Atch_9_Changes_to_16G1-169-3.pdf

Changes to T.O. 16G1-169-3

Page 10-9, Figure 10-1, Index 33:

Change Part number to “See Appendix A” Change Description to “UID Nameplate”

Add new Appendix, Page A-1:

APPENDIX A

UNIQUE IDENTIFICATION (UID) SUPPORTING INFORMATION

A.1 UID SUPPORTING INFORMATION.

- Inspect UID Nameplate (Index 33) by using a 2D hand-held electronic reader. Reference T.O.

00-25-260.

- If UID Nameplate is not present or damaged, or old pre-UID nameplate is still present, manufacture new label and install as shown in Table A-1. CAGE is for the equipment manufacturer (85941).

- Do not cover any existing markings. Reference T.O. 00-25-260.

- CAGE is that of the activity responsible for guaranteeing uniqueness of the sequencing code.

- For additional information, reference MIL-STD-130 and T.O. 00-25-260.

A.1.1 After attaching UID Nameplate, edge seal and overcoat nameplate with Humiseal 1A20 per MIL-I-46058, type UR, by spraying or by brush to a thickness of 2 – 3 mils in accordance with the manufacturer’s instructions.

Table A-1. Item Unique Identification (IUID) Required Information

Part Number

Noun

UID Label Fig./Index

UID Label Part number

Surface Preparation

Application/ Verification

A1020F010-3 Gearbox Assembly, Surface Sensor

Figure 10-1, Index 33

200945069-503, Change height “B” (0.75”) to 0.725”

REF:

T.O. 00-25-260 Premarking Activities

REF:

T.O. 00-25-260

A1020F010-4 Gearbox Assembly, Surface Sensor

Figure 10-1, Index 33

200945069-503, Change height “B” (0.75”) to 0.725”

REF:

T.O. 00-25-260 Premarking Activities

REF:

T.O. 00-25-260