A04-_SOW.docx

Fleet Repair Statement of Work Ruby Mountain IHC Crew Carrier - A (I-620317)

VIN: 1HTMKAAL4GH376886

1. Purpose and Need: To obtain service, labor, and parts required to complete all necessary work items and repairs required by list below to return the vehicle to duty and readiness requirements; based off annual inspection performed by a certified International dealership and service department.

2. General Service Statement of Work:

Post-season annual inspection by certified International service shop found the following needs for repair/replacement (see attached quote for full breakdown);

1. Driver door doesn’t close correctly, replace hinge

2. Diagnose squeal from throttle

3. Replace warped exhaust manifold and EGR cooler

4. Replace control actuator for rear heat

5. Replace all shocks

6. Remove and replace front axle spring pin bushings and front U-bolts

7. Remove and replace torque rod and trailing arms on rear axle

8. Repair inoperable lights

3. Work Order: All work must be completed by a current certified International Mechanic. A written notice to proceed will be issued by Contracting Officer to the Contractor stating when the work is to begin. Work must be completed by March 1, 2025.

4. Workmanship Requirements:

The repair of parts such as hinges, catches, handles, or knobs shall be accomplished to avoid damaging the hardware or the mounting surface after installation. All parts shall be cleaned of the following: smudges, loose, spattered, or excess welding, metal chips, filings or any other foreign material which might detract from the intended operation, function, or appearance of the apparatus or its equipment. This would include particles which could loosen or become dislodged during the normal expected life of the equipment. Whenever possible, this cleaning shall take place before the parts are assembled.

Threaded parts or devices shall show no evidence of cross-threading, mutilation, or detrimental burs. All screw type and rivet fasteners shall be tight, with no relative movement between the attached parts. All bolts and screws shall not be tightened more than the SAE torque standard established for the grade, screw, and thread type.

Fluids, filters, and other serviceable parts to be repaired and replaced should meet standards of original manufacturer specifications to ensure proper function of the vehicle.

5. Contractor must ensure all parts are available with current pricing to meet the specified period of performance, prior to bidding and or accepting solicitation.

6. The vehicle is currently in limited operation at the dealership that performed the annual. Government will be responsible for delivery and pick-up of the vehicle to the vendor’s location, within 300 miles. If the vendor is located outside of this radius, it will be the responsibility of the selected vendor to arrange for transportation of the vehicle from Silver State International in Sparks, NV to their location, and return it to Elko, NV when repairs are complete. The vendor should include this cost as a separate line in their quote, if applicable.