-246-2

FAR 9.106

FAR 52.246-11

FAR 52.209-3 Alt. 1

FAR 52.209-4 Alt. 1

Preproduction Samples

Acceptance of Product (MIL-STD-1916)

FAR 52.211-5

Pre-Award Survey

Post Award Conference

Acceptance Inspection Equipment

Higher Level Contract Quality Requirement

(ISO 9001:2008; only design/development exclusions)

First Article Test - Contractor Testing

First Article Test - Government Testing

2D Bar Code

Lot Numbering (MIL-STD-1168)

Material Requirement

Ammunition Data Cards

Configuration Management Documentation

ITEM(S):

QUALITY ASSURANCE RELEASE

DESCRIPTION CLAUSE

QAR NUMBER:

REQUISITION ORGANIZATION

END ITEM:

PBA Form 702-105 September 2018 Page 1 of 2

FAR 52.246-2

*See attached Requirements *See attached Requirements *See attached Requirements *See attached Requirements

*See attached Requirements *See attached Requirements *See attached Requirements *See attached Requirements *See attached Requirements *See attached Requirements

*See attached Requirements

*See attached Requirements *See attached Requirements

*See attached Requirements

DSN: 966-

Quality Assurance POC

Telephone Number Commercial:

Signature:

(870) 540-

CONTACT INFORMATION:

DELIVERABLE ITEMS

FAT/ Preproduction TEST QUANTITIES and Comments:

Sample 2-D Bar Code Sample Ammunition Data Card First Article Test Report Lot Acceptance Test Report Preproduction Report Quality Management Plan/Detailed Inspection Plan Acceptance Inspection Equipment Statistical Process Control

PBA Form 702-105 September 2018 Page 2 of 2

QUALITY REQUIREMENTS: INSPECTION, ACCEPTANCE, QUALITY ASSURANCE,

AND RELIABILITY

INSPECTION AND ACCEPTANCE:

Inspection and acceptance will be at destination, unless otherwise provided herein. Until delivery and acceptance, and after any rejections, risk of loss will be on the contractor, unless loss results from negligence of the United States Government.

CERTIFIED MATERIAL TEST REPORTS:

For those material(s) identified below, a certified test report shall be made available to the Government Quality Assurance Representative (QAR). The test results contained on the certified test report(s) shall be adequate to determine compliance with all applicable requirements of the material specification(s). Availability of the certified test reports are in addition to other contract requirements and does not reduce or prejudice the Government's right to inspect supplies under other provisions of this contract. The test report(s) shall contain the following:

a. Name and address of supplier.

b. Purchase Order/Contract Number.

c. Identification of material by specification, revision, amendment and dates, together with type, grade, size etc.

d. Quantity of material.

e. Test results identified by reference to the applicable requirements.

f. Quantity tested, sample size, and specimen type as applicable.

g. Date, signature, and title of the authorized representative of the contractor that is attesting to the accuracy of the test report content.

PACKAGING (PRESERVATION/PACKING/MARKING):

Containers shall be clearly marked, at a minimum, with the information as follows:

a. Name of contractor

b. Contract / Purchase Order Number

c. Description of items contained therein

d. Lot / Batch Number(s)

For packing requirements, see the Engineering Release Record.