Attach 1-Statement of Work2_SCW41_2021-Revised 08-06-2021.docx

Statement of Work Stainless Steel Cut Wire Shot 19 February 2021

1.0 SCOPE

1.1 Contractor shall provide stainless steel cut wire for shot blasting to Anniston Army Depot (ANAD) in accordance with the Society of Automotive (SAE) Standards. SAE J441, “Wire, Cut, Shot,” was adopted on 3 October 1994 for use by the Department of Defense (DoD). SAE J441 latest revision date is June 1993. Anniston Army Depot’s requirement is for cut wire only. No rounded or conditioning allowed.

1.2 Period of Performance is twelve (12) months, with one (1) option year, that may be exercised. Estimated delivery is 288,000 pounds of stainless steel cut wire shot per year, delivered to:

7 Frankford Ave Anniston, AL 36201

2.0 PROPERTIES

2.1 Chemical Analysis:

Carbon: 0.15 max Manganese: 2.00 max Phosphorus: 0.045 max Sulphur: 0.0.0 max Silicon: 1.00 max Chromium: 17.00 to 20.00 Nickel: 8.00 to 10.50

2.2 Contractor shall comply with the Chemical Analysis above, stainless steel cut wire must contact a percentage of each chemical or your quotation shall be determined non-responsive.

2.3 Size requirement is 0.041 – 0.042 inches in diameter. Please refer to the attached standard SAE J441

2.4 Tensile Properties: (See table 2 in SAE J441)

2.5 Hardness: Stainless cut wire shot shall have a minimum hardness of 466 KHN (45HRC) IAW SAE J441

2.6 Size Classification: (See tables 1, 3, and 4) IAW SAE J441.

2.7 Inspection Procedures: (Refer to SAE J441)

2.8 Soundness: (Refer to SAE J441)

3.0 PACKAGING / DELIVERY

3.1 Packaging: Stainless steel cut wire shot shall be packaged in accordance with supplier’s commercial practice in a manner to assure protection against damage from the supply source to the using activity. Unless otherwise specified, stainless steel cut wire shot shall be packed in unit quantities of twenty-five (25) pounds, fifty (50) pounds or one hundred (100) pounds.

3.2 Requirement: The prospective vendor shall provide a sample of the cut wire shot that weighs about two (2) pounds, for in-house testing: Send the same, certificate of analyses that show the samples are within the chemical analysis ranges specified above including particle/shot size, and the Safety Data Sheet (SDS) to the following address:

Anniston Army Depot Materials Lab, Bldg. 128 Attn: Doug Swain 7 Frankford Ave.

Anniston, AL 36201

Final award, of deliveries in 24,000 pound increments, will be determined upon approval of initial two (2) pound sample.