A06 SPECIFICATIONS 07.28.2020.pdf

PDF 390 KB Posted

Attached to
PURCHASE OF A PATHFINDER VESSEL WITH TRAILER
Solicitation number
140P5420Q0034
Issued by

View the file

Other files

File Type Posted
Sol_140P5420Q0034.pdf PDF

On GovTribe

Work with this file

  • Download the original file
  • Contacts named in this file
  • Similar government files
  • Ask GovTribe AI about this file

Text version

STATEMENT OF WORK (SPEC SHEET)

Everglades National Park Patrol/Rescue Boat *Must meet or exceed

1. Fiberglass shallow water bay boat hybrid style hull;

a. Hull length at least 24 feet but not more than 25 feet

1. Commercial grade rubber rub rail 3 to 4 inches, no exposed screws or metal trim

b. Hull beam at least 8.5 feet wide

c. Hull weight at least 2200 lbs but not more than 3200 lbs. dry weight as measured without the motor and controls

d. Hull freeboard height at bow must not be greater than 3.5 feet

e. Hull draft at rest/idle between 10 and 14 inches

f. Hull outside Whisper gray / light gray in color

g. Hull inside matching Whisper / light gray with non-skid decking

h. Single bow eye

i. Two stern eyes reinforced with aluminum or stainless steel backing of no less than 5 sq.

inches

j. Light bar/siren (blue lights) installed on tee top

k. Led floodlights (Port/Starboard/Aft) mounted on tee top

l. 12 volt outlet

m. Battery System (1 start/1 electronics)

n. Running/anchor lights - LED

o. Horsepower capacity rating of at least 300

p. Bow anchor compartment

q. Tee top/leaning posts (anchored to deck using through bolts into aluminum backing plates under deck, for a secure long lasting bond).

r. Leaning post a.) rocket style launcher with flip seat storage and back rest – matching color cushions or b.) leaning post with backrest to include storage aft of seat.

s. Fold down or popup cleats (at least 8”) – 7 total (two stern, two amid ship and two forward and one on the bow)

t. Fiberglass center console with windshield.

i. Console same color as hull

u. All hull, console and leaning post non-corrosive hardware subdued black/grey in color to include but not limited to;

i. Steering wheel.

ii. Cleats

iii. Framework tubing

v. Built in gasoline tank with at least 65 gallon capacity located in the hull of the boat

w. Self-bailing deck with two scuppers at least 2.5 inches each

x. Hatches to be lockable to stow Law Enforcement equipment

y. No through hulls – no live wells are to be plumped. Only bilge pump of 1500GOH min.

z. Ritchie Compass or equal

2. 2 Garmin GPS chart plotter with sonar

3. Hydraulic steering system

4. Power trim and tilt system

5. Engine Gauge(s) that provide at least the following information; Smart gauge package SC 1000 or equal

i. Engine rotations per minute

ii. Battery voltage

iii. Oil pressure

iv. Engine temperature

v. Total engine hours

vi. Trip engine hours (resettable)

vii. Water pressure

viii. Fuel consumption (resettable)

6. Hydraulic engine lift/”Jack” plate

a. Hull and engine compatible hydraulic lift capable of lifting engine vertically.

b. Lift plate control mounted on the center console to the right of the steering wheel and above the throttle control.

7. Hull trim tabs

a. Hydraulic trim tabs mounted to each side of the vessel’s stern that each measure 10 –12 inches wide.

b. Trim tab control mounted on the center console to the right of the piloting wheel and above the throttle control.

8. Hydraulic shallow water anchor (Powerpole Pro Series or equal)

a. maximum length of 8 feet

9. Purchaser will provide DTS/Smartcraft gauges/ rigging components/steering wheel to contractor for installation.

10. Mercury Verado 300 XL will be provided by purchaser but will need to be installed by contractor.

11. Purchasing /Installation of VHF radio

12. Purchaser will provide contractor Law Enforcement emergency equipment for installation.

13. Contractor to provide a parts list from Mercury for complete rigging to include keys, harness, etc.

*All Parts will be drop shipped to contractor**

TRAILER SPECS

1. Radial tires with galvanized spoke wheels

2. Aluminum winch stand with winch

3. Sealed L.E.D. lights grounded front to rear

4. Aluminum I-Beam frame

5. Aluminum Cross members

6. Aluminum bunk brackets

7. Aluminum fenders & steps

8. All stainless nuts, bolts & U-bolts

9. Galvanized Torsion axles with removable super lube spindles

10. No leaf springs

11. Vented Disc Brakes

12. Aluminum guide rail pipe with PVC

13. V-block bunks

14. Jack Stand – Heavy Duty

15. Spare tire and mount

16. 2 – inch ball

DELIVERY ADDRESS:

EVERGLADES NATIONAL PARK

40001 STATE ROAD 9336

HOMESTEAD, FL 33034

File details come from the government source that posted it. Updated .